ADEEPT AWR-A Manuale utente
01
02
03
04
05
Take out the plates we will use.
Take out the car acrylic plates,
peel off the films.
Peel off the protective film on
the two sides of the plates.
Car Assembly.
06
Take out two sets of motors (four motors one set),
pay attention not to break the wire connected to
the motor, handle gently.
First we take out the materials we need
according to the picture on the left:
1x set of motors
1x A01 acrylic plate
4x silver M3*30 screw
4x M3 nut
Pass two silver M3*30 screws from the
protruding surface through the fixing
hole of the motor.Note: First install the
motor welded with four wires.
Use the cross wrench to screw the
M3 nut onto the M3*30 screw.
Note that the screw can't be too tight.
If the M3 nut is tightened too much,
it will not be rotated after the motor
is energized.
Motor Part assembly.
07
On the left is an installation drawings
of one assembled set of motor.
Note: The M3*30 screw cap is on the
protruding face.
Assemble another part according to the above
method. Note that the motor needs to be installed
on the other side of the acrylic plate. Two sets of
motors are symmetrically mounted.
Use the cross wrench to fix two M3 nuts
to two M3*30 screws.Note that the screw
cannot be tightened too much.
Next pass two M3*30 screws through
the other motor.
08
Attach the 3-CH Tracking Module to A02 as shown
in the figure. Note that the direction of the 5Pin
wire interface is to the right. If it is to the left,
the car tracking function will not work properly.
Pass two black M2*10 screws through the
two holes as shown.
Screw two black M2 nuts onto the M2 screw.
Use the small screwdriver to tighten the screws.
Connect the 5Pin wire to the
3-CH Tracking Module.
Tracking Module assembly.
Materials needed to assemble
the tracking module:
1x A02 acrylic plate
1x 3-CH Tracking Module
2x black M2*10 screws
2x black M2 nut
1x 5Pin wire
09
Indice
Altri manuali ADEEPT Attrezzature didattiche
