Abus TVAC10070 Manuale utente

TVAC10070

User manual

Version 05/2018

Original English user manual. Keep for future use.

Introduction

Dear Customer,

Thank you for purchasing this product.

This device complies with the requirements of the applicable EU directives.

The declaration of conformity can be ordered from:

ABUS Security-Center GmbH & Co. KG

Linker Kreuthweg 5

86444 Affing

GERMANY

To maintain this condition and to ensure risk-free operation, you as the user must observe these

operation instructions!

Before initial start-up, read through the complete operating instructions observing operating and safety

instructions.

All company and product names mentioned in this document are registered trademarks.

If you have any questions, please contact your installer or your local dealer!

Disclaimer

This user manual was prepared with greatest care. If you should notice omissions or inaccuracies,

please inform us about these on the back of this manual given address.

The ABUS Security-Center GmbH assumes no liability for technical and typographical faults and

reserves the right to make at any time modifications to the product or user manual without a previous

announcement.

The company is not liable or responsible for direct and indirect subsequent damages which are

caused in connection with the equipment, the performance and the use of this product.

No guarantee for the content of this document is taken.

Icon explanation

A flash in the triangle is used if there is danger for the health, e.g. by an electric shock.

An exclamation mark in the triangle points to an important note in this user manual

which must be minded.

This symbol can be found when you are to be given tips and information on operation.

Important safety advice

The warranty will expire for damage due to non-compliance with these operating

instructions. ABUS will not be liable for any consequential loss!

ABUS will not accept liability for damage to property or personal injury caused by

incorrect handling or non-compliance with the safety-instructions.

In such cases the warranty will expire.

The device has been manufactured in compliance with international safety standards. Please read

these safety advices carefully.

Safety advice

1. Mains supply

Operate this product only from the type of power supply indicated on the marking label. If you are

not sure of the type of power supplied to your home, consult your local power company.

Disconnect the product from the mains before you start any maintenance or installation

procedures.

2. Overloading

Do not overload a wall outlet, extension cord or adapter as this may result in electric fire or shock.

3. Liquids

Setup the device only in dry and dust-protected rooms. Protect the device from any kind of liquids

entering.

4. Cleaning

Disconnect the product from the wall outlet before cleaning. Use a light damp cloth (no solvents)

to dust the product.

5. Ventilation

The slots on top of the product must be left uncovered to allow proper airflow into the unit. Do not

stand the product on soft furnishings or carpets. Do not stack electronic equipment on top of the

product.

6. Accessories

Do not use any unsupported accessories as these may be hazardous or cause damage the

product.

7. Location

 Setup the device only in dry and dust-protected rooms.

 Protect the device from any kind of liquids entering.

 Do not place the device near a radiator or heat register.

 Setup the device only in areas with the advised operating temperatures of -10° ~ +40°C.

Warnings

Follow all safety and operating advises before starting-up the device!

1. Follow these directions in order to avoid damage of the power cord or plug:

 Do not modify or process the power cord or plug arbitrarily.

 Do not bend or twist the power cord.

 Make sure to disconnect the power cord holding the plug.

 Keep heating appliances as far as possible from the power cord in order to prevent the

cover vinyl from melting.

2. Follow these directions. Failure to follow any of them may cause electrical shock:

 Do not open the main body or the power supply.

 Do not insert metal or inflammable objects inside the product.

 In order to avoid any damage during lighting use a surge protection.

3. Do not use the product when it is out of order. If you continue to use the product when defective,

serious damage can be caused to it. Make sure to contact your local product distributor if the

product is out of order.

LCD Screen

 Heavy pressure can destroy the LCD screen.

 Using the system in a cold environment can cause display errors. This is not a malfunction

and the LCD screen will work normal again when the environment temperature increases.

 Despite high standards of quality during manufacture, black or light spots could appear on the

screen in places, possibly for a long time. Such spots are normal with LED screens and do not

mean there is a malfunction. Furthermore, after switching off, a distorted picture may still be

seen for several seconds afterwards.

During the installation into an existing video surveillance system make sure that all devices

are disconnected from the low and supply voltage circuit.

If in doubt allow a professional electrician to mount, install and wire-up your device.

Improper electrical connection to the mains does not only represent at threat to you but

also to other persons.

Wire-up the entire system making sure that the mains and low voltage circuit remain

separated and cannot come into contact with each other in normal use or due to any

malfunctioning.

Unpacking

While you are unpacking the device please handle it with utmost care.

If you notice any damage of the original packaging, please check at first the device.

If the device shows damages, please contact your local dealer.

Table of contents

1. Intended use ................................................................................................................................ 6

2. Scope of delivery ........................................................................................................................ 6

3. Features and functions ............................................................................................................. 6

4. Physical descriptions ................................................................................................................ 7

5. Mounting ....................................................................................................................................... 8

5.1 Power supply ............................................................................................................................ 8

5.2 Ventilation .................................................................................................................................. 8

5.3 Wall Mount ................................................................................................................................. 8

6. Button description ..................................................................................................................... 9

7. Selecting the input signal ....................................................................................................... 10

8. On-screen menu ....................................................................................................................... 11

8.1 Picture ....................................................................................................................................... 12

8.2 Position .................................................................................................................................... 12

8.3 Color .......................................................................................................................................... 13

8.4 OSD ............................................................................................................................................ 13

8.5 Setup ......................................................................................................................................... 14

8.6 Misc. .......................................................................................................................................... 14

9. Maintenance and cleaning ..................................................................................................... 15

9.1 Maintenance ............................................................................................................................ 15

9.2 Cleaning ................................................................................................................................... 15

10. Disposal .................................................................................................................................. 15

1. Intended use

The 28” LED monitor displays UHD / Full HD 1080p / HD+ 960p pictures in 16:9 formats. Thanks to its

different connections it can be connected flexibly to ABUS DVR, NVR and computers at the same

time. Integrated loudspeaker and audio outputs also allow soundtracks to be played.

To fix it to a wall or ceiling, VESA standard mounts can be used.

A detailed description of all functions can be found in chapter „3 Features and functions“.

2. Scope of delivery

Monitor

Power supply unit incl. EU

and UK cold device cable

HDMI cable

3. Features and functions

 Higher contrast and improved color display thanks to LED backlighting

 Suitable for continuous operation

 Easy to install on the wall or ceiling with VESA standard mounts

(VESA 100 x 100 mm)

 Versatile connection options

 Low energy consumption due to energy saving LED display

4. Physical descriptions

1 Power supply DC 12 V / 5 A,

Only use the power supply unit provided for operating the monitor!

2 HDMI input 1 HDMI input v2.0

3 HDMI input 2 HDMI input v2.0

4 Display Port 1 (DP1) Display Port v1.2 Input

5 Display Port 2 (DP2) Display Port v1.2 Input

6 Audio out 3.5 mm jack, audio signal output

5. Mounting

5.1 Power supply

Before starting installation, ensure that the power supply voltage and the rated voltage on the

power supply unit are identical.

5.2 Ventilation

Please provide sufficient ventilation. The cooling openings may not be covered for sufficient

ventilation.

5.3 Wall Mount

For mounting the monitor at a wall please use a VESA compatible wall mount. At the backside of

the monitor there are squarely arranged assembly holes (Middle distance 75 mm). These are

compatible with the ABUS TVAC10500 wall mount.

Please also pay attention to the installation manual of the wall mount.

During the mounting of the TFT monitor it must be separated from the mains voltage.

6. Button description

Button Description

SOURCE

Select one of the different input signals:

 HDMI Port 1 or 2

 Display Port 1 or 2

End / Back in the OSD menu

MENU  Show the OSD (on-screen display)

 Enter a menu in the OSD

 Decrease the volume during operation

 Decrease the value in the OSD

 Increase the volume during operation

 In the menu: switch between main menu items

 Switches monitor on or off

7. Selecting the input signal

To select the input signal, press the SOURCE button.

The selected input will be displayed on the upper of the screen.

Press the ▲▼- buttons repeatedly until you reach the required input and confirm the entry with the

MENU - button.

You have the choice of HDMI 1 or 2 and DP 1 or DP 2.

Indice

Manuali Monitor popolari di altre marche

Linear Acoustic

Linear Acoustic LQ-1000 Manuale utente

AOC

AOC I2579V Manuale utente

Gateway

Gateway FPD1520 Manuale utente

Furuno

Furuno Mu 120c Manuale utente

Asus

Asus VB171D - 17" LCD Monitor Manuale utente

Dell

Dell S2230MX Istruzioni utente

Philips

Philips 107C64 Manuale utente

Dell

Dell S2409WFP Manuale utente

EverFocus

EverFocus EN-7517E Manuale utente

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manuale utente

Dell

Dell Precision 7680 Manuale di istruzioni

LG 50PM1M - - 50" Plasma Panel Manuale utente

Bosch

Bosch DDU 9 Manuale utente

Acer

Acer A231HL Manuale utente

Philips

Philips 86BDL4152T Manuale utente

NEC

NEC AccuSync LCD5V Manuale utente

Emay

Emay SleepO2 Manuale utente

IBM

IBM 6360 Istruzioni per l'installazione