Yakima HighRoller Manuale utente

HigHRolleR

SNAP AROUND

BASEPLATE BOLTS

(SHORTER)

HEX KEY

WHEELTRAY BOLT

(LONGER)

WHEEL STRAP

THUMBWHEEL 2X

BASEPLATE COVER

Baseplate

Wheel Grip

small hoop

adjuster KnoB

red Button

BiG hoop

SNAP AROUND (3X)

rear Wheel tray

HEX BOLTS 2X

(optional MightyMount attachments)

CROSSBAR SPREADS

• Up to 2 HighRollers: 16” (41cm)

minimum crossbar spread

• More than 2 HighRollers: 18” (46cm)

minimum crossbar spread

• Maximum crossbar spread is 46”

(117cm)

1033349G-2/21

HATCH INTERFERENCE:

HighRoller can face opposite direction

when there is hatch interference.

Remove the

tabs with

scissors or

pliers.

Loosen the tabs in the

SnapArounds by bending

them repeatedly.

MIGHTYMOUNTS:

• Attach 2 MightyMounts on the rear bar

and 1 on the front bar.

• If your MightyMounts require bar caps,

install them now. Metal bar caps should

be applied to back crossbar (front of bike

mount). Refer to this diagram in place of

your MightyMount instructions.

Do you have - square - rounD - or oTher - crossbars?

OTHER

SQUARE

UNIVERSAL

MIGHTYMOUNT

#03590

Follow the Universal MightyMount

instructions and refer to this instruction for

correct installation.

• Attach 1

SnapAround on rear

bar for wheeltray.

• Attach 2

SnapArounds

on front bar for

baseplate.

HATCH INTERFERENCE:

HighRoller can face opposite direction

when there is hatch interference.

ROUND

• Attach 1

SnapAround on rear

bar for wheeltray.

• Attach 2

SnapArounds

on front bar for

baseplate.

MightyMounts purchased separately

(refer to the YAKIMA Fit List for correct

MightyMounts for your vehicle).

REAR OF VEHICLE

1033349G-3/21

Slide wheeltray bolt into

rear end of wheeltray. SECURE WITH

HEX KEY.

Align bolt to hole...

Position mount anywhere

on crossbars.

Lift both hoops until they stop. Remove baseplate cover. Press sides and lift to expose bolt holes.

If you position the front mount straddling a tower, the

wheel tray can attach to either side of the rear tower.

Insert short

baseplate bolts

through bottom of

SnapArounds into

baseplate.

LOOSELY ATTACH

THUMBWHEELS.

MightyMount users:

• Remove embedded nut

in thumbwheel.

• Push hex bolt into top of

knob until fully seated.

• Insert hexogaonal bolts

through thumbwheels

into baseplate.

•LOOSELY ATTACH

THUMBWHEELS.

MightyMount users:

Remove embedded nut in

MightyMount.

1033349G-4/21

Move big hoop forward.

DO NOT USE MOUNT

WITH WHEELS

UNDER 20" (51cm)

Slide wheel grip until it

aligns to your tire size.

Open wheel grip handle.

The wheel grip

handle must align to

a number before it

will close.

ATTACH WHEEL STRAP

• Insert one end of

strap into slot on far

side of Wheeltray.

• Leave other end free.

Tighten Thumb Wheels. Replace baseplate covers.

(They should snap into place).

Find the tire size of

your front wheel.

Small hoop should lay ﬂat.

Some downhill

tires may require

a higher setting.

While holding small hoop,

press red button.

1033349G-5/21

CLOSE THE STRAP.

Lift bike and place front

wheel in front hoop.

Smaller hoop should

compress against tire. If

wheel moves, tighten more.

Pull the strap through wheel

spokes.

• Insert strap end behind buckle.

•TIGHTEN strap by repeatedly lifting buckle.

• DO NOT OVERTIGHTEN.

CHECK TIRE FOR TIGHT FIT.

Do not let the strap

push against the

valve stem.

CENTER TIRE IN WHEELGRIP.

TIGHTEN

ADJUSTMENT KNOB.

Roll bicycle forward in front tray. Lift small hoop to rest against tire.

Lock your HighRoller

between towers on

crossbar

when not in use.

See your lock

instructions for

installing lock. Loop

cable around frame

and insert silver post

into lock housing.

• If not tight, loosen strap.

• Adjust position of strap and strap

base until strap rests against rim.

• TIGHTEN strap again.

Keep strap centered

on small wheels.

1033349G-6/21

BEFORE DRIVING AWAY:

CHECK THE REAR WHEEL.

Tighten the strap if needed. OFF-ROAD

DRIVING

is not

recommended

and could

result in

damage to

your vehicle

or your bike.

CHECK THE FRONT WHEEL.

If it is loose or it moves, be sure knob

is tight and wheel is centered!

CHECK THE HEX KEY AND THE

OBLONG KNOBS.

If they are loose, tighten them.

If there is

contact, check

wheel setting.

CHECK FRONT WHEEL

ATTACHMENT TO

BICYCLE FORK.

MAKE SURE YOUR

TIRES ARE FILLED

TO RECOMMENDED

PRESSURE FOUND ON

THE TIRE.

DO NOT OVERTIGHTEN

THE STRAP!

To release rear strap,

push tab in buckle.

Roll back and lift bike out.

Lower both hoops when

not in use.

SUPPORT BIKE.

Lay hoop ﬂat.

UNLOAD BIKE: FRONT WHEEL

Loosen

adjustment knob

until small hoop

is loosened.

SUPPORT SMALL HOOP.

Press red button.

Small hoop

will lower.

WARNING

BE SURE ALL HARDWARE

IS SECURED ACCORDING

TO INSTRUCTIONS.

ATTACHMENT

HARDWARE CAN LOOSEN

OVER TIME. CHECK

BEFORE EACH USE, AND

TIGHTEN IF NECESSARY.

• There must be adequate clearance for

installing accessory locks.

• If the accessory lock housing comes

in contact with the vehicle, even after

loading the rack, do not install them.

YAKIMA ACCESSORY LOCKS

CAN LOCK THE MOUNTS TO

THE RACKS

(lock housings purchased

separately)

REAR HATCH

Some longer loads may

prevent the rear hatch

from fully opening.

ALWAYS USE

CAUTION WHEN

OPENING YOUR HATCH.

DO NOT TRANSPORT BICYCLES WITH

ATTACHED BABY SEATS, PANNIERS, WHEEL

COVERS, FULL BIKE COVERS OR MOTORS.

WEIGHT LIMITS

Follow the YAKIMA Fit List or your owner’s manual for

your rack’s weight limit. Do not exceed the factory

weight limit of your vehicle’s racks.

Maximum rack’s weight is 165 lbs. (75 kg) unless otherwise noted.

IF YOU REMOVE YOUR CARRIER, FOLLOW

INSTRUCTIONS TO INSTALL.

Follow safety checks in accessory

instructions before every installation.

BIKE WEIGHT LIMIT:

MaxIMuM bIKe WeIghT Is 50 Lbs. (23 Kg).

Indice

Altri manuali Yakima Accessori per automobili

Yakima

Yakima Whispbar K462W Manuale utente

Yakima

Yakima GEAR BOXES Manuale utente

Yakima

Yakima WheelFork 1032732 Manuale utente

Yakima

Yakima Landin Pad 3 Manuale utente

Yakima

Yakima K725 Manuale utente

Yakima

Yakima Diamondback Manuale utente

Yakima

Yakima SteelHead Manuale utente

Yakima

Yakima K386 Manuale utente

Yakima

Yakima OverHaul HD Manuale utente

Yakima

Yakima K668 Manuale utente

Yakima

Yakima Whispbar K887W Manuale utente

Yakima

Yakima Swing Daddy 4 Manuale utente

Yakima

Yakima 8004093 Manuale utente

Yakima

Yakima LITERIDER 2&3 Manuale utente

Yakima

Yakima K1225 Manuale utente

Yakima

Yakima HullRaiser AERO Manuale utente

Yakima

Yakima K1019 Manuale utente

Yakima

Yakima BlockHead Manuale utente

Yakima

Yakima PR3041 Manuale utente

Yakima

Yakima forklift Manuale utente

Yakima

Yakima 8004046 Manuale utente

Yakima

Yakima JayHook Manuale utente

Yakima

Yakima LoadWarrior Manuale utente

Yakima

Yakima LoadWarrior Manuale utente

Manuali Accessori per automobili popolari di altre marche

James Baroud

James Baroud Odyssey Manuale utente

Motorola

Motorola i50sx Manuale utente

Feniex

Feniex T3 Manuale utente

Renault

Renault 77 11 423 180 Manuale utente

Kia

Kia E8300-4D000 Manuale utente

Brink

Brink 756843 Manuale utente

Whispbar

Whispbar K085W Manuale utente

v.link

v.link CI-VL2-PC-HSD Manuale utente

Viking

Viking Stack-Rack Guida rapida alla configurazione

Aries

Aries 203015 Manuale utente

Choetech

Choetech AT0005 Manuale utente

ZZ2

ZZ2 ZZAIR-PRO Manuale utente

Holman

Holman 4A80L Manuale utente

Thule

Thule 2075 Manuale utente

Motorola

Motorola T325 Manuale utente

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guida all'installazione

DV8

DV8 FBJL-02 Manuale utente

Prorack

Prorack K1163 Manuale utente