Wahsega WL-ZN-CTR-1CH-INF-R Istruzioni per il montaggio
InformaCast Zone Controller Installation Guide Page 4 11.11.2020
Wiring
Power
Option A: To use Power-over-Ethernet (POE 802.3af), route a Cat 5e or
Cat 6 Ethernet cable from a PoE switch or injector to the LAN port.
Option B: Alternately, use the included 2-pin male connector to
connect +9-16VDC and Ground wires for power. Use standard
(unpowered) Ethernet for data.
NOTE: Use either POE or 9-16V for power. DO NOT USE BOTH.
Status
The status LED will increase in brightness as the zone controller is
powering up and will remain steadily lit when the unit is successfully
powered.
Status
LED
Ethernet or POE
If using Power Option A = POE 802.3af
If using Power Option B = Ethernet
Do Not
Use
Power
Option B
Reset
InformaCast Zone Controller Installation Guide Page 5 11.11.2020
Audio Outputs
LINE OUT (unbalanced) –Connect to amplifier via RCA mono
connector. Configure audio settings in configuration webpages as
described in User’s Guide.
RELAY (Single Channel Zone Controller only) –The relay connector is a
3-pin male connector (included), wired to a Form C relay (SPDT) with
contacts rated for 30VDC or 270VAC at 3A.
Pin 1 is a Normally Closed (NC) dry contact closure.
Pin 2 is Common.
Pin 3 is a Normally Open (NO) dry contact closure.
STAT –LED will illuminate when audio is being passed. The steadier the
STAT LED, the stronger the audio signal present.
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Wahsega Controllori
