Arec MS-550 Manuale utente
Media Station
MS-550
ENGLISHQuick Installation Guide
AREC Inc.© All Rights Reserved 2016. l www.arec.com
All information contained in this document is Proprietary
(MS-350 series)
MS-550 Quick Installation Guide
FCC
Federal Communication Commission interference statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures: -Reorient or relocate the receiving antenna. -Increase the
separation between the equipment and receiver. -Connect the equipment into an outlet on a
circuit different from that to which the receiver is connected. -Consult the dealer or an
experienced radio/TV technician for help.
RF Exposure Warning
The equipment complies with RF exposure limits set forth for an uncontrolled environment. The
antenna(s) used for this transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
You are cautioned that changes or modifications not expressly approved by the party responsible
for compliance could void your authority to operate the equipment.
FCC Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may
cause undesired operation
This equipment should be installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
CE
Hereby, AREC Inc., declares that this Media Station is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
1
2
MS-550 Quick Installation Guide
CB
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
– the ventilation should not be impeded by covering the ventilation openings with items, such as
newspapers,table-cloths, curtains, etc.:
– no naked flame sources, such as lighted candles, should be placed on the apparatus;
– attention should be drawn to the environmental aspects of battery disposal;
– the use of apparatus in tropical climates.
the instructions for use shall state that the apparatus shall not be exposed to dripping or
splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.
MS-550 Quick Installation Guide
3
Introduction
Specifications
Package Contents
Featuring a compact and stand-alone design, AREC MS-550 Media Station consists of diverse
features and functionality, including multi-signals capturing, recording synchronously, codec,
streaming online, multi-channel split screen, live broadcasting, and web-based video switcher,
providing complete lecture capture solution.
Power AdapterAntenna Quick Installation GuideRemote Controller
AREC Media Station
Media Station
MS-550(MS-350 series)
354mm(L) x 188.2mm(W) x 46mm(H)
1320g
12V/2A
24W (Max.)
0ºC ~ 50ºC / 90%
Insert 2 IP CAM to LAN port and insert 2 video
signals (either HDMI or VGA input).Using
external USB flash to record the transcoded
video/audio. And output the transcoded video/
audio to both HDMI and VGA port.
Product Name
Model Name
Dimension
Weight
Power Requirement
Power Consumption (Max.)
Operating Temperature / Humidity
Maximum normal load description
MS-550 Quick Installation Guide
4
Product Appearance
Front
Back
1 62
710 13 15 1611
12
8 9 14 17
53
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Remote Control receiver
Led light
Function key
Select key:
Power
USB port
Power port
Video input source
Video output source
Audio input source
Audio output source
Hard drive port
Network port
Network port
Antenna keyhole
DIDO
Reset
NO. Name Brief introduction
Remote Control receiving area
Bluetooth/Record/Power
Record/Play/Pause/Stop/Menu/Channel/Preview Layout
Up/Down/Left/Right /Back/OK
Power on/ off devices
Export document by driving USB flash drive into USB port
/Firmware update through USB disk
12V/2A
VGA/HDMI cables input source
VGA/ HDMI cables output source
Line/Mic audio input source
Line audio output connect to amplifier
USB flash drive/eSATA hard drive
Connect to network
Network camera/Auto-Tracking Mount video input
Antennas for wireless microphone receivers
RS-232 Bidirectional control signal connector
Restoring devices to its factory default state
4
MS-550 Quick Installation Guide
5
Remote Controller
12
6
9
5
3
4
7
10
13
16
20
22
24
25
18
8
12 11
15 14
19
29
17
21
23
26
27
28
30
32 31
NO. Name Brief introduction
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
Power
Resolution
A/B/C/D
Prev Index
Info
Next Index
Previous
Play
Next
Record Layout
Pause
Snapshot
Record
Menu
Stop
Preview Layout
Aspect
Select:
Up/Down/Left/Right
OK
Back
Exit
Volume
Channel
0-9
Mute
P1
P2
P3
Reset
Patrol
Zoom in
Zoom out
Power on/ off devices
Adjust the output resolution
A：Export the storage device
B/C/D：User Define
Jump to previous index play
Display the channel information
Jump to next index play
Jump to previous course play
Start or resume video play
Jump to next course play
Switch record layout
Pause video play/Pause video recording
Take a screen shot and capture into photo
Start video recording
Go to main menu screen
Stop video play/Stop video recording and
exit
Switch preview layout
Switch individual channel to fill in pane
with different aspects
Navigate menu
Select and execute option
Cancel option/Return to previous view
Cancel all of setting and option
Change volume
Switch channel
1~6：Quickly switch record layout while
recording
Mute audio
Auto-Tracking Mount (TP-100)adjust
zoom in, zoom out and change vision
Auto-Tracking Mount (TP-100) adjust
zoom in, zoom out and change vision
Auto-Tracking Mount (TP-100) adjust
zoom in, zoom out and change vision
Auto-Tracking Mount (TP-100)
return to start position
Activate Auto-Tracking Mount
(TP-100) to patrol and to change
patrolling route.
Adjust Network Camera (CI-200) zoom in
Adjust Network Camera (CI-200) zoom out
MS-550 Quick Installation Guide
6
Connection
projectorTV
Local area network
document cam
microphone amplifier
Speaker
DVD player
Hard drive
Hard drive
AREC TP-100
Auto-Tracking System AREC
AM-500
Wireless
Microphone
AREC CI-200
Network Camera
Video input VGA / HDMI
Power
Video output VGA / HDMI Audio output
LAN
Wireless audio receiver
Digital I/O
Audio input
USB
USB
eSATA
LAN
p
2
3
4
5
6 7
89
10
11
6
1
7
MS-550 Quick Installation Guide
Connection
1
2
3
4
5
6
7
8
9
10
11
Power
Video input
Video output
Audio input
Audio output
Hard drive
Local area network (LAN)
Network camera input
Wireless audio receiver
DIDO
Export USB hard drive.
Power connection
Video input for VGA or HDMI cables.
For example: Connected to notebook or document cam.
Video output for VGA or HDMI cables.
For example: Connected to projector or TV.
Audio input for Line or Mic.
For example: Connected to amplifier or microphone.
Audio output for Line or Mic.
For example: Connected to amplifier or Speaker
USB flash drive or eSATA hard drive for storage.
Connected to LAN for remote system management or
Internet video streaming.
Connected to Auto-Tracking Mount (TP-100) or
Network Camera (CI-200).
Antennas receive audio of wireless microphone (AM-500).
Connected to RS-232 device for input and output command.
Driving USB flash drive into USB port to export document or
update firmware.
NO. Name Brief introduction
MS-550 Quick Installation Guide
Product setup
Initial installation
Get IP address from About option in Setup item of the host output interface main menu and
input it in the Browser page
Step 1：Log in System Administration with default user ID admin and password admin.
Step 2：Set up time of host machine by selecting settings in time tab in System Information.
Step 3：Set up name / video source/tracking source/tracking mode by selecting + icon in
image sensor in sensor setup tab. The image capturing source is video in 1 and 2
with option VGA or HDMI. If only one of the latter isconnected, the system would
detect and auto switch to source of signal.
Note：Factory default output display: input channel 1 full screen, input source: HDMI image of
host input terminal video in 1.
2
8
1 2
3
Ini
tia
l i
nst
all
ati
o
n
G
et IP address
f
rom About option in Setup item o
f
the host output inter
f
ace main menu and
i
nput
i
t
i
n t
h
e Browser pa
ge
S
tep
1
：
L
o
g
in
Sy
stem Administration
wi
th
def
aul
t
use
r
ID
adm
in
and password
adm
in
.
S
te
p 2
：
S
et up time of host machine b
y
selectin
g
settin
g
s in
tim
e
ta
b i
n
Sy
stem Informat
ion
.
2
3
1
3
AREC MS-550
MS-550 Quick Installation Guide
9
Step 4：Click Discovery and Refresh to auto scan web cam and auto tracking cloud connected
to host.
Step 5：Connect to devices Status of refreshed or added device displays symbol " ? ". Click
web cam and auto tracking cloud and the device setup page displays. Enter
Administrator and Password to change devicestatus, press OK to save your changes
and exit.
You may click Add button to manual add web cam and auto tracking cloud by input specific IP
or MAC address.
1 2
1 2
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Arec Lettore multimediale
