Westermann wp office Manuale utente
Service
VERSION: 01 - 2019.05
1) STANDARD OPERATION
Use the up and down keys to move the table up
or down in the direction of the arrow, the table
stops when the end positions are reached.
Keep the button pressed until the desired
position has been reached.
2) CONTAINER STOP AND SHELF STOP POSITION
These two functions can be used to limit the travel range of the table
(for example, if a container is under the sit-stand table or a shelf is
hanging over the table). A container stop position can only be set in the
lower half of the travel range, a shelf stop position only in the upper half
of the travel range. If a container stop position is set, this is used as the
lower end position, a shelf stop position corresponds to the upper end
position of the travel range.
To save a container or shelf stop position, proceed as follows:
•Move the table to the position you want to use as the new container
or shelf stop position
•Now press the Up and Down buttons simultaneously for 10
seconds. The save process is confirmed by the controller with a
double-click tone
To deactivate a container or shelf stop position, proceed as follows:
•Move the table to any position in the lower half of the driving range
to deactivate the container stop or in the upper half of the travel
range for the shelf-stop position
•Handset Up / Down: Now press the Up and Down keys
simultaneously for 10 seconds.
Auf
Ab
Service
VERSION: 01 - 2019.05
3) INITIALIZATION / RESET
After installation, or if the table has been disconnected from the power
supply for a long time, if there has been a fault at the table or if the
connection between the drives and the control unit has been
disconnected - the control of the table must be initialized.
If the controller expects a new initialization, only the downward
movement of the table at a reduced speed is possible.
To initialize, move the table to the lowest position by pressing and holding
the down button on the manual switch until all drives have reached the
lowest position. Then press the down button again and hold it down
(about 10 seconds) until the table has made a slight movement down and
up again, release the button only when the table stops moving. Letting
go of the button too early will cause the table to malfunction. If this
happens accidentally, you must repeat the procedure.
-----------------------------------------------------------------------------------
wp office - products by westermann
Karl Westermann GmbH + Co. KG
Albstraße 1
73770 Denkendorf
Germany
wp.westermann.com
Indice
Altri manuali Westermann Attrezzature per ufficio
