30175 Installation Instructions
2
DISCLAIMER
Winsted Control Room Consoles and its affiliated corporations
and subsidiaries (collectively “Winsted”), intend to make this
manual accurate and complete. However, Winsted makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Winsted
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Winsted assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Winsted® is a registered trademark of Winsted® Control Room
Consoles. All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING: Never operate this mounting system if it is
damaged. Return themounting system toa service center for
examination and repair.
WARNING: Do not use this product outdoors.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located attached to the Monitor Mounts up to
(and including)the displaydoes not exceed 40 lbs (18.14 kg).
Use with products heavier than the maximum weight
indicated may result in collapse of the mount and its
accessories causing possible injury.
--SAVE THESE INSTRUCTIONS!--
DIMENSIONS
Slat Wall Mount (30175)
2.95
75.0
3.94
100.0
3.94
100.0 2.95
75.0
18.20
462.4
10.56
268.1
9.13
231.9
6.75
171.5
2.32
59.0
