ACSI HAGER 45CE Manuale utente
YELLOW
GREEN
SWITCH SLIDER
FAIL SECURE
ELECTRIC TRIM CONTROL INSTRUCTIONS
MOTOR-CONTROLLED ELECTRIC LOCKING/UNLOCKING
Electrical Specifications:
Voltage: 12-24V AC/DC (11V - 30V)
Current: 250mA MAX Inrush, 10mA MAX Holding
Non-polarized Leads
1560 - Fail Safe (Power Lock):
Outside trim is locked when power is applied and unlocked when power is removed.
Trim control will unlock in the event of a power failure.
1570 - Fail Secure (Power Unlock):
Outside trim is unlocked when power is applied and locked when power is removed.
Trim control will lock in the event of a power failure.
Key Function:
The outside trim may be momentarily unlocked with a
key even though the trim control is electrically locked.
Switch Slider Settings:
Yellow: Fail Secure
Green: Fail Safe
Note: Power must be applied to the trim control after a switch slider setting change.
HAGER 45CE
FAIL SAFE
2-Conductor Wire Run
Distance
12V/24V
Wire Gauge
125'/250'
22
200'/400'
20
300'/600'
18
500'/1000'
16
750'/1500'
14
1250'/2500'
12
2720 CLARK AVE. ~ ST. LOUIS, MO 63103 ~ 1-800-753-5558 ~ www.acsi-inc.com
II-E1500-45
REV. 01/2019
1/2"
RHR
HANDING
1/2"
LHR
HANDING
3-5/8"
11/16" 11/16"
TRIM CONTROL
SIDE OF DOOR
MECHANISM CASE
TRIM CONTROL
WIRING
EXIT DEVICE HARNESS
BASEPLATE ASSEMBLY
TY-WRAP
MOUNT
Door Preparation:
This door preparation is in addition to the door
1.
preparation shown for an electric exit device
(see document E-1500-19).
Drill and deburr a
1/2" hole through the door
2.
for wire routing from the electric trim control to
the exit device head.
Installation:
These instructions are in addition to the
1.
manufacturer's installation instructions for the
exit device and cylinder escutcheon trim.
Install the supplied exit device harness along
2.
the side of the baseplate assembly with the
connector end located in the exit device
head and the wire lead end secured to the
inside of the mechanism case near the end of
the device using the supplied ty-wrap mount
and ty-wrap.
Route the wiring from the electric trim control
3.
through the door preparation hole into the
exit device head and mate the connectors.
Connect the wire leads of the exit device
4.
harness to the power transfer device.
Verify the operation of the electric trim control
5.
and that all wiring is not interfering with the
operation of both devices.
2720 CLARK AVE. ~ ST. LOUIS, MO 63103 ~ 1-800-753-5558 ~ www.acsi-inc.com
II-E1500-45
REV. 01/2019
Altri manuali ACSI Serratura
