Wicked lasers FlashTorch Manuale di installazione e funzionamento
www.wickedlasers.com
User’s Manual and Safety Guide
User’s Manual & Safety Guide | 1
Table of Contents
Flashtorch Technical Specications
Flashtorch Diagram
Quick Start Guide
Modes of Operation
Charging Guide
Bulb Replacement
Battery Replacement
Safety Instructions
Limitation of Liability
Manufacturer’s Warranty
3
4
5
6
7
8
9
11
12
13
FLASHTORCH | 2
WWW.WICKEDLASERS.COM
User’s Manual & Safety Guide | 3
Technical Specications
Model Name:
Lamp Output:
Dimensions:
Weight:
Power Supply:
Power Consumption:
Battery Lifetime:
Bulb Type:
Expected Bulb Life:
Body:
Finish:
LED switch:
Tail switch:
Warranty:
Flashtorch
4100 Lumens with a High Eciency Reector
63mm x 48mm x 293mm ( Head x Barrel x Length)
610g
18650 Lithium-Ion Battery Pack
16.8V@10A
10 - 40 Minutes
100W Halogen
2000 Hours
6061-T6 Aircraft-Grade Aluminum
Mil-Spec Type III hard anodized in black
Low, Medium and High Power modes
On/O Button
One Year
FLASHTORCH | 4
WWW.WICKEDLASERS.COM
Flashtorch Diagram
Tailcap Button
LED Switch
Battery Compartment
Lamp Head
Power (DC) InputTailcap
User’s Manual & Safety Guide | 5
Quick Start Guide
Close the cover. Make
sure that the locking tab
is secure.
2
Connect the power cable
of the ashlight to the
Lithium battery pack.
1Screw on the tail cap,
make sure that the switch
is aligned properly with
the button.
3Press the button on the
tail cap to turn-on the
ashlight. It will start in
high-power mode by
default.
4
WARNING: The Flashtorch’s lamp head may become extremely hot after a few minutes of use. Do not touch it while in use and
allow enough distance from the lamp head for heat dissipation.
FLASHTORCH | 6
WWW.WICKEDLASERS.COM
Modes of Operation
The LED switch allows for switching between
high, medium and low power modes.
High-Power: This is the default mode after turning on the Flashtorch. It will run at
100% full-power.
Medium-Power: From High-Power mode, press the LED switch once, this will set it
to 50% power.
Low-Power: From Medium-Power mode, press the LED switch once, this will set it to
33% power.
Pressing the LED switch again from Low-Power Mode will set it back to High-Power
mode.
Lock Mode: For safety, connecting the charger to the Flashtorch will shut it o and the
LED switch will be unresponsive. The LED switch will be blinking to indicate it is in Lock
Mode. To exit this mode, disconnect the charger and press the tail cap switch twice
to turn it o then on again. Do not leave the Flashtorch in Lock Mode. Exit this mode
whenever possible.
LED Indicator: The LED will be on to show the Flashtorch is powered on. The LED will
be o to show that it is either o or out of battery power. The LED will constantly be
blinking to show that it is in Lock Mode.
Indice
Altri manuali Wicked lasers Torcia elettrica
