Notification V8 Type
Contact Medical Service (0x03)
(Table 1)
V1 Alarm
(Table 2)
Configuration - Synchronic Time Interval
1 ~ 127 (Set up from 16
to 2032 seconds)
(Table 3)
(P.S.: This is the definition how long ZA1502-7 will contact
Gateway for having a synchronic information. The basic
interval time is 16 seconds, the synchronic time will be the
basic interval time by Parameter 1’s value.)
Operation
Notice: If you are installing the entire Z-Wave™ system for the first time, please
refer to the installation guide of Z-Wave™ Interface Controller and full charging the
ZA1502-7 before using..
1. Green LED turns on while pressing the button of ZA1502-7.
2. Quick press the button of ZA1502-7 5 times for showing the sensor’s inclusion status.
- Not Included : Red/Green LED flashing 5 times quickly.
- Included : Red/Green LED flashing 1 second.
: Red/Green LED flashing 5 times
3. For “Inclusion”in (adding to) a network: Put the Z-Wave™Interface Controller into
“inclusion”mode, and following its instruction to add the ZA1502-7 to your controller.
To get in the “inclusion”mode, quick press the button of ZA1502-7 5 times for sending
the NIF, the Red/Green LED will flash 5 times quickly before the learning process for
showing the sensor has not been included. After sending NIF, Z-Wave will send the
auto inclusion, the Red/Green LED will flash 1 second after successful inclusion;
otherwise, ZA1502-7 will go to sleep after 30 seconds. The red LED will be flashing
while the inclusion is proceeding.
4. For “Exclusion” from (removing from) a network: Put the Z-Wave™ Interface
Controller into “exclusion” mode, and following its instruction to delete the ZA1502-7
from your controller. Quick press the button of ZA1502-7 5 times to be excluded,
the Red/Green LED will flash 5 times quickly after successful exclusion.
Note: All user and network settings will be cleared and the device reset to factory
defaults when the device is excluded.
5. Trigger Response:
- Movement: The sensor will send Notification Report (refer to Table 1 & 2) if it has
been moved.
- Synchronic Time: The sensor will send Notification Report (refer to Table 1 & 2)
and exceed the preset synchronic time (refer to Table 3).
- Button Press: Press the button of ZA1502-7 once for sending Notification Report
(refer to Table 1 & 2) if button has been pressed for any specific purpose.
6. Wake Up Notification:
Press the button of ZA1502-7 2 times will active the “Wake Up Mode”for receiving all
the command class from controller. The ZA1502-7 will go to sleep mode without
receiving any Z-Wave command till 10 seconds. It will proceed all the commands
after sending the “Wake Up Notification”
7. Auto Wake Up:
Use “Wake Up” command to set up the awaking interval and send the wake up
notification to controller. User can use “Wake_Up” command to change the auto
wake up interval from 10 minutes to 1 week, Interval increment is 200 seconds.
(Default Value: 24 hours.)
