Wenger Cupholder Manuale utente
Assembly Instructions
Cupholder Accessory
for Flex
®
TechBridge
©Wenger Corporation 2019 Printed in USA 2019-10 Part #236A186-02
Wenger Corporation, 555 Park Drive, P.O. Box 448, Owatonna, Minnesota 55060-0448
Questions? Call.....USA: (800) 4WENGER (493-6437) • Worldwide: +1-507-455-4100 • wengercorp.com
Parts List
Cupholder
Accessory
Note: Please read and understand these instructions before assembling.
Note: If you need additional information, contact Wenger Corporation using the information below.
Basic Instructions to be used with the Cupholder Accessory for Flex®
TechBridge only!
For othe component information, refer to the Flex TechBridge Owner's Manual 236A153.
Item Qty Description Item Qty Description
1 1 Cupholder 4 2 Nylon Lock Nut, #10-24
21Bridge Clip 5 2 Flat Washer, 0.188 ID x 0.734 OD”
32Machine Screw, #10-24 x 5/8”
2
345
1
Assembly
1. Attach the cupholder (1) to the bridge clip (2)
using two #10-24 x 5/8” machine screws (3),
two 0.188 ID x 0.734 OD at washers (5)
and two #10-24 nylon lock nuts (4) as shown.
2
Bridge
Extrusion
Assembled
Cupholder Release
Handle
2. Attach the assembled cupholder to the
bridge extrusion by inserting the short side
of the bridge clip into the outside groove.
Press down to snap the long side of the
bridge clip into place.
3. To reposition or remove the cupholder,
release the bridge clip by pulling on the
release handle (long side of the clip) and
rotate forward.
#10-24 x 5/8”
Machine Screws
(3)
Cupholder
(1)
Bridge
Clip
(2)
0.188 ID x 0.734 OD
Flat Washers
(5)
#10-24
Lock Nuts
(4)
Indice
Altri manuali Wenger Accessori
