Wilson Electronics 304472 Manuale utente

Wide-Band

Panel Antenna

Window, Ceiling, Wall

& Outdoor Mounts

The wide-band panel antenna is vertically polarized. For optimum

performance, install the antenna with the cable running from the

bottom or the top.

WINDOW

#304452

#304472

CEILING

#304451

#304471

WALL

#311135

UPGRADE- #311155-0630

#311155

POLE

# 314453

#314473

Appearance of device and accessories may vary.

Antenna

Contact Wilson Electronics Customer Support Team with any questions at

866-294-1660 or email: [email protected]

Window Mount:

#304452 - 50 Ohm

#304472 - 75 Ohm

Ceiling Mount:

#304451 - 50 Ohm

#304471 - 75 Ohm

Wall Mount:

#311135

#311155

Pole Mount:

#314453

#314473

Optional In-Wall

Mount Accessory:

In-Wall Mounting

Bracket

(901123)

Appearance of device and accessories may vary.

Wide-Band Panel Antenna

Window, Ceiling, Wall & Pole Mounts

(extra parts may be included in hardware packet)

Panel Antenna

w/F-Female Connectors

RG6 30’ Coax Cable

w/F-Male Connectors

Required F-Female to SMA

Male adapter #2F1165

#311155-0630

DT4G Inside Panel

Antenna Upgrade

Contact Wilson Electronics Customer Support Team with any questions at

866-294-1660 or email: [email protected]

Window Mount Installation

Find the window that faces the direction of the nearest cell tower. The

signal strength function on your cell phone can help you determine

this. Contact Customer Support at 866-294-1660

for instructions on

accessing the signal strength function on your particular phone.

Choose an inside window location where the antenna will be hung.

Clean the window and the suction cups with glass cleaner.

It is important that the small tabs on each suction cup be facing outward

so they may be used to remove the antenna from the window if desired.

Use rm and even pressure to attach the antenna to the window without

breaking the glass. Avoid excessive or sudden pressure against the

glass.

Refer to Signal Booster instructions for separation requirements.

To be used as your outside antenna which communicates with the cell tower

Wide-Band

Panel Antenna

Window Cradle

Mount

Attach to

Window

Slide Panel

Antenna into

cradle

Panel

Antenna

remove tape

back panel

pull

Carefully pull back panel cover away from

antenna until tape releases (this will

take some force). Peel off tape and tape

residue before installing different mounting

options.

Remove Back Panel Before

Utilizing Other Mounting Options

Contact Wilson Electronics Customer Support Team with any questions at

866-294-1660 or email: [email protected]

Ceiling Mount Installation

anchor

wood screw

anchor

drill hole in ceiling

for end connector

anchor

Select a location on the ceiling that you can access from above to

run the antenna cable. Verify that your chosen location allows for

the necessary separation between the Inside and Outside Antenna

(see Signal Booster installation instructions for antenna separation

requirements).

Use the antenna as your template in your predetermined location.

Note: Ensure that the cable connector location is NOT below a ceiling

rafter.

Panel Antenna

remove ceiling

mount panel from

Panel Antenna

before utilizing other

mounting options

Remove Ceiling Mount Before

Utilizing Other Mounting Options

Drill a hole large enough to accommodate the dimension of the

connector on the location you have marked for the cable. Hold the

antenna to the ceiling and mark the locations for the screws and then

drill a 3/16 inch hole and tap anchors into

the pre-drilled screw holes.

Attach the Signal Booster “Inside

Antenna” cable to the connector on the

Ceiling Mount Antenna. Place the

antenna ush against the ceiling, and

then screw the antenna into place

(screws and anchors provided). Be

careful not to over-tighten.

If you have any questions about the

installation procedure, please

contact our Customer Support Team toll

free at 866-294-1660 or email

[email protected].

Wide-Band Panel Antenna

Ceiling Mount

Contact Wilson Electronics Customer Support Team with any questions at

866-294-1660 or email: [email protected]

Wall Mount Installation

Find the desired location for the Panel Antenna. Verify that the Panel

Antenna and the Outside Antenna have the necessary separation (see

Signal Booster instructions for requirements).

For optimum results, the antenna should be mounted a minimum of 6

feet from the oor.

Utilize Wall Mount Bracket (see diagram below) as your template. Drill

out the four holes for the screws in the wall, using a 3/16 size drill bit,

following your template. Tap in wall anchors provided and place the

mounting bracket over the wall anchors, insert the screws and tighten.

Slide the Panel Antenna onto the wall mount bracket (see diagram

below).

Wide-Band

Panel Antenna

Wall Mount

& hardware

slide into

mount

drywall

anchor &

screw

anchor &

screw

Panel Antenna back view

remove back panel

mount from Panel

Antenna before

utilizing other

mounting options

Remove Mount Before Utilizing

Other Mounting Options

Contact Wilson Electronics Customer Support Team with any questions at

866-294-1660 or email: [email protected]

The antenna should be mounted as shown in the illustration below. The

included mounting bracket is adjustable and will accommodate pipe

diameters from 1.25 inches to 2 inches (pipe sold separately #901117).

Mount the antenna so that there is at least 3 feet of clearance in front

and sides. Position the antenna so that it has the most unobstructed line

of sight to the cellular service provider’s strongest signal. If you are using

a wireless Signal Booster, make sure the antenna is not pointing across

your own roof.

Refer to Signal Booster instructions for separation requirements.

Warning: Lightning protection is recommended for all installations,

sold separately (Wilson Electronics #859902-50 Ohm &

#859992-75 Ohm). Take extreme care to ensure that

neither you nor the antenna comes near any electric

power lines.

Pole Mount Installation

Postion for strongest signal

Pole Mount

& hardware

Wide-Band

Panel Antenna

pipe sold separately

#901117

Contact Wilson Electronics Customer Support Team with any questions at

866-294-1660 or email: [email protected]

Cell Tower

RF Signal

Wide Band

Antenna

-50dB -60dB -70dB -80dB -90dB -100dB -110dB

EXCELLENT

Signal Strength

GOOD

Signal Strength

POOR

Signal Strength

SIGNAL

Adjusting the Antenna for Maximum Performance

To adjust the antenna for best performance, connect it to your cell

phone with an External Adapter and a length of cable (External Antenna

Adapters and cables are sold separately). Put the cell phone in test

mode and turn the antenna in 10-degree increments while checking

the cell phone’s signal level. At each point you may need to wait a few

seconds as your cell phone updates.

Once you have obtained the strongest signal, fully tighten the mounting

hardware. After the Signal Booster and the rest of the system is installed

and performing correctly, weatherproof all connections.

Important: If you are using a Wireless Signal Booster, be sure the

antenna is not pointing across the building in which you are trying

to get coverage. The antenna should point away from the building

to help prevent oscillation (feedback).

Ultra low loss cable is recommended for lengths 20 feet or greater to

prevent signicant signal loss. Wilson Electronics offers WILSON 400

cable in several lengths from 20-100 feet. Wilson Electronics also offers

a wide range of phone adapters to connect your cell phone to a Signal

Booster or directly to the antenna. To nd the adapter for your phone, or

contact Customer Support toll free 866-294-1660.

Signal readings usually appear as a negative number (for example, -86).

The larger the number, the more powerful the signal (-75 is stronger than

-84). See graph above.

103074_Rev15_05.04.17

2-Year Warranty

Wilson Electronics Signal Boosters are warranted for two (2) years against defects in workmanship

and/or materials. Warranty cases may be resolved by returning the product directly to the reseller with

a dated proof of purchase.

Antennas may also be returned directly to the manufacturer at the consumer’s expense, with a dated

proof of purchase and a Returned Material Authorization (RMA) number supplied by Wilson Electronics.

Wilson Electronics shall, at its option, either repair or replace the product. Wilson Electronics will pay for

delivery of the repaired or replaced product back to the original consumer.

This warranty does not apply to any antennas determined by Wilson Electronics to have been subjected

to misuse, abuse, neglect, or mishandling that alters or damages physical or electronic properties.

Replacement products may include refurbished Wilson Electronics products that have been recertied

to conform with product specications.

RMA numbers may be obtained by contacting Technical Support at 866-294-1660.

Disclaimer: The information provided by Wilson Electronics, LLC is believed to be complete and

accurate. However, no responsibility is assumed by Wilson Electronics, LLC for any business or

personal losses arising from its use, or for any infringements of patents or other rights of third parties

that may result from its use.

Wilson Electronics, LLC

3301 East Deseret Drive, St. George, UT 84790

For additional Technical Support visit www.WilsonElectronics.com

or email at: [email protected]

Phone: 866-294-1660 Local: 435-673-5021 Fax: 435-656-2432

www.twitter.com/WilsonCellular www.facebook.com/WilsonCellular

Antenna Specifications

Part

Number 304452 304472 304451 304471 311135 314473 311155 314453 311155-0630

Frequency

Range

700-800 MHz / 824-894 MHz / 880-960 MHz / 1710-1880 MHz

1850-1900 MHz / 2110-2700 MHz

698-716 MHz / 776-787 MHz / 824-849 MHz / 1710-1755

MHz / 1850-1995 MHz

698-716 MHz / 776-787 MHz /

824-849 MHz / 1710-1755 MHz /

1850-1995 MHz

Impedance 50 Ohms 75 Ohms 50 Ohms 75 Ohms 50 ohms 75 ohms 75 Ohms 50 Ohms 75 Ohms

Connector N-Female F-Female N-Female F-Female N-Female F-Female F-Female N-Female F-Female

Antenna

Gain

5.2 dBi 700-800 MHz / 4.4 dBi 824-894 MHz / 4.2 dBi 880-960 MHz

/ 10.1 dBi 1710-1880 MHz / 10.6 dBi 1850-1990 MHz /

8 dBi 2110-2700 MHz

3.8 dBi 698-716 MHz / 3.6 dBi 776-787 MHz / 4.4 dBi 824-849

MHz / 8.2 dBi 1710-1755 MHz / 10.0 dBi 1850-1995 MHz

1.49 dBi 698-716 MHz / 1.26 dBi

776-787 MHz / 1.81 dBi 824-849

MHz / 4.25 dBi 1710-1755 MHz /

5.72 dBi 1850-1995 MHz

Polarization Vertical

Beamwidth

Horizontal

Plane

70 / 60 Deg

Beamwidth

Vertical Plane 50 / 45 Deg

Max Power 50 Watts

Dimension 8.27 x 7.09 x 1.73 (inch) / 21 x 18 x 4.39 (cm)

Weight 1.32 lbs / 0.6 kg

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Wilson Electronics Antenna

Wilson Electronics

Wilson Electronics 301201 Manuale utente

Wilson Electronics

Wilson Electronics 301143 Manuale utente

Wilson Electronics

Wilson Electronics 301123 Manuale utente

Wilson Electronics

Wilson Electronics 301130 Manuale utente

Wilson Electronics

Wilson Electronics 301133 Manuale utente

Wilson Electronics

Wilson Electronics 304411 Manuale utente

Wilson Electronics

Wilson Electronics 301102 Manuale utente

Wilson Electronics

Wilson Electronics 304451 Manuale utente

Wilson Electronics

Wilson Electronics 301157 Manuale utente

Wilson Electronics

Wilson Electronics 301124 Manuale utente

Wilson Electronics

Wilson Electronics 301119 Manuale utente

Wilson Electronics

Wilson Electronics WR-500 Manuale utente

Wilson Electronics

Wilson Electronics 301134 Manuale utente

Wilson Electronics

Wilson Electronics 301104 Manuale utente

Wilson Electronics

Wilson Electronics 301124 Manuale utente

Wilson Electronics

Wilson Electronics 301143 Manuale utente

Wilson Electronics

Wilson Electronics SignalBoost DT Manuale utente

Wilson Electronics

Wilson Electronics 311104 Manuale utente

Wilson Electronics

Wilson Electronics 301130 Manuale utente

Wilson Electronics

Wilson Electronics 301111 Manuale utente

Wilson Electronics

Wilson Electronics 301102 Manuale utente

Wilson Electronics

Wilson Electronics SignalBoost DT Manuale utente

Wilson Electronics

Wilson Electronics 301104 Manuale utente

Wilson Electronics

Wilson Electronics 301201 Manuale utente

Manuali Antenna popolari di altre marche

Alfa Network

Alfa Network APA-L01 Manuale utente

Naval

Naval PR-422CA Manuale utente

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manuale utente

TERK Technologies

TERK Technologies TV44 Manuale utente

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manuale utente

HP J8999A Manuale utente

MobilSat

MobilSat MSP-S Manuale utente

Steren

Steren ANT-UHF 13 Manuale utente

Novatel

Novatel 600-G Manuale operativo

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manuale utente

TRENDnet

TRENDnet TEW-AO12O Manuale utente

Radio Shack

Radio Shack 15-1837 Manuale utente

CommScope

CommScope CMAX-OMFX-43M-I53 Manuale utente

Ramsey Electronics

Ramsey Electronics DAP25 Manuale utente

COBHAM

COBHAM SAILOR 800 VSAT Manuale per l'uso e la cura

Trango Systems

Trango Systems AD900-9 Manuale utente

Steren

Steren ANT-100 Manuale utente

Proxim

Proxim 5054-PA-23 Manuale utente