Virtuox VirtuCLEAN 2.0 Manuale utente

2.0

www.VirtuClean.com
Please allow 35 minutes of settling time of non use of your
CPAP equipment after cleaning your CPAP equipment to allow
the ozone to dissipate.
Please only use VirtuCLEAN 2.0 for its intended use. It is not
recommended to use any other way.
Use VirtuCLEAN 2.0 in a room larger than 100 sq ft. The scent of
ozone can be unpleasant to some users.
Do not run VirtuCLEAN 2.0 for more than 1 cycle. It is not
necessary for multiple cleaning cycles.
Do NOT inhale the omitted ozone directly from the VirtuCLEAN
2.0 device as this may be harmful to ones health.
Do NOT attempt to open or repair the device. This will
compromise the device’s functionality and void the warranty.
Do NOT leave unattended near children or pets.
Do NOT block any part of the VirtuCLEAN 2.0 during operation.
It is not recommended to use your VirtuCLEAN 2.0 while
plugged into the wall for charging purposes. This will possibly
deplete your battery life in your device.
VirtuCLEAN 2.0, if purchased from an unauthorized dealer, the
24 month warranty will be VOIDED.
877.337.7111
1

www.VirtuClean.com 2
Thank you for purchasing the VirtuCLEAN 2.0 CPAP sanitizer
device.
In this manual you will nd how to properly clean your
CPAP equipment and accessories using the VirtuCLEAN 2.0
device, operating your VirtuCLEAN 2.0 device and
frequently asked questions.
To regiser your device for warranty coverage, accessories
for your device, or to nd additional information, please go
to www.VirtuClean.com
It is important to register your device for warranty
coverage. All devices not properly registered will not be
eligible to be covered under warranty.
877.337.7111

www.VirtuClean.com
USB charging port
tubing port air intake
on/off button
with built-in
charging and
working
indicator
Name Part Number
877.337.7111
3
VirtuCLEAN 2.0 device 2250
VirtuCLEAN 2.0 replacement bag 2251
VirtuCLEAN 2.0 replacement filter 2252
VirtuCLEAN 2.0 replacement charging kit 2254

www.VirtuClean.com 4
Dimensions: 4.5 in X 1.7 in
Weight: .48lbs
Rechargable Lithium-ion battery
2000mAh, 4W power
Storage temperature -20°C ~55°C
Operating temperature -5°C ~45°C
IPX1IP (ingress protection): IPX1
877.337.7111

www.VirtuClean.com
TheVirtuCLEAN 2.0 is a ONE-STEP process
Step 1: Disconnect your CPAP tubing from your CPAP machine.
Step 2: Disconnect your CPAP tubing from your CPAP mask
Step 3: Place your CPAP mask into yourVirtuCLEAN 2.0 bag
Step 4: Remove your humidier chamber from your CPAP machine and empty
the water
Step 5: Place your humidier chamber into your VirtuCLEAN 2.0 bag
Step 6: Zip the VirtuCLEAN 2.0 bag closed
Step 7: Connect the end of your CPAP tubing that was connected to your CPAP
machine to your VirtuCLEAN 2.0 bag as shown.
Step 8: Connect the end of your CPAP tubing that was connected to your CPAP
mask to your VirtuCLEAN 2.0 device as shown.VirtuCLEAN 2.0 evice as shown.
STANDARD/HEATED TUBING CPAP MACHINES
877.337.7111
5

www.VirtuClean.com 6
Step 9: Press the power button as shown
Step 10: The device will now display your compliance data and utilization data
and then start the cleaning device.
Step 11: The device will now start to run and display the remaining time for the
cleaning cycle.
Step 12: Once the cleaning cycle has ended, reattached your CPAP equipment to
your mask and machine. Then place the humidier chamber back into your CPAP
machine and replace the water in it.
877.337.7111

www.VirtuClean.com
For the best lithium battery performance and battery life, set the power o while it
is at charging. LCD screen will display a battery symbol with red exclamation mark
inside the battery with the word (Recharge) in red under the battery symbol ,when
the device needs to be recharged. The LCD screen will display a battery symbol
with a yellow lightning bolt inside the battery with the word (Charging) in yellow
underneath while plugged in and charging. Once the battery has been completely
charged, the LCD screen will display a battery symbol completely full with green
lines and the word Full in underneath the battery.
The time required to recharge the battery will vary greatly depending on the
ambient temperature and the battery’s remaining capacity. If the battery becomes
exhausted quickly even after being fully charged, the battery has reached the end
of its life cycle.
Low Power indication: When the battery is running low, the battery symbol in the
top right hand corner of the device will have 1 slim bar and it will be red. It will also
start to blink and be accompanied by a series of beeps from the device. The
sanitizer will continue to operate until the battery charge is completely exhausted;
however, it does not warrant a complete 35 minute sanitation cycle. Recommend
the user charge the unit once the battery indicator ashes and beeps.
The VirtuCLEAN 2.0 includes a rechargable battery that is inside your device.
Please do not attempt to replace this battery as this will void the warranty of
your device. For charging the battery, connect the cable to the VirtuCLEAN 2.0
device. Connect the USB cable to the power adapter. Insert the power adapter
into the power outlet. Please make sure to fully charge your battery before use.
877.337.7111
7

www.VirtuClean.com
For the CPAP machine congured with a humidier, drain water in
reservoir before starting the sanitization process.
Ozone concentration is designed by the disinfector design,
enclosing container and sanitization time. The machine design
is based on the best sanitization performance. User is not
recommended to change any settings.
The 2000 mAh rechargeable batteries meets most of the airlines
restriction.
The warranty becomes VOID if repairs are undertaken by
unauthorized persons and if original parts are not used. To obtain
service within the warranty period, Please contact your distributor.
I
VirtuCLEAN 2.0, if purchased from an unauthorized dealer, the 24
month warranty will be VOIDED.
The VirtuCLEAN bag has a connection for standard and heating tubing.
Consumers with an air mini device and tubing will need to visit the
website below to purchase adapter.
t is recomended to sanitize your CPAP mask and tubing everyday and
your CPAP humidier weekly
After the sanitation process is complete, wait 45 minutest before using
your CPAP machine to ensure no residue ozone odor.
8
HLS oers a 24 month warranty on the product
commencing on the date of purchase (only when
purchased from an authorized retailer). The warranty
does not cover damage due to improper use and normal
wear. The warranty only covers defects in the product
resulting from faults in materials or workmanship, free
from charge by repairing or replacement in the complete
product at the HLS location and the HLS discretion.
877.337.7111

www.VirtuClean.com
9
For repair or additional information, please visit
WWW.VIRTUCLEAN.COM
If VirtuCLEAN 2.0 does
not turn on
VirtuCLEAN 2.0 will
not charge
VirtuCLEAN 2.0 will
not charge
Make sure you check the charging
connection.
Connect VirtuCLEAN to charger. Plug
the charger into power outlet. Turn on
the VirtuCLEAN 2.0
If after you press the On/O button, the
screen turns on, but the fan in the
device does not appear to be
functioning. Please send your
VirtuCLEAN 2.0 in for repair.
Your CPAP tubing
does not t on the top
of the VirtuCLEAN bag
Please visit WWW.VirtuCLEAN.com to
purchased an air mini adapter- part #
2253
877.337.7111
Altri manuali per VirtuCLEAN 2.0
1
Indice
Altri manuali Virtuox Accessori
Manuali Accessori popolari di altre marche

IFM Electronic
IFM Electronic Efector 250 Series Guida di riferimento

DigiDesign
DigiDesign 888/24 I/O Manuale utente

PROZIS
PROZIS QUAY Manuale utente

patagonia
patagonia PSI Vest Manuale utente

SFC Energy
SFC Energy EFOY GO! Manuale utente

Axminster
Axminster Tooling Stylus Tip Ballpoint Pen Kit Manuale utente












