Visonic GSM 350 PG2 Manuale utente

D-302800 GSM 350 PG2 Installation Instructions 1

GSM 350 PG2

English Installation instructions for Internal GSM/GPRS module for PowerMaster control panels

Fig. 1 GSM 350 PG2

1. INTRODUCTION

The internal GSM module enables the PowerMaster system to operate over a GSM/GPRS cellular network.

2. INSTALLATION

PowerMaster-10 Control Panel

Figure 2 Optional GSM module mounting

1. Release screws

2. Remove front unit

3. Plug in the GSM 350 PG2

module and fasten it with

the screw

A. GSM 350 PG2

B. Front unit

Mount the optional GSM external antenna on the

desired site surface, connect its connector to the

internal GSM module and insert the SIM card

A. External GSM antenna

Fig. 3 Optional external GSM antenna

Figure 4 SIM card insertion

1. Slide top cover.

2. Open cover

3. Align SIM card in cover

(note cover orientation)

4. Slide SIM card into cover

5. Rotate cover to close

6. Lock cover to close

IMPORTANT!

Do not insert or remove the

SIM card when the control

panel is powered by AC

power or battery.

Warning!

If external antenna removal is required, hold its

connector (not the cable) and pull it out.This prevents

damage to the P.C.B.

Compliance with GSM Standards (USA): FCC 47 Part 22 (GSM850) and Part 24 (GSM 1900).

EMC standard: FCC 47 Part 15.

Compliance with European CE Standards: EN301489-3,7, EN60950, EN50136-1 and -2

Compliance with GSM Standards (Europe): Complies with CE standards 3GPP TS 51.010-1,

EN 301 511, EN301489-7

W.E.E.E. Product Recycling Declaration

For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are discarding this product and not

returning it for repair then you must ensure that it is returned as identified by your supplier. This product is not to be thrown away with everyday waste.

Directive 2002/96/EC Waste Electrical and Electronic Equipment.