Xylem Jabsco ParMax 1 Plus Manuale utente

Jabsco ParMax 1 Plus

LOW FLOW, COMPACT WATER PRESSURE PUMPS

Pompes de PRESSION D’EAU

compactes à bas débit

Kompakte DRUCKWASSERPUMPE

mit niedrigem Durchuss

Pompe di PRESSIONE IDRICA

a basso usso, compatte

Lage doorstroming, compact

WATERDRUK-pompen

Lågt öde, kompakt

VATTENTRYCKSPUMPAR

Bombas compactas de bajo caudal

de PRESIÓN DEL AGUA

Purpose of this manual

The purpose of this manual is to provide necessary information for product installation,

operation andmaintenance.

CAUTION: Read this manual carefully before installing,using or servicing

this product. Failure to follow the instructions within this manual could result

in explosion, property damage, severe personal injury and/or death.

DANGER: Failure to follow this instruction manual may lead to signicant

property damage or may result in serious injury or death.

WARNING:

• The operator must be aware of safety precautions to prevent physical injury.

• Operating,installing or maintaining the unit in any way that is not covered in this

manual could cause death, serious personal injury or damage to the equipment.

This includes any modication to the equipment or use of parts not provided by

Xylem.If there is a question regarding the intended use of equipment, please

contact a Xylem representative before proceeding.

• Do not change the service application without the approval of an authorized

Xylem representative.

NOTICE: Save this manual for future reference, and keep it readily

available at the location of the unit.

Safety

About safety messages

It is extremely important that you read,understand and follow the safety messages and

regulations carefully before handling the product.They are published to help prevent

these hazards:

• Personal accidents and health problems

• Damage to the product

• Product malfunction

Safety terminology and symbols

Hazard Level:

DANGER

WARNING

CAUTION

NOTICE

Indication:

A hazardous situation which,if not avoided, will result in

death or serious injury.

A hazardous situation which,if not avoided, could result in

death or serious injury.

A hazardous situation which,if not avoided, could result in

minor or moderate injury.

A potential situation which,if not avoided, could result in

undesirable conditions.

A practice not related to personal injury.

ELECTRICAL HAZARD:

Hazard categories can either fall under hazard levels or let specic symbols replace the

ordinary hazard levels symbols. Electrical hazards are indicated by the following specic

symbols:

These are examples of other categories that can occur.They fall under the ordinary

hazard levels and may use complementing symbols:

Hazard categories

• Crush hazard

• Cutting hazard

• Arc ash hazard

General safety rules

These are safety rules apply:

• Always keep work area clean

• Pay attention to the risks presented by gas and vapors in the work area.

• Avoid all electrical dangers. Pay attention to the risks of electric shock or arc ash hazards

• Always bear in mind the risk of drowning, electrical accidents and burn injuries

User safety

Safety equipment

Use safety equipment according to the company regulations.Use this safety

equipment within the work area:

Electrical connections

Electrical connections must be made by certied electricians in compliance with

all international, national,state and local regulations. For more information about

requirements, see sections dealing specically with electrical connections.

• Hard hat

• Safety goggles,preferably with side shields

• Protective shoes

• Protective gloves

• Gas mask

• Hearing protection

• First-aid kit

• Safety devices

NOTICE: Never operate a unit unless safety devices are installed.

Precautions before work

Observe these safety precautions before you work with the product or are in connection

with the product:

• Provide a suitable barrier around the work area, for example,a guard rail

• Make sure that all safety guards are in place and secure

• Make sure that you have a clear path of retreat

• Make sure that the product cannot roll or fall over and injure people or damage

property

• Make sure that the lifting equipment is in good condition

• Use a lifting harness, a safety line and a breathing device as required

• Allow all system and pump components to cool before you handle them

• Make sure that the product has been thoroughly cleaned

• Disconnect and lock out power before you service the pump

• Check the explosion risk before you weld or use electric hand tools

Wash the skin and eyes

Follow these procedures for chemicals or hazardous uids that have come into contact

with your eyes or skin:

Action

1. Hold your eyelids apart forcibly with your ngers

2. Rinse the eyes with eyewash or running water for al least

15 minutes

3. Seek medical attention

1. Remove contaminated clothing

2.Wash the skin with soap and water for a least 1 minute

3. Seek medical attention, if necessary

Condition

Chemicals or

hazardous uids

in eyes

Chemicals or

hazardous uids

on skin

The work area

Always keep the station clean

Waste and emissions regulations

Observe these safety regulations regarding waste and emissions:

• Appropriately dispose of all waste

• Handle and dispose of the processed liquid in compliance with applicable

environmental regulations

• Clean up all spills in accordance with safety and environmental procedures

• Report all environmental emissions to the appropriate authorities

Environmental safety

Electrical installation

For electrical installation recycling requirements, consult your local electric utility

Recycling guidelines

Always follow local laws and regulations regarding recycling

WARNING: Radiation Hazard.Do NOT send the product toXylem if it has

been exposed to any nuclear radiation

WARNING: It is critical that chemical compatibility between the pump and the

liquid media be veried by the user before installation and use in the equipment.

Chemical incompatibility may cause premature failure and may result in leakage.

Always read the manufacturers literature before you use uid or solvent in the pump.

STOP

Installation/Mounting

1: Select pump location. Pump must be installed in a dry, ventilated area.

CAUTION: Installation Notes: To avoid the risk of re. Be sure that the area

where pump is installed is isolated from gas,fuel tanks,electrical wiring looms

or ammable substances. Failure to do so may cause injury or death.

CAUTION: Not For Continuous Duty,Intermittent Duty Only

CAUTION: Installation Notes: To avoid the risk of re. Do not install this

product if visible damaged. If damage exposes electrical contacts, electrical

sparks could ignite fuel fumes. Failure to do so may cause injury or death.

HORIZONTAL TYPICAL

VERTICAL

NOTE: Do Not Submerge

2: For a pump only installation, connect ttings supplied with the pump to the

system plumbing. Use 3/8” (9mm) I.D. exible hose (preferably braided or

reinforced) to reduce vibration through the plumbing system.Use hose clamps

on the slip on barb hose connectors. For a pump and faucet utilize included

tubing and John Guest (type) ttings.

3: Fasten pump to a at surface. If mounting vertically; install with pumphead

down. Do not over tighten screws to allow rubber mounts to absorb vibration.

WARNING:

• Observe accident prevention regulations in force.

• Use suitable equipment and protection.

• Always refer to the local and/or national regulations, legislation,and codes

in force regarding the selection of the installation site, plumbing,and power

connections.

Electrical installation

Electrical Hazard:

Installation:

WARNING: Make sure that all connections are performed by qualied

installation technicians and in compliance with the regulations in force.

WARNING: Before starting work on the unit, make sure that the unit and the

control panel are isolated from the power supply and cannot be energized.

Electrical requirements:

The local regulations in force overrule specied requirements listed below.

Electrical connection checklist

Check that the following requirements are met:

• The electrical leads are protected from high temperature,vibrations, and collisions.

• The current type and voltage of mains connection must correspond to the

specications on the data plate on the pump.

• Initial Start up

• Open all faucets

• Turn pump switch “ON”

• When water is free of air, turn

all valves off beginning with

the valve closest to the pump

Operation

CAUTION: Allowing water to freeze in the system may result in damage to the

pump, plumbing system or Exposed Industrial applications. Non-Toxic antifreeze

for potable water may be used with Jabsco pumps.Follow manufacturer’s

recommendations. Refer to equipment manufacturer’s instructions for their specic

winterizing and drainage procedures.Do not use automotive antifreeze to winterize

potable water systems .These solutions are highly toxic and may cause serious

injury or death if ingested.

1. Drain the water tank. Open tank drain valve.You may use the pump to drain

the tank by opening all the valves in the system.Allow the pump to operate

until the tank is empty. Do not operate the pump more than 15 minutes

continuously.

2. Open all valves and purge the water from the plumbing system.Turn off

power to the pump. Be sure that all the water from the drain lines is drained.

3. Remove quick-connect inlet and outlet ttings from the pump and turn the

pump on to pump out remaining water from the pump head. Be sure to

have a catch pan or a rag under the pump to prevent water from spilling onto

the oor. Turn the pump off once the plumbing is empty. Leave the ttings

disconnected from the pump until the system is ready to be used again.

Make a note on your tank ller that the plumbing is not connected.

4. Be sure that all valves are left open to protect against damage to the

plumbing.

Winterizing

2.79 [70.1]

2.66 [67.6]

1.72 [43.7]

3.30 [83.8]

4.05 [102.9]

6.47 [164.3]

1.90 [48.3]

3.37 [85.6] 2.21 [56.1] 0.90

[22.9]

Dimensional Drawing

Indice

Lingue:

Altri manuali Xylem Pompa dell'acqua

Xylem

Xylem Flygt 2075 Manuale utente

Xylem

Xylem G&L A-C 8300 Series Manuale utente

Xylem

Xylem Flygt 2400 Manuale utente

Xylem

Xylem Bell & Gossett e-82 Series Manuale utente

Xylem

Xylem GOULDS LC Manuale

Xylem

Xylem GOULDS NPO Manuale utente

Xylem

Xylem Bell & Gossett VSC Series Manuale utente

Xylem

Xylem FLOJET Duplex II Series Manuale utente

Xylem

Xylem JABSCO 11860 Series Manuale utente

Xylem

Xylem Lowara e-IXPS Manuale

Xylem

Xylem Lowara ecocirc S Manuale

Xylem

Xylem GOULDS LB Manuale utente

Xylem

Xylem Goulds Red Jacket Series Manuale utente

Xylem

Xylem McDonnell & Miller MM-706B Manuale utente

Xylem

Xylem FLOJET BW5000 Series Manuale utente

Xylem

Xylem LOWARA e-SVE Manuale

Xylem

Xylem Laing Thermotech E-10 Series Manuale utente

Xylem

Xylem JABSCO 42755 Series Manuale utente

Xylem

Xylem Lowara Micro PRESFIX Manuale utente

Xylem

Xylem FLOJET 2840 Series Istruzioni per l'uso e l'installazione

Xylem

Xylem LOWARA e-LNEEE Guida alla risoluzione dei problemi

Xylem

Xylem hydrovar hv 1.1 Manuale utente

Xylem

Xylem FLYGT APP 412 Manuale utente

Xylem

Xylem Bell & Gossett TECHNOForce e-HV Series Manuale utente

Manuali Pompa dell'acqua popolari di altre marche

Neptun

Neptun NPHW 5500 Manuale utente

Sensidyne

Sensidyne Gilian BDX-II Istruzioni per l'installazione e il funzionamento

Draper

Draper 47808 Manuale utente

Trolla

Trolla 12820 Manuale utente

Sunfab

Sunfab SVH Series Manuale utente

WilTec

WilTec 50740 Manuale utente

Fieldmann

Fieldmann FVC 5015 EK Manuale utente

Everbilt

Everbilt EFSUB5-122HD Manuale utente

Graco

Graco Husky 3300e Manuale utente

esotec

esotec 101018 Manuale utente

moyno

moyno 2000 CC Manuale utente

Becker

Becker BASIC VASF 2.80/1-0.AC230 Manuale utente

Sykes AmeriPumps

Sykes AmeriPumps GP100M Guida alla risoluzione dei problemi

DUROMAX

DUROMAX XP WX Series Manuale utente

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Manuale utente

Franklin Electric

Franklin Electric IPS Manuale utente

Milton Roy

Milton Roy PRIMEROYAL Manuale utente

STA-RITE

STA-RITE ST33APP Manuale utente