1. Important information
Please read this manual completely and attentively
before using the product for the first time. Keep this
manual. It is part of the product.
1.1 Safety instructions
Caution:
Risk of injury!
Due to the detailed reproduction of the original and
the intended use, this product can have peaks,
edges and breakable parts. For installation tools
are required.
Electrical hazard!
Never put the connecting wires into a power
socket! Regularly examine the transformer for
damage. In case of any damage, do not use the
transformer!
Make sure that the power supply is switched
off when you mount the device and connect the
cables!
Only use VDE/EN tested special model train
transformers for the power supply!
The power sources must be protected to prevent
the risk of burning cables.
1.2 Using the product for its correct
purpose
This product is intended:
- For installation in model train layouts and dioramas.
- For connection to an authorized model train trans-
former (e. g. item 5200/5201).
- For operation in dry rooms only.
Using the product for any other purpose is not ap-
proved and is considered inappropriate. The manu-
facturer is not responsible for any damage resulting
from the improper use of this product.
1.3 Checking the package contents
Check the contents of the package for completeness:
- LED light with plug-in socket
- Protective cap
- Retaining ring
- Manual
2. Introduction
This LED light produces the light by SMD-LED which
is suitable for the LED light model. Low heat build-up
and power input. Nearly unlimited lifetime of the LED,
so no more exchange is required.
3. Mounting
- Remove the LED light carefully from the package.
- Check the function before mounting.
- Drill a hole (Ø 6 mm) at the mounting place (see fig. 1).
- Insert the cables from outside through the hole
and push the base socket into the hole (fig. 2). If
necessary, fasten the LED light with the retaining
ring from inside (optional).
Hint: To further design the landscape, without dam-
aging the LED light, pull the LED light out of the
plug-in socket and insert the protective cap. Upon
completion, pull the protective cap off and insert the
LED light into the plug-in socket again.
4. Connection
Connect the LED light to the light output of a model
train transformer (e. g. item 5200/5201) as shown in
fig. 3.
DC voltage: Connect the diode (red part with black
marking) with the positive pole and the resistor with
the negative pole of the power supply.
3
EN
