Technical Information Ƹ
Function Introduction for Combination Button
1. Energy-Saving Function
In cooling mode, pressTEMP and CLOCK buttons simultaneously to start up or turn-off the energy-savings function.
When energy savings function is started, SE will be shown on the remote controller display. The air conditioner will adjust
the set temperature automatically.
NOTE:
• The fan speed will default to an auto speed that cannot be adjusted.
• The set temperature also cannot be adjusted. This will render the turbo function inoperable.
• The sleep function and energy saving function cannot operate at the same time. If one of these functions is set and
the user attempts to set the other, the previous function will be cancelled.
2. 8ºC/46ºF Heating Function.
In heating mode, press theTEMP and CLOCK buttons simultaneously to start or turn off the 8ºC/46ºF heating function.
When this operation starts, and 8ºC/46ºF will be shown on the remote controller and the air conditioner will keep the
heating status at 8ºC/46ºF.
NOTE:
• While this function is operating, the fan speed will default to an auto speed that cannot be adjusted.
• The set temperature also cannot be adjusted. This will render the turbo function inoperable.
• The sleep function and energy saving function cannot operate at the same time. If one of these functions is set and
the user attempts to set the other, the previous function will be cancelled.
3. Child Lock Function
Press Sor Tsimultaneously to turn on/off the child lock function. When this function is on, icon is displayed on the
remote controller. If you operate the remote controller, the icon will blink 3 times without sending a symbol to the
unit.
4. Temperature display switchover function
While powered OFF, press Tand MODE buttons simultaneously to switch the temperature display between Celsius and
Fahrenheit.
5. I FEEL Function
Pressing Sand MODE buttons simultaneously to start I FEEL function and will be displayed on the remote
controller. The remote controller will send the ambient temperature to the unit. This will cause the unit to adjust and set
the airflow accordingly in order to maximize energy savings while providing maximum comfort.
• Do not place remote controller near an object of high or low temperature. This will prevent the controller from
detecting an inaccurate ambient temperature. Make sure the remote controller stays within the area in which the unit
can continuously receive its signal.
Operation Guide
1. Press ON/OFF button on the remote controller to turn on the air conditioner.
2. Press MODE button to select the desired operation: AUTO, COOL, DRY, FAN, HEAT.
3. Press Sand Tbutton to set your desired temperature. (Temperature cannot be adjusted in AUTO mode).
4. Press FAN button to set the desired fan speed: AUTO, LOW, MEDIUM and HIGH.
5. Press SWING button to select fan blowing angle.
signal sender EDWWHU\
&RYHURIEDWWHU\ER[
UHPRYH
reinstall
Replacement of Batteries in Remote Controller
1. Press the back side of remote controller marked with , as shown in the figure on the
right, and then push out the cover of the battery box.
2. Replace the two AAA batteries with fresh AAA batteries, making sure to position them
on the correct polar sides “+” and “-“.
3. Reinstall the cover of the battery box.
NOTE:
• Aim the signal sending end (top) of the remote controller at the unit to operate.
• Distance between the unit and the remote controller should be no more than 20 feet and there should be no
obstacles in between them.
• Remote controller signal may be interfered in the present of fluorescent lighting or wireless telephones.
• Replace batteries when remote control signal is weak or when display becomes fuzzy or difficult to read.
• Remove batteries during prolonged periods of time where the controller will not be used.
