Xtreme X-160 Manuale utente

X-Treme™ Electric Scooters

X-160

Sea Scooter

User Manual

USER MANUAL

SEA SCOOTER

Read through carefully and understand these instructions before operating

the scooter.

DO NOT RETURN TO STORE!

Do not use this sea scooter for the first

time until you have completely read this manual

thoroughly. Failure to follow these instructions may

damage your sea scooter and void your warranty.

For technical support or warranty issues

CALL OR GO ONLINE

1-253-777-0690

www.x-tremescooters.com/support/

TABLE OF CONTENTS

Introduction……………………………………………………………………………………………………. 4

Parts Diagram………………………………………………………………………………………………….5

Warnings………………………………………………………………………………………………………. 6

Getting Started…………………………………………………………………………………………………7-8

Using the Sea Scooter for Swimming or Snorkeling………………………………………………..7

Use of Variable Speed………………………………………………………………………………… 7

Using the Sea Scooter for Diving –Adjusting the Buoyancy………………………………………8

Battery Use……………………………………………………………………………………………………. 9-11

Charging the Battery………………………………………………………………………………….. 9-11

To Replace A Flat Battery With A Fully Charged Battery…………………………………………. 11

Care & Maintenance…………………………………………………………………………………………. 12

Battery Care……………………………………………………………………………………………. 12

Care After Using the Sea Scooter…………………………………………………………………….12

Troubleshooting………………………………………………………………………………………………. 13-15

Unit Does Not Function……………………………………………………………………………….. 13

Blocked Propeller……………………………………………………………………………………….13

Removing the Fan Shroud To Remove An Obstruction…………………………………………… 13

Removing the Fan Guard And Propeller To Remove Obstruction………………………………..13-14

Sand or Grit On Seals………………………………………………………………………………….14

Sea Scooter Cuts Out………………………………………………………………………………….15

Accidental Flooding…………………………………………………………………………………….15

Wiring Diagram……………………………………………………………………………………………….. 16

INTRODUCTION

Thank you for choosing your X-Treme X-160 Sea Scooter. This new design in personal water propeller will give you

twin speed power for up to 4.8km/hr for up to 90 minutes of use at a depth of 30 meters while at the same time still

being light and compact.

There are many features incorporated in this design so please read this manual thoroughly to be sure you learn and

get the most out of your X-Treme Sea Scooter.

PARTS DIAGRAM

1. Latch

2. Nose Cone

3. Inner Nose Cone

4. Vent Plug

5. Triggers

6. Handle

7. Nozzle

8. Propeller

9. Fan Shroud & Fan Guard

10. Battery Housing

11. Master Switch

12. Battery Leads

13. Battery

14. Vent Hole

15. Buoyancy Control Chamber

16. Silicone Ring

17. Pump

18. Lubricant

WARNINGS!

Read the user’s manual carefully.

Never remove the Fan Shroud or Fan Guard except for maintenance.

Never stick body parts, clothing or other objects in the vicinity of the Propeller. Do not wear loose or flowing

clothing or equipment that could be drawn into the Propeller.

Particular care should be exercised when using the sea scooter near anybody with long hair. Users with long

hair should tie it up in a ponytail or wear a swim cap when using the sea scooter.

Always inspect the swimming area to ensure it is free of hazards or obstacles such as boats and swimmers

before using the sea scooter.

Always charge battery to its fullest before using the sea scooter. Ensure sufficient battery charge remains for

return to shore or surface.

Always wear a cost guard approved personal floatation device when using the sea scooter.

Be aware of appropriate water levels, tidal changes, dangerous currents, weather changes and strong

offshore winds. Always scout unfamiliar water.

Do not use alcohol or mind-altering drugs prior to using this product.

ALWAYS keep the sea scooter out of direct sunlight when not in use. HEAT KILLS BATTERIES.

When using the sea scooter for SCUBA, ascents and descents should be made in accordance with

recognized diving practices.

The sea scooter should only be used for SCUBA by qualified divers.

Always follow this age recommendation: a child under 16 years old should never operate this sea scooter.

Never open the Cover of the sea scooter under water.

When not in use, always turn the Master Switch to the OFF position.

Do not use the sea scooter below the recommended maximum depth of 30 meters.

GETTING STARTED

When you buy the sea scooter the battery is disconnected and needs to be charged. Follow the instructions on

page 9 –Battery Use, Charging the Battery –for charging and connection.

Using the Sea Scooter for Swimming and Snorkeling

When swimming or snorkeling the sea scooter should be kept positively buoyant –this is done by simply making

sure the Buoyancy Chamber is empty and fitted inside the Nose Cone.

To use the sea scooter for swimming or snorkeling follow these instructions.

1. Charge the battery –see page 9 for instructions. Make sure that when you finish charging the battery the

Vent Plug is closed.

2. Place the sea scooter into the water so the Handle, Outer Nose Cone and Nozzle fill with water.

3. When ready to set off, switch the Master Switch to the ON position shown in Figure 2.

4. Pull and hold one or both Triggers to start the Propeller.

5. To stop the Propeller, simply release the Trigger.

6. Always turn the Master Switch OFF when out of the water.

7. Proper posture when using the sea scooter is important to achieve the maximum speed –see Figure 3 for the

correct position of the sea scooter when using it.

CAUTION: Do not dive deeper than

you would normally when snorkeling to

ensure you can get back to the surface

safely.

Use of Variable Speed

Your sea scooter features two speeds –for normal speed, pull the right trigger only. For the higher speed, pull both

triggers together.

Using the Sea Scooter for Diving –Adjusting the Buoyancy

Your sea scooter can be used for diving up to 30 meters but will need to be adjusted for neutral buoyancy. The sea

scooter must never be adjusted for negative buoyancy to avoid it from sinking if accidentally released.

To adjust the neutral buoyancy, follow these instructions.

1. Make sure the sea scooter Master Switch is in the OFF position.

2. Remove the sea scooter from the water, give a half turn to turn the Latches, remove them –see Figure 4 –

and remove the Buoyancy Control Chamber.

3. Open the Buoyancy Chamber and add a small amount of rocks or a lead weight –see Figure 5.

4. Replace the Buoyancy Chamber, Nose Cone and Latches and place the sea scooter in the water. If the sea

scooter is neutrally buoyant it will just float in the water.

5. If the sea scooter sinks, remove rocks until it is neutrally buoyant. If the sea scooter is still positively buoyant

repeat step 3 until it is neutrally buoyant.

CAUTION: If the sea scooter is later used for swimming or

snorkeling be sure to remove the weight from the Buoyancy Chamber

so the sea scooter has positive buoyancy.

BATTERY USE

The Battery Housing should always be ventilated during charging to allow potentially explosive gasses to

dissipate. Before removing/attaching any battery cables always allow two minutes for any gasses to dissipate.

ALWAYS plug the charger jack into the charging socket first and then plug into the mains. When charging is

complete, unplug the charger from the mains first and then from the charging socket.

ALWAYS ensure the charger socket is DRY before plugging in a live charger.

NEVER place a battery in a sealed container when charging.

NEVER charge the battery near water.

If in doubt of the state of the battery, recharge it until the indicator on the battery charger indicates full charge.

ALWAYS charge the battery in a well-ventilated place where it is out of reach of children.

ALWAYS ensure the unit is dried thoroughly before opening the Nose Cone for charging or changing the

battery.

Charging the Battery

For charging the battery, follow these instructions.

1. Always ensure that the Master Switch is OFF –see Figure 2.

2. Always ensure that the sea scooter is out of the water and placed in a dry area.

3. Give a half turn to the Latches and remove them from the

Nose Cone as shown in Figure 4.

4. Remove the Outer Nose Cone and Buoyancy Control

Chamber.

5. Open the Vent by unscrewing the Vent Plug.

6. Remove the Inner Nose Cone. To do this, first feed the

silicone ring (provided with this manual) through the latch

holes in the Inner Nose Cone and hook over the hooks on the

Battery Housing –see Figure 6. Then screw the Pump

Nozzle onto the Vent Hole and pump air into the Battery

Chamber until the Inner Nose Cone pops off and then remove the silicone ring.

7. Allow two minutes for any gasses to dissipate.

8. Disconnect the battery cable from the housing cable (if not already disconnected –the cable will be

disconnected when your remove your sea scooter from the carton after purchase) by pressing the locking

feature.

9. Connect the battery cable to the charger cable.

10. Plug the charger into the mains and turn on the supply. Do not

replace the Nose Cone.

11. Charging will take 4 to 6 hours for a fully discharged battery. When

the battery is charging the LED charger light remains on, when the

battery is charged the LED flashes.

12. Unplug the adapter from the mains.

13. Unplug the battery cable from the charger cable and reconnect to

to the Housing Cable.

14. Make sure the seals and sealing surfaces are clean and lubricated

before placing the Inner Nose Cone –see Figure 7 and 8.

15. Replace the Inner Nose Cone making sure the key is aligned

correctly. See Figure 9.

16. Ensure the Vent O-Ring is fitted correctly. See Figure 10.

17. Screw in the Vent Plug to seal the vent.

18. Replace the Buoyancy Control Chamber.

Indice

Altri manuali Xtreme Scooter

Xtreme

Xtreme X-600 Manuale utente

Xtreme

Xtreme XG-550 Manuale utente

Xtreme

Xtreme XB-300SLA Manuale utente

Xtreme

Xtreme XG-575DS Manuale utente

Xtreme

Xtreme XM-3500Li Guida alla risoluzione dei problemi

Xtreme

Xtreme X-360 Manuale utente

Xtreme

Xtreme XM-5000Li Guida alla risoluzione dei problemi

Xtreme

Xtreme XG-565 A-Blaze Signature Series Manuale utente

Xtreme

Xtreme XG-470 Manuale utente

Xtreme

Xtreme X-560 Manuale utente

Xtreme

Xtreme XM-4000Li Guida alla risoluzione dei problemi

Xtreme

Xtreme XG-499 Manuale utente

Xtreme

Xtreme X-140 Manuale utente

Xtreme

Xtreme X-600 Manuale utente

Xtreme

Xtreme Rubicon 48V Manuale utente

Xtreme

Xtreme X-140 Manuale utente

Xtreme

Xtreme X-140 Manuale utente

Xtreme

Xtreme XT300 Manuale utente

Xtreme

Xtreme XMB-320 Manuale utente

Xtreme

Xtreme XMB-400 Manuale utente

Xtreme

Xtreme XG-505 Manuale utente

Xtreme

Xtreme XR-101 Manuale utente

Xtreme

Xtreme XH-505 Manuale utente

Xtreme

Xtreme XB-420M Manuale utente

Manuali Scooter popolari di altre marche

TEKTRO

TEKTRO CHEETAH Manuale utente

Douglas

Douglas Vespa Sprint Guida all'installazione

PLAYTIVE

PLAYTIVE AS-2448 Manuale utente

Ebinger

Ebinger DONKEY XL Manuale utente

Flyer

Flyer Mountain Guida utente

BackCountry eBikes

BackCountry eBikes Storm Manuale utente

equipmed

equipmed FreeRoam II Manuale utente

Yoto

Yoto Lion Manuale utente

WESTHILL BIKES

WESTHILL BIKES LINK Manuale utente

BAnff

BAnff eProdigy series Manuale utente

Winther

Winther 475 Manuale utente

Jetson

Jetson JBZL17 Manuale utente

First Choice Mobility

First Choice Mobility Roma Medical Corella S741 Manuale utente

Carrera

Carrera impel Manuale utente

Afikim

Afikim Superlight SL-3 Manuale utente

CareCo

CareCo ZOOM Manuale utente

Douglas

Douglas Vespa G.S. Manuale utente

Gazelle

Gazelle with BOSCH System Manuale utente