ABB Relion 615 series Manuale utente
Relion® 615 series
Transformer Protection and Control
RET615
IEC 60870-5-103 Point List Manual
Document ID: 1MRS756883
Issued: 2012-05-11
Revision: C
Product version: 4.0
© Copyright 2012 ABB. All rights reserved
Copyright
This document and parts thereof must not be reproduced or copied without written
permission from ABB, and the contents thereof must not be imparted to a third
party, nor used for any unauthorized purpose.
The software or hardware described in this document is furnished under a license
and may be used, copied, or disclosed only in accordance with the terms of such
license.
Trademarks
ABB and Relion are registered trademarks of the ABB Group. All other brand or
product names mentioned in this document may be trademarks or registered
trademarks of their respective holders.
Warranty
Please inquire about the terms of warranty from your nearest ABB representative.
http://www.abb.com/substationautomation
Disclaimer
The data, examples and diagrams in this manual are included solely for the concept
or product description and are not to be deemed as a statement of guaranteed
properties. All persons responsible for applying the equipment addressed in this
manual must satisfy themselves that each intended application is suitable and
acceptable, including that any applicable safety or other operational requirements
are complied with. In particular, any risks in applications where a system failure and/
or product failure would create a risk for harm to property or persons (including but
not limited to personal injuries or death) shall be the sole responsibility of the
person or entity applying the equipment, and those so responsible are hereby
requested to ensure that all measures are taken to exclude or mitigate such risks.
This document has been carefully checked by ABB but deviations cannot be
completely ruled out. In case any errors are detected, the reader is kindly requested
to notify the manufacturer. Other than under explicit contractual commitments, in
no event shall ABB be responsible or liable for any loss or damage resulting from
the use of this manual or the application of the equipment.
Conformity
This product complies with the directive of the Council of the European
Communities on the approximation of the laws of the Member States relating to
electromagnetic compatibility (EMC Directive 2004/108/EC) and concerning
electrical equipment for use within specified voltage limits (Low-voltage directive
2006/95/EC). This conformity is the result of tests conducted by ABB in
accordance with the product standards EN 50263 and EN 60255-26 for the EMC
directive, and with the product standards EN 60255-1 and EN 60255-27 for the low
voltage directive. The product is designed in accordance with the international
standards of the IEC 60255 series.
Table of contents
Section 1 Introduction.......................................................................5
This manual........................................................................................5
Intended audience..............................................................................5
Product documentation.......................................................................5
Product documentation set............................................................5
Document revision history.............................................................6
Related documentation..................................................................6
Symbols and conventions...................................................................7
Symbols.........................................................................................7
Document conventions..................................................................7
Functions, codes and symbols......................................................8
Section 2 IEC 60870-5-103 data mappings...................................11
Overview...........................................................................................11
Supported functions..........................................................................11
Point list for RET615 Ver.4.0 TE01-08.............................................13
Indications and controls...............................................................13
General Data(FUN=0) IEC 60870-5-103 standard.................13
General Data(FUN=10) - 615-specific....................................14
GeneralData(10-2) - 615-specific...........................................15
LD0.MVGAPC1 Multipurpose binary inputs (1)......................15
LD0.MVGAPC2 Multipurpose binary inputs (2)......................15
LD0.SRGAPC1 Multipurpose binary outputs - flip-flop
resets (1)................................................................................16
LD0.SRGAPC2 Multipurpose binary outputs - flip-flop
resets (2)................................................................................16
LD0.SPCGGIO1 Multipurpose binary outputs (1)..................16
LD0.SPCGGIO2 Multipurpose binary outputs (2)..................17
LD0.NSPTOC1 Negative-sequence overcurrent
protection (1)..........................................................................18
LD0.NSPTOC2 Negative-sequence overcurrent
protection (2)..........................................................................18
LD0.SEQRFUF1 Fuse failure protection................................18
LD0.TPOSSLTC1 Tap position..............................................18
LD0.MAPGAPC1 Multipurpose analog protection
function (1).............................................................................18
LD0.MAPGAPC2 Multipurpose analog protection
function (2).............................................................................19
LD0.MAPGAPC3 Multipurpose analog protection
function (3).............................................................................19
Table of contents
RET615 1
Point List Manual
LD0.MAPGAPC4 Multipurpose analog protection
function (4).............................................................................19
LD0.MAPGAPC5 Multipurpose analog protection
function (5).............................................................................19
LD0.MAPGAPC6 Multipurpose analog protection
function (6).............................................................................19
LD0.XRGGIO130 Alarm and warning....................................20
LD0.PHPTOV3 Phase overvoltage protection - stage 3........20
LD0.PHPTOV2 Phase overvoltage protection - stage 2........20
LD0.PHPTOV1 Phase overvoltage protection - stage 1........20
LD0.PHPTUV3 Phase undervoltage protection - stage
3.............................................................................................21
LD0.PHPTUV2 Phase undervoltage protection - stage
2.............................................................................................21
LD0.PHPTUV1 Phase undervoltage protection - stage
1.............................................................................................21
LD0.ROVPTOV1 Residual overvoltage protection -
stage 1....................................................................................21
LD0.ROVPTOV2 Residual overvoltage protection -
stage 2....................................................................................22
LD0.ROVPTOV3 Residual overvoltage protection -
stage 3....................................................................................22
LD0.XGGIO130 Physical binary I/O signals (status
only)........................................................................................22
LD0.XGGIO120 Physical binary I/O signals (status
only)........................................................................................22
LD0.XGGIO110 Physical binary I/O signals (status
only)........................................................................................23
LD0.XGGIO100 Physical binary I/O signals (status
only)........................................................................................23
LD0.MDSOPT1 Generic operation time supervision..............23
LD0.ARCSARC1 Fault arc protection - stage 1.....................24
LD0.ARCSARC2 Fault arc protection - stage 2.....................24
LD0.ARCSARC3 Fault arc protection - stage 3.....................24
LD0.EFLPTOC1 Non-directional earth-fault and
sensitive earth-fault protection - low stage 1..........................24
LD0.EFLPTOC2 Non-directional earth-fault and
sensitive earth-fault protection - low stage 2..........................25
LD0.PHIPTOC2 Phase overcurrent protection -
instantaneous stage 2 ...........................................................25
LD0.PHIPTOC1 Phase overcurrent protection -
instantaneous stage 1 ...........................................................25
LD0.PHHPTOC2 Phase overcurrent protection - high
stage 2 ...................................................................................25
LD0.PHHPTOC1 Phase overcurrent protection - high
stage 1....................................................................................26
Table of contents
2RET615
Point List Manual
LD0.PHLPTOC1 Phase overcurrent protection - low
stage 1....................................................................................26
LD0.PHLPTOC2 Phase overcurrent protection - low
stage 2....................................................................................26
LD0.T2PTTR1 Thermal overload protection (2).....................26
LD0.LREFPDIF1 Low-impedance restricted earth-fault
protection (1)..........................................................................27
LD0.HREFPDIF1 High-impedance restricted earth-fault
protection (1)..........................................................................27
LD0.TR2PDIF1 Transformer differential protection................27
LD0.CMMXU1 Phase currents (1) limit supervision...............27
LD0.RESCMMXU1 Residual current (1) limit
supervision.............................................................................27
LD0.CMMXU2 Phase currents (2) limit supervision...............28
LD0.RESCMMXU2 Residual current (2) limit
supervision.............................................................................28
CTRL.Cxxxxx1 Circuit breaker (1) CB object and failure
protection................................................................................28
LD0.SSCBR1 Circuit breaker (1) condition monitoring..........29
CTRL.DCXSWI1 Disconnector (1) - controllable object.........29
CTRL.DCXSWI2 Disconnector (2) - controllable object.........30
CTRL.ESXSWI1 Earth switch - controllable object................30
CTRL.DCSXSWI1 Disconnector (1) - non-controllable
object......................................................................................30
CTRL.DCSXSWI2 Disconnector (2) - non-controllable
object......................................................................................31
CTRL.DCSXSWI3 Disconnector (3) - non-controllable
object......................................................................................31
CTRL.ESSXSWI1 Earth switch (1) - non-controllable
object......................................................................................31
CTRL.ESSXSWI2 Earth switch (2) - non-controllable
object......................................................................................31
LD0.LEDGGIO1 LHMI LED indications..................................31
Class 2 data measurands............................................................32
Class 2 private measurand data (6 and 7) for RET615..........33
Section 3 Interoperability profile for 615 series IEC
60870-5-103...................................................................37
Physical layer...................................................................................37
Electrical interface.......................................................................37
Optical interface...........................................................................37
Transmission speed....................................................................37
Link layer..........................................................................................37
Application layer...............................................................................38
Transmission mode for application data......................................38
Table of contents
RET615 3
Point List Manual
COMMON ADDRESS of ASDU..................................................38
Selection of standard information numbers in monitor
direction.......................................................................................38
System functions in monitor directions...................................38
Status indications in monitor direction....................................38
Supervision indications in monitor direction...........................39
Earth fault indications in monitor direction..............................39
Fault indications in monitor direction......................................39
Auto-reclosure indications in monitor direction.......................40
Measurands in monitor direction............................................41
Generic functions in monitor direction....................................41
Selection of standard information numbers in control
direction.......................................................................................41
System functions in control direction......................................41
Generic functions in monitor direction....................................41
Basic application functions..........................................................42
Miscellaneous..............................................................................42
Section 4 Glossary.........................................................................43
Table of contents
4RET615
Point List Manual
Altri manuali per Relion 615 series
41
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali ABB Trasformatore
ABB
ABB RELION RET670 Manuale utente
ABB
ABB TDO 6 Manuale elenco delle parti
ABB
ABB AT41 Manuale elenco delle parti
ABB
ABB Relion 670 series Guida rapida
ABB
ABB VT Guard Pro Manuale elenco delle parti
ABB
ABB ELK-CT0 Series Manuale elenco delle parti
ABB
ABB Relion 620 Series Manuale utente
ABB
ABB FLM 1000 Manuale utente
ABB
ABB RET 541 Manuale utente
ABB
ABB KOKM Series Manuale elenco delle parti
