WayteQ N720B Manuale utente

User Manual
WayteQ
N720B

NOTICE
USING YOUR NAVIGATOR at the first time
1. Charge completely
2. Install into your vehicle
3. Initialize software as described in the manual
4. Make sure that the car is outside the garage and it is not
covered by anything (treed, bridges, etc)
5. Normally it takes a bit longer to receive the GPS signal the first
time you turn on the unit. Your device has to locate 3 satellites to
function. This time to find the satellites is significantly shorter
after the first time you use the device. If you move your unit over
300km without it being used, it may need a little more time to
locate the satellites again.

Introduction
This manual is a complete instruction for the device. Please ready this manual
carefully before using.
Contents:
Safety and Regulatory Information
1. Getting Started
1.1 Unpacking
1.2 Over View
1.3 Using Your Device in a Vehicle
1.3.1 Using the Car bracket
1.3.2 Connecting the Car Charger
1.3.3 Connecting to AC Power supply and Charging the Battery
1.3.4 Assembly
1.4 Starting up
1.5 Power saving
2.Main Menu Selection
2.1 Navigation
2.2 Bluetooth
2.3 Media
2.4 Photo
2.5 E-book
2.6 FM transmitter
2.7 System
3. Battery, Charger and Safety Precaution
3.1 About Charging
3.2 About the AC Adapter and the Car Charger
3.3 About the Battery
4. Specifications

Safety and Regulatory Information
Important Safety Notices and Warnings
Global Positioning System
The Global Positioning System (GPS) is a satellite-based system that provides location
and timing information around the Globe.
GPS is operated and controlled under the sole responsibility of the Government of the
United States of America, who are responsible for its availability and accuracy. Any
changes in GPS availability and accuracy, or in environmental conditions, may impact the
operation of your device .We cannot accept any liability for the availability and accuracy
of GPS.
Precautions and Notices
For your own safety, do not operate the controls of the product while driving.
Use this product prudently. The product is intended to be used only as a navigation aid.
It is not for precise measurement of direction, distance, location or topography.
The calculated route is for references only. It is the user's responsibility to follow the
traffic signs and local regulations along the roads When you get off the car, do not leave
your device on the dashboard or the car glass that is subject to direct sunlight. The
overheating of the battery can cause malfunction and /or danger.
GPS is operated by the United States government, which is solely responsible for the
performance of GPS. Any change to the GPS system can affect the accuracy of all GPS
equipments.
GPS satellite signals can not pass through solid materials (except glass).When you are
inside a tunnel or building, GPS positioning is not available.
A minimum of 4 GPS satellite signals is needed to determine current GPS position. Signal
reception can be affected by situations such as bad weather or dense overhead obstacles
(e.g. trees and tall buildings)
The wireless devices might interfere the reception of satellite signals and cause the
reception of the signal to be unstable. For better signal reception, it is recommended
that you use a car antenna (option)
Aircraft and Hospitals
Use of devices with an antenna is prohibited on most aircraft, in many hospitals and in
many other locations. The device must not be used in these environments.

1. Getting Started
1.1Unpacking
Unpack your device box and identify the contents. You should have:
(1) Unit. Its main features are a touch-sensitive LCD screen, 1 SD card slot, 1 volume
control switch. Details see the photo below.
(2) Holder,to hold the device.
(3) Bracket, its main features is to fix the device on a car .
(4) Car Charger. With 12V cigarette lighter adapter. This is the normal way of providing
power to your device when it's in your vehicle.
(5) AC adapter(Option), included for you to charge and work with your device even when
It's not in your vehicle. When you use the adapter, please make sure it is cooled by
placing it in a ventilated area.
(6) USB data cable for connecting your device to a Windows PC
(7) GPS External Antenna (Option) is used when the GPS signal is not so strong and it
should mounted on the top of the car or on the front of the car window .
(8) SD card(Option), containing map data.
(9) User Manual.
(10) Installation CD(Option), containing PC connection software and extra maps.
*Note: please check optional accessories with local retailer/importer/distributor.
1.2 Over View

(1) Charger Indicator Light
(2)Saving Power Switch
(3)Unit Power On/Off
(4)GPS Antenna
(5)Speaker
(6)SD Card Slot: for accessing data as maps.
Note:
Before using GPS navigation software and maps, you need to insert the storage Card
included with your device. Do not remove the card during GPS operation.
(7)Earphone Jack
(8)Reset Key
(9)USB Connector
(10)External GPS Antenna Connector
(11) Volume Switch
(12)DC Jack
Do not expose the device to high temperatures. We recommend that you do not leave the device
in direct sunlight for long periods or in an unattended car on sunny days.
High temperatures can cause permanent damage.
Do not attempt to service the device yourself! Do not open, puncture or disassemble it.
Doing so may be dangerous and will invalidate your warranty.
1.3 Using Your Device in a Vehicle
A stand and a car charger are supplied with your device.
1.3.1 Using the Car Bracket
Caution:
-- Select an appropriate location for the stand. Never place the stand where the driver's

field of vision is blocked.
-- If the car's windshield is tinted with a reflective coating, an external antenna (optional)
maybe be needed to route the.
Antenna to the top of the car through a window. When closing the car window, be careful
not to pinch the antenna cable (Cars with an anti-jam window design may automatically
leave adequate space as needed.).
1.3.2 Connecting the Car Charger
The car charger supplies power to your device when you are using the device in a car.
Caution: To protect your device against sudden surges in current, connect the car
charger only after the car engine has been started. Connect one end of the car charger
to the power connector of your device. Connect the other end to the cigarette lighter in
the car to power and charge your device.
To Cigarette Lighter
1.Device power connector
2.Vehicle power connector
1.3.3 Connecting to AC Power supply and Charging the Battery
1.Fully charge the battery before using your device for the first time
2.Connect the adapter cable to the bottom of your device.
3.Plug the AC adapter into a wall outlet.

The charge indicator glows amber when charging is in progress. Do not disconnect your
device from AC power until the battery is fully charged, when the charge indicator turns
green. This will take a couple of hours.
1.3.4 Assembly
To get started, put the device into the holder and assemble holder with bracket. Take off
the protected film on the bottom or the suction. Then put the bracket onto a suitable
location of your windscreen or side window, make sure the window or the suction or
windscreen is clean and without water and some dirty things inside, fixing the stand on
that position..
Note: Controlling 5 different levels of suction by pressing down the button (See below
picture)
Controlling 5 different
levels of suction by
pressing down the button
Note: that some newer vehicles may have a heat reflective shield embedded in the wind
screen. In some cases this can prevent proper GPS signal reception. If this turns out to be
a problem in your vehicle, you will need to purchase and install the GPS external
antenna kit.
Under normal journey conditions, the suction mount is perfectly sufficient to hold the
bracket in position. Note that suction may be lost if left overnight, due to condensation
and low temperature. For this reason, and for security, we recommend Removing Both

the suction mount bracket and the device when leaving your vehicle overnight.
To remove the bracket, three steps as below:
Press 2 sides button, pull back lightly and then take off the suction. If the bracket still
doesn't detach from your windscreen, tug gently on the clear plastic tab at the edge of
the suction mount, to break the vacuum seal.
1. Press 2 sides button
2. Pull back lightly
3. Take off the suction
1.4 Starting up
Push the System Power button to the "ON" position, when first time to use, and leave it
on "ON" position.(Suggestion: please leave it on "OFF " position if long time not use.)
Insert the supplied SD card (optional) into the slot at the bottom of device.

Tap "OK "then enter into the "Main Function Operation Screen " as below.
Then select the functions you need and then go directly to the way you need.
1.5 Power saving
Press the power button on the top side of your device to turn on and off your
device for saving power. When you press the power button to turn off the unit, your
device actually enters a suspend state and the system stops operation. Once you turn on
the system again, it resumes.
2.Main Menu Selection
Main Menu is the start of all functions. It includes six function icons such as navigation,
Bluetooth, Photo, E-book, Media(MP3&MP4) and system setting .You can choose your
desired functions as you like.
2.1 Navigation
Please refer the navigation software user manual for the details.
2.2 Bluetooth
1)Tap the “Bluetooth” on the main menu and enter into following display..
Indice
Altri manuali WayteQ GPS

WayteQ
WayteQ X960BT Manuale utente

WayteQ
WayteQ x985BT Manuale utente

WayteQ
WayteQ G5 Series Manuale utente

WayteQ
WayteQ X995 Manuale utente

WayteQ
WayteQ X950BT Manuale utente

WayteQ
WayteQ x980BT Manuale utente

WayteQ
WayteQ X960BT Manuale utente

WayteQ
WayteQ X990 Manuale utente

WayteQ
WayteQ X850 Manuale utente

WayteQ
WayteQ x985BT Manuale utente

WayteQ
WayteQ WayteQx995 Manuale utente

WayteQ
WayteQ x920 Manuale utente

WayteQ
WayteQ X950BT-HD Manuale utente

WayteQ
WayteQ X620 Manuale utente

WayteQ
WayteQ N310 Manuale utente

WayteQ
WayteQ N770 Manuale utente

WayteQ
WayteQ xRIDER Manuale utente

WayteQ
WayteQ X820 Manuale utente

WayteQ
WayteQ N410 Manuale utente

WayteQ
WayteQ x920BT Manuale utente


















