Adaptec 2100S - SCSI RAID Controller Manuale utente

Adaptec RAID

Installation Guide

reproduced, stored in a retrieval system, or transmitted in any form or by any means,

electronic, mechanical, photocopying, recording or otherwise, without the prior

written consent of Adaptec, Inc., 691 South Milpitas Blvd., Milpitas, CA 95035.

Trademarks

Adaptec and the Adaptec logo are trademarks of Adaptec, Inc., which may be

registered in some jurisdictions. Windows 95, Windows 98, Windows NT,

Windows Me, and Windows 2000 are trademarks of Microsoft Corporation in the US

and other countries, used under license.

All other trademarks are the property of their respective owners.

Changes

The material in this document is for information only and is subject to change

without notice. While reasonable efforts have been made in the preparation of this

document to assure its accuracy, Adaptec, Inc. assumes no liability resulting from

errors or omissions in this document, or from the use of the information contained

herein.

Adaptec reserves the right to make changes in the product design without reservation

and without notification to its users.

Disclaimer

IF THIS PRODUCT DIRECTS YOU TO COPY MATERIALS, YOU MUST HAVE

PERMISSION FROM THE COPYRIGHT OWNER OF THE MATERIALS TO AVOID

VIOLATING THE LAW WHICH COULD RESULT IN DAMAGES OR OTHER

REMEDIES.

iii

Regulatory Compliance Statements

Federal Communications Commission Radio Frequency Interference Statement

WARNING: Changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy, and if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. However, if this equipment

does cause interference to radio or television equipment reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between equipment and receiver.

• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/television technician for help.

• Use a shielded and properly grounded I/O cable and power cable to ensure compliance of this unit to the

specified limits of the rules.

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference and (2) this device must accept any

interference received, including interference that may cause undesired operation.

European Union Compliance Statement

This Information Technology Equipment has been tested and found to comply with the

following European directives:

EMC Directive 89/336/EEC, as amended by 92/31/EEC and 93/68/EEC

EN 50081-1 (1992)

EN55022 (1994) Class B

EN 50082-1 (1992)

EN61000-4-2 (1998)

EN61000-4-3 (1998)

EN61000-4-4 (1995)

EN61000-4-5 (1995) Surges

Australian/New Zealand Compliance Statement

This device has been tested and found to comply with the limits for a Class B digital

device, pursuant to the Australian/New Zealand standard AS/NZS 3548 set out by the

Spectrum Management Agency.

Adaptec, Inc.

ATA RAID 2400A

Tested to Comply

With FCC Standards

FOR HOME OR OFFICE USE

SCSI RAID 2100S/3200S/3210S/3400S/3410S

Canadian Compliance Statement

This Class B digital apparatus meets all requirements of the Canadian Interference-

Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le

matérial brouilleur du Canada.

Japanese Compliance (Voluntary Control Council Initiative)

Contents

1 Introduction

Read this First 1-2

System Requirements 1-2

Storage Requirements for Drivers and Software 1-2

Motherboard Compatibility 1-3

Kit Contents 1-3

Adaptec RAID Controller Features 1-4

Adaptec RAID Features – SCSI Only 1-5

About the Documentation 1-6

Using the Adaptec RAID Installation CD 1-6

Files and Folders 1-8

Product Documentation on CD 1-9

Errata and Release Notes 1-9

Installing the Adobe Acrobat Reader 1-10

Overview of the Installation Process 1-11

Cache Memory Module 1-12

Storage Management Software Overview 1-13

Safety Information 1-14

Notes, Cautions, and Warnings 1-14

Electrostatic Discharge 1-15

2 Installing Your Controller

Configuring ATA Drives 2-1

ATA Drives 2-1

ATA Cables 2-2

Configuring SCSI Devices 2-2

Narrow and Wide SCSI Devices 2-2

LVD and SE Devices 2-3

SCSI Cables 2-3

SCSI Device IDs 2-3

SCSI Termination 2-4

Adaptec RAID Installation Guide

Installing Additional Cache Memory 2-6

Seating the Module – Adaptec 3200S/3400S Only 2-6

Seating the Module – Adaptec 2400A/2100S/3210S/3410S

Only 2-7

Finishing up – All Models 2-7

Installing the Battery Backup Module 2-8

Installing the Controller 2-8

Determining the Booting Controller 2-9

Controller IRQ and Address 2-9

Using SMOR 2-10

3 Installing the Driver

Windows 2000 3-2

Installing the Driver in a New System 3-2

Adding the Controller to an Existing System 3-3

Upgrading Windows NT to Windows 2000 3-4

Windows NT 4.0 3-5

Installing the Driver in a New System with Only One

Controller 3-6

Installing the Driver in a New System with Other

Hardware 3-7

Upgrading the Controller in an Existing System 3-8

Changing the Driver in an Existing System 3-9

Windows95,Windows98,andWindowsMe 3-11

Installing the Driver in a New Windows 98/Me

System 3-12

Installing the Driver in a New System with Windows 95

(OEM SR2 – Version 95B) 3-14

Adding the Controller to an Existing Windows 95/98/

Me System 3-16

Upgrading Windows 95 to Windows 98/Me (Upgrade

Version) 3-18

Novell NetWare 3-18

Installing the Driver for a Boot Controller in a New

NetWare 4.11 Server 3-19

Installing the Driver in a Existing NetWare 4.11

Server 3-20

vii

Contents

Installing the Driver for a Boot Controller in a New

NetWare 4.2 Server 3-21

Installing the Driver in an Existing NetWare 4.2

Server 3-23

Installing the Driver for a Boot Controller in a New

NetWare 5 Server 3-24

Installing the Driver in an Existing NetWare 5

Server 3-25

SCO UNIX 3-26

Installing the Driver in a New OpenDesktop 3.x

System 3-26

Installing the Driver in a New OpenServer 5.0x

System 3-27

Adding the Controller to an Existing OpenDesktop 3.x

or OpenServer 5.x System 3-27

Adding the Controller to an Existing UnixWare 7

System 3-28

FreeBSD 3-29

Linux 3-30

Installing the Driver in a New Linux System 3-30

Installing the Driver in an Existing Linux System 3-32

4 Installing Storage Management Software

System Requirements 4-2

Installing Storage Manager Pro 4-2

Operating System Compatibility 4-2

Installation Prerequisites 4-3

Windows 4-3

NetWare 4.11 and 4.2 4-4

NetWare 5.x 4-6

Red Hat Linux and FreeBSD 4-7

Installing Storage Manager 4-8

Operating System Compatibility 4-8

Windows 4-8

NetWare 4-9

SCO UNIX 4-10

SCO UnixWare 7 4-10

FreeBSD 4-10

Linux 4-11

viii

Adaptec RAID Installation Guide

A Card and Module Diagrams

Adaptec ATA RAID 2400A A-2

Adaptec SCSI RAID 2100S A-3

Adaptec SCSI RAID 3200S A-4

Adaptec SCSI RAID 3400S A-5

Adaptec SCSI RAID 3210S/3410S A-6

Adaptec Battery Backup Module A-8

B Controller LEDs

LED During Power-up B-2

LEDs During Controller Idle B-2

LEDs During Controller Active B-2

Cache Status LEDs B-3

Cache Status LEDs –

Adaptec 2400A/3200S/3400S Only B-3

Cache Status LED – Adaptec 3210S/3410S Only B-4

SCSI Bus Status LEDs B-4

SCSI Bus Status LEDs – Adaptec 3200S/3400S Only B-4

SCSI Bus Status LEDs – Adaptec 3210S Only B-4

SCSI Bus Status LEDs – Adaptec 3410S Only B-5

C Troubleshooting

D Controller Reset Procedures

NVRAM Reset D-2

Flash Mode 0 D-2

E Specifications

1-1

Introduction

In this Chapter

➤ Read this First 1-2

➤ System Requirements 1-2

➤ Kit Contents 1-3

➤ Adaptec RAID Controller Features 1-4

➤ About the Documentation 1-6

➤ Using the Adaptec RAID Installation CD 1-6

➤ Installing the Adobe Acrobat Reader 1-10

➤ Overview of the Installation Process 1-11

➤ Cache Memory Module 1-12

➤ Storage Management Software Overview 1-13

➤ Safety Information 1-15

1-2

Adaptec RAID Installation Guide

Read this First

Before you begin installing your new Adaptec RAID controller, read

this chapter. This chapter is an important guide to the rest of the

documentation and provides a summary of the installation process.

System Requirements

The following system requirements are discussed:

■Storage requirements for drivers and software

■Motherboard compatibility

■ATA requirements – Adaptec 2400A only

■

SCSI requirements –

Adaptec 2100S/3200S/3210S/3400S/3410S only

Storage Requirements for Drivers and Software

Adaptec Storage Management software and device drivers require

approximately 4 MB of disk space. The host system should have

64 MB of memory, and a Pentium processor that is at least as fast as

200 MHz. A mouse and SVGA color monitor are also required.

Adaptec Storage Manager Pro requires 40 MB of available disk space

for installation. The host system should have 64 MB of memory, a

Pentium processor (200 MHz or faster), and a video adapter capable

of 800 ×600 resolution with 256 colors.

Altri manuali per 2100S - SCSI RAID Controller

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Adaptec Hardware per computer

Adaptec

Adaptec AUA-3100LP Manuale

Adaptec

Adaptec 2410SA - Serial ATA RAID Controller Manuale utente

Adaptec

Adaptec RAID 5405Z Manuale utente

Adaptec

Adaptec RAID 51245 Come usare

Adaptec

Adaptec M3093GX Manuale operativo e di manutenzione

Adaptec

Adaptec 1220SA - RAID Controller Manuale utente

Adaptec

Adaptec 2100S - SCSI RAID Controller Manuale utente

Adaptec

Adaptec CDP-00277-01-A Manuale utente

Adaptec

Adaptec 1200A Manuale utente

Adaptec

Adaptec 2940U2W - Storage Controller U2W SCSI 80... Manuale utente

Adaptec

Adaptec RAID 5085 Manuale utente

Adaptec

Adaptec ASR-3085 Manuale operativo

Adaptec

Adaptec AHA-1520 Manuale utente

Adaptec

Adaptec AHA-2940 - SCSI Card Manuale utente

Adaptec

Adaptec AAA-130SA SERIES Istruzioni di montaggio

Adaptec

Adaptec AAA-130U2 SERIES Istruzioni di montaggio

Adaptec

Adaptec 2100S - SCSI RAID Controller Guida di sicurezza

Adaptec

Adaptec PM3332UW Manuale utente

Adaptec

Adaptec ASR-3085 Manuale operativo

Adaptec

Adaptec 2045 Manuale utente

Adaptec

Adaptec RAID 6805Q Manuale utente

Adaptec

Adaptec Ultra Wireless AWN-8030 Manuale utente

Adaptec

Adaptec 2045 Manuale utente

Adaptec

Adaptec 9110G Manuale utente

Manuali Hardware per computer popolari di altre marche

EMC2

EMC2 VNX Series Manuale del proprietario

Panasonic

Panasonic DV0PM20105 Manuale utente

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuale utente

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuale utente

Raidon

Raidon iT2300 Manuale utente

National Instruments

National Instruments PXI-8186 Manuale utente

Hauppauge

Hauppauge WinTV-HVR-2250 Manuale utente

Kontron

Kontron CP6002 Manuale utente

Manhattan

Manhattan 702843 Manuale utente

Aphex

Aphex 230 Manuale utente

AMD

AMD Phenom II Manuale operativo

Intel

Intel NUC 12 Pro Manuale utente

dbx

dbx Zone Pro 1260 Manuale utente

Galaxy

Galaxy GHDX2-2430S-24F4D Manuale utente

Intel

Intel AXXRMFBU4 Manuale utente

Kontron

Kontron DIMM-PC/MD Manuale utente

ST X-NUCLEO-SAFEA1B Istruzioni operative

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuale utente