Xtreem RAPTOR EYE Manuale utente
Raptor
EYE
RC QUADCOPTER SHOOTS
OUT OF THIS WORLD HD VIDEO
INSTRUCTION MANUAL
2
SAFETY PRECAUTIONS
NOTICE: Before using the Drone, read this instruction manual carefully, and obey all warnings and caution labels
- seriously, it’s no fun if someone gets hurt.
CHOKING HAZARD - SMALL PARTS, KEEP
OUT OF REACH OF SMALL CHILDREN.
WARNING - DO NOT FLY IN RESTRICTED OR
NO-FLY ZONES. CHECK YOUR LOCAL LAWS
AND REGULATIONS FOR INFORMATION
REGARDING THE USE OF UNMANNED
AERIAL VEHICLES.
WARNING - THIS DRONE IS NOT INTENDED
FOR USE BY CHILDREN UNDER 14 YEARS
OLD. ADULT SUPERVISION IS REQUIRED AT
ALL TIMES.
CAUTION - DO NOT TOUCH THE RUNNING
PROPELLERS OR FLY OVER SOMEONE’S
HEAD.
• Keep hands, hair and loose clothing away from the propellers when the power switch is turned on.
• Always lift off from a flat surface. Never hold the drone in your hand when lifting off.
• Stay away from obstacles and electrical hazards.
• Keep your drone within line of sight - if line of sight to the controller is lost, you may lose control of the
drone.
• Always keep a safe distance in all directions around your drone to avoid collisions and/or injury. This drone
is controlled by a radio signal subject to interference from many sources outside your control. Interference
can cause momentary loss of control.
• Never completely exhaust the battery. When the drone starts to lose power, immediately bring it down
safely, and charge the battery as soon as practicable.
• Turn off the controller and drone when not in use.
• Read and obey all warnings and safety guidelines in this manual.
• Regularly examine for any damage to the plugs, propellers and other parts (loose or missing screws).
Replace any damaged or loose parts before attempting to fly.
3
SAFETY PRECAUTIONS
• Never charge battery unattended.
• Never charge batteries overnight.
• Charge battery in an isolated, controlled
environment. Keep far away from flammable
materials.
• Do not expose to direct sunlight; there is a risk
that the battery may overheat, ignite and/or
explode.
• Do not disassemble, modify, heat, or short circuit
the battery.
• Do not drop the battery or subject it to strong
impacts.
• Do not allow the battery to get wet.
• Only charge the battery with the supplied
charging equipment. Using other charging
equipment will void your warranty, may damage
the battery and poses a risk of fire or explosion.
• If the Drone is not being used for an extended
period of time, remove the battery and store it in
a cool, dry place out of the reach of children.
• In the unlikely event of leakage or explosion, use
sand or a chemical fire extinguisher to extinguish
the battery.
• The battery must be recycled or disposed of
properly.
• Controller requires 4 x 1.5V AA alkaline batteries
(not included).
• Installing/Replacing batteries must be undertaken
by a competent adult.
• Do not mix new and old batteries or types of
batteries (i.e. alkaline/standard).
• To avoid battery leakage, remove batteries from
the controller if the Drone is not being played for
a long period of time.
• Promptly remove exhausted batteries. Battery
leakage and corrosion can damage the controller.
• Recycle or dispose of used batteries responsibly.
The Drone is equipped with a Lithium Polymer battery. These kind of batteries are light and powerful, as their
chemistry is based on lithium, a light and extremely volatile metal.
SPECIAL LIPO BATTERY INSTRUCTIONS:
BATTERY SAFETY INSTRUCTIONS
WARNING - MODIFICATIONS NOT APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE
COULD VOID USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
4
YOUR CONTROLLER
Power LED
Throttle Stick
Photo
Video
Speed Control /
Headless Flight
(hold for 3 seconds)
Rotation
(Left & Right) Trim
Power Switch
360° Flip /
Return Home
(hold for 3 seconds)
Sideway
(Left & Right) Trim
Direction Stick
Forward &
Backward Trim
Antenna
Get acquainted with your controller.
5
INSTALL CONTROLLER BATTERIES
Your controller requires 4 AA batteries (not included). Open the battery cover of the controller, insert 4 new
“AA” (1.5V) alkaline batteries following the polarity markings (+ and -) inside the battery compartment, and then
replace the battery cover.
AA 1.5V
AA 1.5V
AA 1.5V
AA 1.5V
6
PREPARE FOR FLIGHT
Charge the Drone LiPo battery
The LiPo battery which is partially charged at shipment. For longest flying time and best performance, fully charge the
battery before the first use.
HDMI
~ 90 mins
charging time
(from empty)
USB charging cable
LiPo battery
connector
LiPo battery
(inside the battery
compartment)
If it’s more convenient, you can also slide
open the battery compartment cover and
take out the Drone battery for charging.
7
PREPARE FOR FLIGHT
Install the Drone LiPo battery
Once fully charged, plug the battery connector on the LiPo battery to the drone’s power connector.
Power connector
Lipo battery connector (Black to Black,
Red to Red)
8
PREPARE FOR FLIGHT
Attach the prop guards
Prop guards prevent propellers from getting damaged or hurting someone, in case of collision.
Fit the guide pegs on the prop guard
into the holes on the arms of the
Drone so that the screw holes on the
prop guard and Drone align, and then
secure into place with a screw.
Do not over-tighten screws as this can cause the mounting holes to deform.
9
Attach the landing gear
The set of landing gear provides a stable platform for the Drone, enabling safer landing and added protection for
the shell.
PREPARE FOR FLIGHT
10
Pair the controller
PREPARE FOR FLIGHT
1
2 Turn on the controller. Beginning from a neutral position, move the Throttle stick all the way up and then all
the way down. The Drone LEDs stop blinking and the controller beeps once more to indicate successful
pairing. The Drone is ready for takeoff.
Turn on the Drone and place it on a flat, level surface.
Power switch located at
the tail end of the Drone
Indice
Altri manuali Xtreem Quadricottero
