LP SERIES
INSTALLATION INSTRUCTIONS
PN #49091081
Page 2 of 2
H.E. Williams, Inc. Carthage, Missouri www.hew.com 417-358-4065
Information contained herein is subject to change without notice. REV.07/08/19JL
SKYLIGHT KIT FIXTURE INSTALLATION
Step 1: Place fixture on skylight kit.
Bend tabs over fixture (below).
Step 2: Wire fixture (see
Wiring on page 1).
Step 3: Install fixture into grid
ceiling.
LP fixture
1x4 2x2 2x4
23-15/16”
23-15/16
23-15/16
SURFACE MOUNT FIXTURE INSTALLATION
Step 1: Assemble kit with provided
flat head screws. Secure to
ceiling (screws provided by
others).
Step 2: Remove one end plate and wire
fixture (see Wiring on page 1). Be
sure to provide adequate length
of flexible conduit and slide LP
into side rails.
Step 3: Attach end plate.
Side rails
LP fixture
End plat
3”
1x4 2x2 2x4
24
24
FCC NOTES:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
■Reorient or relocate the receiving antenna.
■Increase the separation between the equipment and receiver.
■Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
■Consult the dealer or an experienced radio/TV technician for help.
