AFe Power Advanced FLOW engineering Manuale utente

advanced FLOW engineering

Instruction Manual P/N: 77-46310

Make: BMW Model: M3/M4 (F80) Year: 2015-2018 Engine: L6-3.0L (tt) S55

Make: BMW Model: M4 (F82/F83) Year: 2015-2020 Engine: L6-3.0L (tt) S55

Make: BMW Model: M2 Competition (F87) Year: 2019-2020 Engine: L6-3.0L (tt) S55

Note: Includes M3 CS, M4 CS & GTS Models.

Label Qty. Description Part Number

A 1 Module R77-46310

B 1 LED Switch 05-70029

C 2 Velcro (2 Inches) 05-01244

D 4 Cable Ties 05-60167

Note: Legal in California for use on race vehicles only. The use of this device on vehicles used on public

streets or highways is strictly prohibited in California and others states that have adopted California

emission regulations.

• Please read the entire instruction manual before proceeding.

• Ensure all components listed are present.

• If you are missing any of the components, call customer support at 951-493-7100.

• Ensure you have all necessary tools before proceeding.

• Do not attempt to work on your vehicle when the engine is hot.

• Disconnect the negative battery terminal before proceeding.

• Retain factory parts for future use.

Page 2

aFepower.com

Page 3

Refer to Figure A for Step 1.

Step 1: Before installing your aFe module, you will have to place your vehicles ECU in sleep mode. In

order to do this you will need to do the following:

- If the engine is cold, open the hood, close the doors lock the car and wait 30 seconds.

- If the engine is warm, open the hood, close the doors lock the car and wait 20 minutes.

- If the engine is warm and you can’t wait 20 minutes, disconnect the battery.

REMOVAL

Page 4

Figure A

Refer to Figure B for Steps 2-5.

Step 2: Locate the TMAP 1 and MAP sensors 2 . The TMAP sensor is located driver side on charge

pipe, the MAP sensor is located on top of the intake manifold, behind the charge-air cooler and

under the expansion tank.

Step 3: Remove the push clip on the driver side windshield cover. 3

Step 4: Unlock the three 10mm nuts retaining the windshield cover and remove. 4

Step 5: Remove the two T27 screws off the top expansion tank and pop off grommet.

REMOVAL

Page 5

4 4

aFepower.com

Figure B

Refer to Figure C for Steps 6-7.

Step 6: Pass the aFe module harness through frame brace.

Step 7: Pop off the trim seal of the frame brace to allow more space.

Figure C

Page 6

REMOVAL

Step 8: Disconnect the MAP sensor, by pressing down on the locking tab and sliding the connector out

of the sensor.

Step 9: Locate the MAP sensor jumper harness on the aFe module. This is the longer harness with 4

wires in the connectors. Plug the female connector of the module into the MAP sensor, then the

male connector of the module into the female connector of the engine harness.

Note: Make sure connections are fully engaged. Usually, connectors make a snapping

sound when fully engaged.

Refer to Figures D for Steps 8-9.

Figure D

Page 7

INSTALL

aFepower.com

Page 8

Refer to Figure E for Steps 10-11.

Step 10: Locate and disconnect the TMAP sensor, by pressing down on the locking tab and sliding the

connector out of the sensor.

Step 11: Locate the TMAP sensor jumper harness on the aFe module. This is the shorter harness

with 3 wires in the connectors. Plug the female connector of the module into the

TMAP sensor, then plug the male connector of the module into to the female connector of the

engine harness.

Figure E

INSTALL

aFepower.com

Page 9

Refer to Figure F for Steps 12-13.

Step 12: Carefully route the switch cable behind steering wheel cover.

Step 13: Mount the Switch on an open, ﬂat surface

Figure F

INSTALL

Page 10

Refer to Figure G for Steps 14-16.

Step 14: Remove the two 10mm nuts holding the foot trim panel.

Step 15: Route the switch cable through ﬁrewall and into the engine bay. Follow the main harness

through the grommet into the ﬁrewall. Plug the end of the cable to the module.

Step 16: Re-install foot trim panel.

Figure G

INSTALL

Altri manuali per advanced FLOW engineering

Altri manuali aFe Power Accessori per automobili

aFe Power

aFe Power advanced FLOW engineering Manuale utente

aFe Power

aFe Power 05-01016 Manuale utente

aFe Power

aFe Power 440-401006-N Manuale utente

aFe Power

aFe Power 77-42008 Manuale utente

aFe Power

aFe Power 56-70058D Manuale utente

aFe Power

aFe Power 77-43025 Manuale utente

aFe Power

aFe Power 50-70009S Manuale utente

aFe Power

aFe Power Momentum GT Manuale utente

aFe Power

aFe Power QUANTUM 53-10005D Manuale utente

aFe Power

aFe Power 52-10002D Manuale utente

aFe Power

aFe Power 54-13053D Manuale utente

aFe Power

aFe Power 51-82722 Manuale utente

aFe Power

aFe Power 77-86318 Manuale utente

aFe Power

aFe Power 54-12742 Manuale utente

aFe Power

aFe Power dfs780 Manuale utente

aFe Power

aFe Power Takeda 56-10005D Manuale utente

aFe Power

aFe Power 77-46306 Manuale utente

aFe Power

aFe Power Scorpion 79-21001L Manuale utente

aFe Power

aFe Power 52-10002D Manuale utente

aFe Power

aFe Power 77-83046 Manuale utente

aFe Power

aFe Power advanced FLO engineering Manuale utente

aFe Power

aFe Power Momentum hd Manuale utente

aFe Power

aFe Power 46-70270 Manuale utente

aFe Power

aFe Power 54-12208 Manuale utente

Manuali Accessori per automobili popolari di altre marche

James Baroud

James Baroud Odyssey Manuale utente

Motorola

Motorola i50sx Manuale utente

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuale utente

Feniex

Feniex T3 Manuale utente

Renault

Renault 77 11 423 180 Manuale utente

Kia

Kia E8300-4D000 Manuale utente

Brink

Brink 756843 Manuale utente

Whispbar

Whispbar K085W Manuale utente

v.link

v.link CI-VL2-PC-HSD Manuale utente

Viking

Viking Stack-Rack Guida rapida alla configurazione

Aries

Aries 203015 Manuale utente

Choetech

Choetech AT0005 Manuale utente

ZZ2

ZZ2 ZZAIR-PRO Manuale utente

Holman

Holman 4A80L Manuale utente

Thule

Thule 2075 Manuale utente

Motorola

Motorola T325 Manuale utente

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guida all'installazione

DV8

DV8 FBJL-02 Manuale utente