Wolf M Series Manuale utente

M Series Ovens Installation Guide

M SERIES OVENS

Contents

3M Series Ovens

4Specications

12 Installation

14 Troubleshooting

Features and specications are subject to change at any

time without notice. Visit wolfappliance.com/specs for the

most up-to-date information.

Wolf Customer Care 800.222.7820

Important Note

To ensure this product is installed and operated as safely

and efciently as possible, take note of the following types

of highlighted information throughout this guide:

IMPORTANT NOTE highlights information that is especially

important.

CAUTION indicates a situation where minor injury or product

damage may occur if instructions are not followed.

WARNING states a hazard that may cause serious injury or

death if precautions are not followed.

IMPORTANT NOTE: Throughout this guide, dimensions in

parentheses are millimeters unless otherwise specied.

IMPORTANT NOTE: Save these instructions for the local

electrical inspector.

wolfappliance.com

M SERIES OVENS

Product Information

Important product information including the model and

serial number are listed on the product rating plate. The

rating plate is located near the bottom trim on the left. The

oven door must be open to view the rating plate. Refer to

the illustration below.

If service is necessary, contact Wolf factory certied service

with the model and serial number. For the name of the

nearest Wolf factory certied service or for questions

regarding the installation, visit the contact & support section

of our website, wolfappliance.com or call Wolf customer

care at 800-222-7820.

Rating plate location.

RATING

PLATE

Wolf Customer Care 800.222.7820

SPECIFICATIONS

Installation Requirements

The M series oven can be installed in a standard or ush

inset application. If a cooktop is being installed above an

oven, a minimum of 1/4"(6) is required between units. Loca-

tion of the electrical supply within the oven opening may

require additional cabinet depth.

Finish the edges of the opening. They may be visible when

the door is open.

For standard installations, face trim will overlap stiles and

rails. Refer to the chart below.

For ush inset installations, a minimum 1/8"(3) reveal is

required on all sides. To ensure consistent reveals, each

corner of the opening must be exactly 90°.

INSTALLATION REQUIREMENTS

BASE SUPPORT MIN

Single Oven 250 lb (115 kg)

Double Oven 400 lb (181 kg)

TRIM OVERLAP

Top 1" (25)

Bottom 0" (0)

Sides 11/16"(18)

DUAL INSTALLATION

Two 30" single M series ovens can be installed side by side

in a standard or ush inset application. A dual installation kit

is required. To maintain appropriate airow, the ovens must

be installed into one opening. Any cosmetic or structural

material placed between the ovens will impede airow and

is not recommended. Refer to illustrations on the following

pages.

The dual installation kit is available through an authorized

Wolf dealer. For local dealer information, visit the nd a

showroom section of our website, wolfappliance.com.

wolfappliance.com

Electrical

Installation must comply with all applicable electrical codes.

Locate the electrical supply ush with the back wall and

within the shaded area shown in the illustrations on the

following pages. For ease of installation, the electrical

supply for the oven can be placed in an adjacent cabinet

within reach of the conduit.

Performance may be compromised if the electrical supply is

less than 240 volts.

The oven is supplied with a conduit consisting of two

insulated hot lead conductors and a bare ground conductor.

The wiring diagram covering the control circuit is provided

with the oven.

Rating plate location.

RATING

PLATE

SPECIFICATIONS

ELECTRICAL REQUIREMENTS—SINGLE OVEN

Electrical Supply grounded, 240/208 VAC, 60 Hz

Service 30 amp dedicated circuit

Conduit 4' (1.2 m)

Total Amps 22

Max Connected Load 5.4 kW

Min Supply Wire L1, L2, ground—10 AWG

ELECTRICAL REQUIREMENTS—DOUBLE OVEN

Electrical Supply grounded, 240/208 VAC, 60 Hz

Service 50 amp dedicated circuit

Conduit 5' (1.5 m)

Total Amps 45

Max Connected Load 10.8 kW

Min Supply Wire L1, L2, ground—8 AWG

Wolf Customer Care 800.222.7820

SPECIFICATIONS

M Series Single Oven

STANDARD INSTALLATION

(127)

(102)

FRONT VIEW

SIDE

VIEW

NOTE: Location of electrical supply within opening may require additional cabinet depth.

231/4" (591)

OPENING

DEPTH

TOP VIEW

OPENING WIDTH

271/2"

(699)

OPENING

HEIGHT

OPENING WIDTH W

30" Model 281/2"(724)

wolfappliance.com

SPECIFICATIONS

M Series Single Oven

FLUSH INSET INSTALLATION

"(25) minimum depth. Shaded areas will be visible and should be finished to match cabinetry.

7/8"(22) for transitional, professional and contemporary stainless steel models and 1" (25) for contemporary black glass model.

*Dimension provides minimum reveals.

NOTE: Location of electrical supply within opening may require additional cabinet depth.

283/4"

(730)

FLUSH INSET

HEIGHT***

(127)

(102)

FRONT VIEW

SIDE

VIEW

11/8" (29)

1/8" (3)

13/16" (21)

24" (610)

FLUSH INSET

DEPTH

7/8" (22)

1"(25)**

FLUSH INSET WIDTH***

TOP VIEW

FINISHED

CLEATS*

FLUSH INSET WIDTH W

30" Model 301/8"(765)

Wolf Customer Care 800.222.7820

SPECIFICATIONS

M Series Double Oven

STANDARD INSTALLATION

(127)

(102)

FRONT VIEW

SIDE

VIEW

NOTE: Location of electrical supply within opening may require additional cabinet depth.

497/8"

(1267)

OPENING

HEIGHT

231/4" (591)

OPENING

DEPTH

OPENING WIDTH

17" (432)

TYPICAL

TOP VIEW

OPENING WIDTH W

30" Model 281/2"(724)

wolfappliance.com

SPECIFICATIONS

M Series Double Oven

FLUSH INSET INSTALLATION

"(25) minimum depth. Shaded areas will be visible and should be finished to match cabinetry.

7/8"(22) for transitional, professional and contemporary stainless steel models and 1" (25) for contemporary black glass model.

*Dimension provides minimum reveals.

NOTE: Location of electrical supply within opening may require additional cabinet depth.

(127)

(102)

FRONT VIEW

SIDE

VIEW

511/8"

(1299)

FLUSH INSET

HEIGHT***

11/8" (29)

1/8" (3)

13/16" (21)

24" (610)

FLUSH INSET

DEPTH

7/8" (22)

1"(25)**

FLUSH INSET WIDTH***

17" (432)

TYPICAL

TOP VIEW

FINISHED

CLEATS*

FLUSH INSET WIDTH W

30" Model 301/8"(765)

Wolf Customer Care 800.222.7820

(127)

E E

(102)

(127)

(102)

FRONT VIEW

SIDE

VIEW

NOTE: Location of electrical supply within opening may require additional cabinet depth.

231/4" (591)

OPENING

DEPTH

TOP VIEW

271/2"

(699)

OPENING

HEIGHT

581/2"(1486)

OPENING WIDTH

M Series Ovens

DUAL STANDARD INSTALLATION

SPECIFICATIONS

Altri manuali per M Series

Indice

Altri manuali Wolf Forno

Manuali Forno popolari di altre marche

Bosch

Bosch HVA531NS0 Manuale utente

Electrolux

Electrolux EOF6P46X Manuale utente

NEFF

NEFF B44S32 5GB Series Manuale utente

Combi

Combi BLODGETT BC142GDS Manuale utente

AEG

AEG COMPETENCE 311704300 Manuale utente

Falcon

Falcon DOMINATOR PLUS G3106 Series Guida utente

Rational

Rational SCC WE 61G Manuale utente

Smeg

Smeg DOSPA38X Manuale di installazione e funzionamento

Electrolux

Electrolux air-o-convect 20 GN 2/1 Manuale utente

Miele

Miele HR 1954-2 Manuale utente

KHIND

KHIND OT50 Manuale utente

Henny Penny

Henny Penny Smoker Box Manuale utente

Lang

Lang ECOD-AP Manuale utente

AEG

AEG BEK455310M Manuale utente

Frigidaire

Frigidaire FNGE90JGR Manuale utente

Hotpoint

Hotpoint FE9 S831 JSH IX Manuale utente

GE Advantium SCB2000 Manuale utente

AEG

AEG DE401301DM Manuale utente