Ween Ween Manuale utente

[Installation instructions ]

[ Safety guidelines ]

READ THIS DOCUMENT CAREFULLY BEFORE INSTALLATION

• Do not allow children to handle this product

• Only basic skills as a handyperson are necessary to install the Ween correctly

• Electrical installation must conform to applicable safety regulations (NF C15-100)

• Never dismantle the Thermostat or the Relay

• Do not install the Thermostat or the Relay in extreme conditions of temperature

or humidity

• Before installing the Ween Thermostat, check its compatibility with your heating

system

Rev. 1.3.50 - 12/12/2019

[ The Ween Thermostat ]

1 Thermostat

1 Relay

2 screws (3.5x30)

2 plugs (5mm)

1 AC adapter

1 USB Cable

2 batteries (1.5V AA)

tted in the Relay

THERMOSTAT

Power supply : 5VDC

Typical consumption : 0,75W

Operating temperature :

0-50°C, without condensation

Radio : Wi (2.4GHz) & 802.15.4 (868MHz)

Temperature setting :

• Units : °C

• Resolution : 0,1°C

• Accuracy: 0,3°C

Humidity measurement :

+/-2%RH over the range [20-80%]

Setting :

• Temperature range available : 5-35°C

• Increment : 0,5°C

• Weight : 225g

RELAY

Power source : 2 AA battery – operating life 1

year depending on radio environment and re-

gulation mode

Operating temperature:

0-50°C, without condensation

TECHNICAL SPECIFICATIONS

Radio : 802.15.4 (868MHz)

Control output:

• TOR: 240VAC / 5A (NO et NC)

• Pilot wire

• Bus : BSB (Siemens)

Weight (without batteries): 140g

APP

Compatible Android 4.2 and higher

Compatible iPhone 5 and higher

CE CERTIFICATION

WEEN declare that their products conform to the

requirements of CE certication including:

•Low-voltage directive 2014/35 / UE

• Directive CEM 2004/108 / CE

• Directive R & TTE 1999/5 / CE

• Directive RoHS 2011/65 / UE

All informations available on :

https://www.ween.fr/Data/WeenW01W02-CE.pdf

EQUIPMENT WARRANTY

Installation comprises the 3 following stages :

I. Connecting the Thermostat to Wi

II. Connecting the Relay to the heating system

III. Connecting the Relay to the Thermostat

These 3 stages are relatively separate.

However, we advise you to carry them out in the above order

Before installation, check the Ween Thermostat compatibility with your heating system

(www.ween.fr)

[ Preamble ]

I. Connecting the Thermostat to Wi

OPERATION

The Thermostat is the system’s « brain ».

It must be installed in the living room of your home.

It is connected to the internet by Wi.

It ensures optimal control of your heating by constantly piloting the Relay.

The Relay interfaces with your heating system.

1,2m

THE THERMOSTAT

Processes data and carries out measurements to regulate the temperature.

Should be placed in a position allowing an accurate evaluation of your comfort, i.e :

• In a room that is in constant use

• Near an inside wall

• About 1,2m (50 ins.) from the oor

• In a position where air can circulate freely (not in a recess)

• Away from direct sunlight and other heat sources (radiators, TV, etc.)

• In a draught-free area

• In a zone well-covered by your Wi

• At a distance from the Relay allowing good communication between the two

1) Insert the cable’s mini-USB connec-

tor rmly into the Thermostat in the

position indicated (1). Clip the cable

into the grooves in the base to hold it

in place.

2) Connect the other end of the USB

cable to the adapter and plug this into

a mains socket.

On startup, the Thermostat displays a

tutorial screen. Scroll down to read,

then click on “I understand”.

[ Connecting the Thermostat ]

3) The Thermostat may display a

different temperature from reality,

especially at rst.

If it was previously in cold surroundings,

it may need up to an hour to adjust to

the ambient temperature.

View from below

4) On initial installation, the “Wi conguration” screen appears automatically. It

displays the Thermostat Wi’s SSID and the associated password. The Thermostat

ashes purple.

If this is not the case:

1. Long press on the Thermostat’s button

2. Turn it until you see “Wi conguration Off”

3. Click once, you will access the choice On / Off

4. Turn to select On and click to conrm

1 2 3 4 5

Network setting

Off

Network setting

Off

SSID :

ween xxxxxx

Password :

64561991

[ Download the App on your Smartphones ]

App is available on Google play for android Smartphones

Apple Store for iOS Smartphones.

Download the Ween Thermostat App on all family’s Smartphones.

Indice

Manuali Termostato popolari di altre marche

EWELLY

EWELLY EW-181 Manuale utente

Prolon

Prolon T1100 Istruzioni per l'installazione

Computherm

Computherm Q20 Manuale utente

Heatmiser

Heatmiser neoStat Manuale utente

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuale utente

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuale utente

Saswell

Saswell SAS920XWHB-7-S-RF Guida

Aircalo

Aircalo TFP1-ET85P2 Manuale utente

Honeywell

Honeywell CM721 Manuale utente

Carrier

Carrier DEBONAIR 33CS Manuale utente

Lennox

Lennox iHarmony Zone Thermostat Istruzioni per il montaggio

Gemtech

Gemtech GT7000 Manuale di istruzioni

Rollei

Rollei Smartes 45000 Manuale utente

Sinope

Sinope TH1300RF Manuale utente

Honeywell

Honeywell RLV4305 Manuale utente

Honeywell

Honeywell Prestige 2.0 THX9421 Manuale utente

NuTone

NuTone NTBZ48 Istruzioni operative originali

Stelpro

Stelpro MAESTRO ASMT402AD Manuale utente