EN
6
GUTTERPRO Universal
Gutter Cleaning Kit
SAFETY INSTRUCTIONS
WARNING! User must read the product
manual to fully understand this product
prior to use, and follow all safety instructions
as outlined in the WORXAIRTM Operator’s
Manual.
CAUTION!The user must wear the
appropriate clothing and safety goggles
when operating this product. Be aware of all
bystanders, pets and objects in a close
proximity.
• DO NOT operate blower and attachments
when fatigued.
• DO NOT overreach or stand on unstable
support. Keep good footing and balance at
all times.
• Never direct airflow towards bystanders.
Always be aware of the direction that the
debris will be thrown.
• Use a face filter mask to avoid breathing
dust and debris.
WARNING: This product maybe contains
lead, phthalate or other chemicals known to
the State of California to cause cancer, birth
defects and other reproductive harm. Please
wash your hands after use.
ASSEMBLY AND OPERATION
1. ATTACH THE GUTTER KIT AS SHOWN
IN Fig. A1:
Connect the (1, 2, 3) components by screwing
together. Snap the (3, 4) components together.
2.
ASSEMBLING THE UNIVERSAL ADAPTOR
(1) Place the fabric side of the Universal
Adapter over the Blower Outlet and slide it
on as far as possible (B1).
(a) WORXTRIVAC models - Place the fabric
side of the Universal Adapter over the
Vacuum Outlet and slide it on as far as
possible (B1.1). Before operation, flip the
blow/vac switch into the vacuum mode.
PLEASE NOTE: Items can be vacuumed
through the vac inlet and pass through or
clog the gutter kit. Please keep the vac inlet
away from objects while using the gutter
kit.
(2) Check to make sure the strap is threaded
through the locking mechanism. Then
pull to tighten the strap (B2). Increase the
tension by pulling the latch up and down
to tighten (B3). To loosen, simply press the
two outside latches down and then pull the
strap out from other side (B4).
(3) Test that the Universal Adapter will not
slide off of the blower outlet.
(4) If further tightening is needed, then pull the
middle latch up and down until the adapter
is tight. Please recheck if it will slide off of
the blower outlet. Realign and repeat these
steps if needed (B3). To loosen, simply
press the two outside latches down and
then pull the strap out from other side (B4).
PLEASE NOTE:The Universal Adapter may
have space between the Blower Outlet and
Adapter Outlet after installation.
To remove the adapter, simply press the two
outside latches down and loosen the strap to
remove it from the Blower Outlet (B4).
NOTE:
Use only enough GutterTube Extensions to
comfortably reach the inside of the gutter.
3. OPERATE ACCORDING TO Fig. C:
The Gutter Tube Nozzle can be adjusted to any
desired direction by rotating the GutterTube
Connecter as shown in Fig. D. Gutter cleaning
applications will vary. It is recommended to
try various positions to find the most effective
working position for the type of house and
gutter design.
