Volt Low Voltage Landscape Lighting Manuale utente
VOLT®Low Voltage Landscape Lighting
VOLT® Gentle Splash Flood Light
VFL-430-4-BBZ
INSTALLATION INSTRUCTIONS
Specications and product details subject to change without notice.
© Copyright 2018, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3700
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)
VOLT®Gentle Splash Flood Light
VFL-430-4-BBZ
Important: Please Read Before Installation
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION INSTRUCTIONS
This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situations.
1. Make sure that the power is turned OFF before installing or servicing
this luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M)
or more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with wire connectors that are
suitable for outdoor use.
5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or
tting.
6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm)
7. If additional lengths of low voltage cable is required, please contact
www.voltlighting.com or call 1-813-978-3700.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Turn o/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Do not touch the hot lens, guard or enclosure.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
6. Do not operate the luminaire tting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
!
!
www.voltlighting.com
Package Contents
Product Dimensions
A. (1) Stake
B. (1) Luminaire
4”
1.5”
2”
Install Stake
1
Determine the desired location for mounting
the luminaire. Hammer the stake into the
ground until ange of stake is ush to grade.
To avoid damage to the stake, place a board
on top of stake while hammering.
NOTE: If the ground is hard and the stake
is dicult to install, make a crosscut in the
ground using a at shovel.
Board
Stake
Neck
Soil
Ground
INSTALLATION INSTRUCTIONS
www.voltlighting.com
VOLT®Gentle Splash Flood Light
VFL-430-4-BBZ
Unscrew the lock screws and remove the cover and gasket with the
lens from the luminaire to expose the socket.
Install the gasket with the lens and cover back onto the luminaire and
secure with the lock screws.
Remove Cover and Gasket with Lens
Install Cover and Gasket with Lens
2
4
Luminaire
Luminaire
Socket
Cover
Cover
Gasket with Lens
Gasket with Lens
Lock Screw
Lock Screw
Insert the bulb with correct
wattage and type marked on the
luminaire label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch bulb with
bare hands. Use soft cloth to
handle lamp.
Install Bulb
3
Bulb
Socket
Wire Connection
6
Clear away an area in the ground
at the wireway slot on top of the
stake. Lay the luminaire pigtail
into the wireway slot and screw the
xture on to the stake. Tighten the
hex nut on the luminaire against the
stake and tighten until snug.
Install Luminaire to Stake
5
Luminaire
Hex Nut
Stake
Pigtail
Wireway Slot
Strip both leads from the luminaire pigtail. Using two wire connectors
(sold separately), connect the leads from the luminaire to the main
supply cable leads.
Pigtail
Main Low Voltage
Supply Cable
Wire Connectors
Maintenance – Install/Replace Bulb
Please reverse Step 2 - Step 4 to expose the bulb and replace it with correct
wattage and type marked on the luminaire label. Reinstall the gasket with
the lens and cover.
IMPORTANT: Halogen lamps must be protected from moisture and dust at all
times. Always reinstall gasket with lens and cover when moved.
is-VFL-430-ver3.pdf
Specications and product details subject to change without notice.
© Copyright 2018, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3700
www.voltlighting.com
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Volt Apparecchio di illuminazione
Manuali Apparecchio di illuminazione popolari di altre marche
Emos
Emos CLASSIC ZY1431T Manuale utente
Westinghouse
Westinghouse Outdoor Lighting Fixture Manuale utente
Hedler
Hedler C 12 silent Manuale utente
Blizzard Lighting
Blizzard Lighting Puck: CSI Manuale utente
Energetic Lighting
Energetic Lighting ELYSL-5004 Series Manuale utente
Lightmaxx
Lightmaxx Shaft 5R Manuale utente
Cooper Lighting
Cooper Lighting Halo L3232E Manuale utente
Stageline
Stageline ODW-2410RGBW Manuale utente
Light Sky
Light Sky Tornado Series Manuale utente
Lightolier
Lightolier Paralyte 2424 PLA2G9LS26U Manuale utente
Lightolier
Lightolier Lytespan 83ED17S Manuale utente
Lightolier
Lightolier Calculite CS8226 Manuale utente