Xtreem FlyeEye Manuale utente
VIDEO DRONE THAT’S
YOUR EYE IN THE SKY
INSTRUCTION MANUAL
2
SAFETY PRECAUTIONS
NOTICE: Before using the Drone, read this instruction manual carefully, and obey all warnings and caution labels
- seriously, it’s no fun if someone gets hurt.
CHOKING HAZARD - SMALL PARTS, KEEP
OUT OF REACH OF SMALL CHILDREN.
WARNING - DO NOT FLY IN RESTRICTED OR
NO-FLY ZONES. CHECK YOUR LOCAL LAWS
AND REGULATIONS FOR INFORMATION
REGARDING THE USE OF UNMANNED
AERIAL VEHICLES.
WARNING - THIS DRONE IS NOT INTENDED
FOR USE BY CHILDREN UNDER 14 YEARS
OLD. ADULT SUPERVISION IS REQUIRED AT
ALL TIMES.
CAUTION - DO NOT TOUCH THE RUNNING
PROPELLERS OR FLY OVER SOMEONE’S
HEAD.
• Keep hands, hair and loose clothing away from the propellers when the power switch is turned on.
• Always lift off from a flat surface. Never hold the drone in your hand when lifting off.
• Stay away from obstacles and electrical hazards.
• Check the weather conditions. Do not operate the drone in rainy or snowy conditions, or when the wind
exceeds 5 MPH (8 KM/H).
• Make sure the controller’s antenna is pointing straight up.
• Keep the drone within line of sight - if line of sight to the controller is lost, you may lose control of the
drone.
• Always keep a safe distance in all directions around your drone to avoid collisions and/or injury. This
drone is controlled by a radio signal subject to interference from many sources outside your control.
Interference can cause momentary loss of control.
• Never completely exhaust the battery. When the drone starts to lose power, immediately bring it down
safely, and charge the battery as soon as practicable.
• Turn off the controller and drone when not in use.
• Read and obey all warnings and safety guidelines in this manual.
• Regularly examine for any damage to the plugs, propellers and other parts (loose or missing screws).
Replace any damaged or loose parts before attempting to fly.
3
SAFETY PRECAUTIONS
• Never charge battery unattended.
• Never charge batteries overnight.
• Charge battery in an isolated, controlled
environment. Keep far away from flammable
materials.
• Do not expose to direct sunlight; there is a risk
that the battery may overheat, ignite and/or
explode.
• Do not disassemble, modify, heat, or short circuit
the battery.
• Do not drop the battery or subject it to strong
impacts.
• Do not allow the battery to get wet.
• Only charge the battery with the supplied
charging equipment. Using other charging
equipment will void your warranty, may damage
the battery and poses a risk of fire or explosion.
• If the Drone is not being used for an extended
period of time, remove the battery and store it in
a cool, dry place out of the reach of children.
• In the unlikely event of leakage or explosion, use
sand or a chemical fire extinguisher to extinguish
the battery.
• The battery must be recycled or disposed of
properly.
• Controller requires 4 x 1.5V AA alkaline batteries
(not included).
• Installing/Replacing batteries must be undertaken
by a competent adult.
• Do not mix new and old batteries or types of
batteries (i.e. alkaline/standard).
• To avoid battery leakage, remove batteries from
the controller if the Drone is not being played for
a long period of time.
• Promptly remove exhausted batteries. Battery
leakage and corrosion can damage the controller.
• Recycle or dispose of used batteries responsibly.
The Drone is equipped with a Lithium Polymer battery. These kind of batteries are light and powerful, as their
chemistry is based on lithium, a light and extremely volatile metal.
SPECIAL LIPO BATTERY INSTRUCTIONS:
BATTERY SAFETY INSTRUCTIONS
WARNING - MODIFICATIONS NOT APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE
COULD VOID USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
4
YOUR CONTROLLER
Power LED
Throttle Stick
Video (up)
Photo (down)
Rotation Trim
Power Switch
Speed Control 360° Flip
Sideway Trim
Direction Stick
Forward / Backward
Trim
Antenna
Headless Flight Return Home
Hover
Get acquainted with your controller.
Low = single beep
Medium = double beep
High = triple beep
5
INSTALL CONTROLLER BATTERIES
Your controller requires 4 AA batteries (not included). Open the battery cover of the controller, insert 4 new
“AA” (1.5V) alkaline batteries following the polarity markings (+ and -) inside the battery compartment, and then
replace the battery cover.
AA 1.5V
AA 1.5V
AA 1.5V
AA 1.5V
6
PREPARE FOR FLIGHT
Charge the Drone LiPo battery
Plug the white (3-wire) connector on the LiPo battery into the charging connector on the charger, and then plug
the charger into a power outlet. While charging, the charger LED will be solid red. When charging is complete,
the charger LED turns green.
• Only charge the battery with the original
charger. Using other charging equipment
will void your warranty, may damage
the battery, and could result in fire or
explosion.
• Promptly remove the battery and
disconnect the charger from the power
outlet once charging is complete.
CAUTION
The LiPo battery which is partially charged at shipment. For longest flying time and best performance, fully
charge the battery before the first use.
~ 90 mins
charging time
(from empty)
7
PREPARE FOR FLIGHT
Install the Drone LiPo battery
Once fully charged, plug the red (2-wire) connector on the LiPo battery to the drone’s power cable located
inside the Drone battery compartment. Stow the LiPo battery and any excess cables inside the battery
compartment, and then close the cover.
power cable
battery compartment
(Black to Black,
Red to Red)
8
PREPARE FOR FLIGHT
Attach the prop guards
Prop guards prevent propellers from getting damaged or hurting someone, in case of collision.
(under the arm)
Optional front and rear LED covers can be fitted together with the prop guards under the arms of the
Drone, if necessary. They can make it easier to tell which way the Drone is flying.
Note: Do not over-tighten
screws as this can cause the
mounting holes to deform.
Use this screw
type
9
Attach the landing gear
The set of landing gear provides the Drone a stable platform and protects the bottom-mounted camera during
takeoff and landing.
PREPARE FOR FLIGHT
Use this screw
type
10
Install the Drone camera
The camera comes pre-fitted with a tilt mount. Simply attach the mount to the four screw posts located
underneath the Drone and secure in place using screws. Once mounted, plug the camera’s power connector
into the “CAMERA” port on the Drone.
PREPARE FOR FLIGHT
CAMERA
1
2
3
camera power
connector
The camera has no internal memory; instead photos and videos are stored on a microSD memory card. Be
sure to insert a microSD memory card into the microSD slot on top of the camera.
Peel off the transparent film
wrapped around the camera lens
Use this screw
type
Indice
Altri manuali Xtreem Drone
