YUNEEC E50 Manuale utente
QUICK START GUIDE V2.0
CONTENTS
EN: Quick Start Guide
DE: Schnellstartanleitung
FR: Guide de démarrage rapide
ES: Guía de inicio rápido
IT: Guida Rapida
Introduction and Overview
01 Damping Plate
02 LED Status Indicator
03 Lens
04 5 GHz Antenna
05 MicroSD Card Slot
06 USB Upgrade Port
07 Camera
01
02
03
04
05
06
07
Specifications
General.
Name:
Dimensions:
Weight:
Yuneec E50
115x80x130mm
275g
Gimbal.
Angular Vibration Range:
Mount:
Controllable Range:
Mechanical Range:
Environmental.
Operating Temperature:
±0.02°
Detachable
Tilt: +15°to -90°
Pan: 360°
Tilt: +30° to -120°
Pan: 360°
Roll:±40°
Camera.
Sensor :
Effective Pixels:
Lens:
FOV:
Photo Resolutions:
Video Resolutions:
Photo Formats :
Video Formats:
Operation Modes:
Exposure Mode:
Exposure Compensation:
Metering Mode:
Shutter Speed:
White Balance:
ISO Range:
CMOS 1/2.3''
12MP
F/2.4 7.2mm(40mm Equivalent with 6x Crop Factor)
58°
4:3 4000x3000
UHD: 4K(4096x2160) 24/25p
4K(3840x2160) 24/25/30p
FHD: 1920x 1080 24/25/30/48/50/60/120p
Jpeg, DNG, DNG+Jpeg
MP4
Capture, Record
Program AE Mode, Manual Exposure Mode
±2.0
Spot Metering、Center-weighted Metering、Average Metering
4-1/8000s
Daylight、Cloudy、Auto、Fluorescent、Incandescent、Sunrise/Sunset
100-3200
-10 to 40℃
Assembling
Step 1.
Find the arrow printed on the top of the damping plate,
which indicates the correct direction for installation.
Step 2.
Slide the E50 in the indicated direction all the way into
the mounting slot, until the E50 is secured by the locking
clip.
Step 3.
Remove the lens protector.
Step 4.
Insert the Micro SD card.
Gimbal Installing
Disassembling
Step 1.
Find the locking clip which is located in front of the
mounting slot
Step 2.
Press and hold the locking clip and push the E50 forward
(the direction shown by the arrow).
Cancel
ok
Please enter password for
NO CAMERA
Fly
Takeoff
RTL
Pause
Action
Reset All Links Close
Not Connected N/A
75%
GPS
E50 31009B
E50 31009B
NO CAMERA
Fly
Takeoff
RTL
Pause
Action
Not Connected N/A
75%
GPS
Select Vehicle to Connect NO CAMERA
E50 31009B
Fly
Takeoff
RTL
Pause
Action
Reset All Links Close
Not Connected N/A
75%
GPS
Binding the E50
NOTICE
If the connection process is delayed, close the pop
up window and then repeat the above steps.
Step 1.
Switch on the ST16S followed by the H520 aircraft.
Step 2.
Tap the [ ] on the top right corner of the main
interfaceofST16S.
Step 3.
Tap the serial number of the E50 when the following
window pops up. (If multiple Yuneec UAS are used,
check the ID number on the side of each camera to
assure correct camera selection/binding).
Step 4.
Using the password “1234567890”, authorize the
camera and tap "OK" to confirm.
Collection and Processing of Data
Yuneec may collect navigation information such as GPS data to help improve our products.
We may also collect Depth Map information and Infrared Image information from your drone delivered to our
service center for repair and maintenance service or any other service.
We may also collect other information such as device information, server log information, etc. We may also collect
personal information used in registration if you choose to become a registered user and any other information
user provided to Yuneec. We may also collect information which user send to other users, and the recipients and
senders of such information.
NOTICE
1.Make sure that the firmware of the gimbal has been updated to the latest version.
2.For the latest product information, please check our official website: www.yuneec.com.
WARNING
Do not expose the lens of the E50 gimbal camera to extreme light sources.
Do not operate the E50 gimbal camera in the rain or in environments with high humidity.
Do not try to repair the E50 gimbal camera. Repairs must go to an authorized service center.
Do not touch or move the E50 gimbal camera until the initialization process has been completed.
The following special language terms are used throughout the product literature to indicate various levels
of potential harm when operating this product:
NOTICE Procedures, which if not properly followed, create a possibility of property damage and/or little to no
possibility of injury.
CAUTION Procedures, which if not properly followed, create the probability of property damage and/or a
possibility of serious injury.
WARNING Procedures, which if not properly followed, create the probability of property damage, collateral
damage and/or serious injury or create a high probability of superficial injury.
WARNING
Read the entire instruction manual to become familiar with the features of the product before operating.
Do not use with incompatible components or alter this product in any way outside o the instructions provided by
Yuneec.
Failure to use this product in the intended manner as described in instruction manual can result in damage to the
product, property and/or cause serious injury.
Disclaimer
Yuneec Electric Aviation cannot be held liable for any damage, injury or for use of the product in violation with legal
regulations, especially in the following circumstances: Damage and/or injury as well violation of legal regulations
resulting from a failure to comply with the operating instructions or the instructions at www.yuneec.com, product
information, user manual and other legally binding information.
Damage and/or injury as well violation of legal regulations brought about by the influence of alcohol, drugs,
medication or other narcotics which may impact on the concentration of the user.
The same applies to illnesses effecting the concentration of the user(dizziness, tiredness, nausea etc.) or other
factors compromising mental and physical capabilities.
Intentionally caused damage, injury or violation of legal regulations.
Any request for compensation caused by an accident resulting from use of the product.
Damage and/or injury as well as violation of legal regulations caused by use of the product in a no-fly zone,
e.g.next to an airfield, above a motorway or a natural conservation area.
Malfunction of the product caused by retrofitting or replacement with components which did not come from
Yuneec Electric Aviation.
Damage and/or injury caused by the use of replica parts (non-original parts).
Damage and/or injury as well as violation of legal regulations caused by incorrect operation or misjudgement.
Damage and/or injury caused by damaged spare parts or not using original Yuneec Electric Aviation spare parts.
Damage and/or injury as well as violation of legal regulations caused by ignoring the low voltage battery warning.
Damage and/or injury as well as violation of legal regulations caused by operating the model in a magnetic field
(e.g. high voltage lines, electricity/ transformer stations, radio towers, mobile phone masts etc.), a strong wireless
We reserve the right to disclose your information if required to do so by law or in the good-faith belief that such
disclosure is needed to comply with applicable laws, for example in response to a court order, judicial subpoena,
warrant or request from government, or otherwise cooperating with government agencies or law enforcement.
We also reserve the right to disclose your information that we believe in good faith is necessary or appropriate to:
(i) protect ourselves or others from fraudulent, unlawful, or abusive activities; (ii) take precautions against potential
liability; (iii) protect the security of the Yuneec Apps embedded into or downloaded onto your drone or any associated
equipment and services; (iv) protect the legal rights of ourselves or any others.
Any information we collected maybe disclosed or transferred to an acquirer, successor or assignee as part of any
potential merger, acquisition, debt financing or other activities that involves transfer of business assets.
We may make the aggregated non-personal information of the users available to third parties for various purposes,
including (i) complying with various report obligations; (ii) marketing efforts; (iii) analyzing product safety; (iv)
understanding and analyzing our users’ interests, habits, usage pattern for certain functionalities, services,
content, etc.
Altri manuali per E50
1
Indice
Lingue:
