Asus WL-600g Manuale utente

Rev1.0

ASUS Wireless ADSL Router Internet Configuration Guide

Introduction:

This document describes how to set up ASUS wireless ADSL router such as WL-600g,

WL-AM604g and DSL-N13 to getting connection to the Internet and provides troubleshooting

tips to help you fix some simple problems.

STEP1: Connecting the wireless router

The figure below illustrates a connection diagram example.

STEP2: Getting to know your Internet connection type

The router supports following connection types: PPPoA(PPP over ATM), PPPoE(PPP over

Ethernet), MER(MAC Encapsulation Routing), IPoA(IP overATM), Bridging.

Please inquire your ISP what the type you use and the VPI/VCI value.

9Some DSL-based ISPs use PPPoA (Point-to-Point Protocol over ATM) to establish

Internet connections. In this type, you must have User Name and Password from ISP

supply. In addition, if your ISP supply you a permanent, fixed (static) IP address to

your computer, please also fill in it to router.

9Most of DSL-based ISPs use PPPoE (Point-to-Point Protocol over Ethernet) to

establish Internet connections, select “PPPOE”. If you are connected to the Internet

through a DSL line, check with your ISP to see if they use PPPoE. In this type, you

must have User Name and Password from ISP supply. In addition, if your ISP supply

you a permanent, fixed (static) IP address to your computer, please also fill in it to

router.

9MER (MAC Encapsulation Routing) has two ways to get IP address: static IP or

Rev1.0

obtain an IP address automatically. Enter information provided by your ISP to

configure the WAN IP settings.

9Some DSL-based ISPs use IPoA (IP over ATM) to establish Internet connections, in

this type, ISP will give you a permanent, fixed (static) IP address. Some ISP need

special requirement, such as gateway, please require from ISP and fill in the router.

9If you are using your Gateway as a bridge, which makes the Gateway act like a

stand-alone modem, select “Bridging”

The installation technician from your ISP should have left the setup information for the modem

with you after installing your broadband connection. If not, you can call your ISP to request that

data.

STEP3: Configuring the router

1. Enter into router’s Web-based configuration page

a) Open browser and type router’s IP address: http://192.168.1.1 (the default address)

b) Input username and password, both of them: admin (the default value)

c) By default, the Quick Setup page pops up. The Quick Setup Wizard automatically

detects yourADSL connection type. Please wait a minute.

d) If ADSL connection is detected, the page shows your ISP connection type. Then click

information that need, the following is PPPOE example, for your reference. For the

other circumstances (PPPOA, MER, IPOA, Bridging), please refer to manual for

details.

e) Input your username and password then click Next.

Rev1.0

f) Setup wireless SSID and Security Level, and then click Next. For establishing

wireless connection, you need a 802.11b/g compatible WLAN card. Refer to your

wireless adaptor user’s manual for wireless connection procedures. By default, the

SSID is set to “Default”, security level is Low (no encryption)

Note: SSID is a unique identifier which emulates a password when a WLAN device

attempts to communicate with the ADSL router.

Rev1.0

g) The summary page then shows up. If the information displayed is correct, click

Save/Reboot to finish the setup.

Rev1.0

2. If your ADSL connection is not detected or your actual connection is not as detected one,

please click Manual Setting.

a) Select your Country and ISP and click Next. If your country and ISP are not on the

list, select Not List, key in your VPI and VCI values. Most of ISPs use encapsulation

mode “LLC”, click Next. In this case, you can refer to the table below or contact your

ISP for VPI/VCI values.

ISP VPI/VCI Connection Type Encapsulation Mode Username format example

Bigpond 8/35 PPPoE LLC

username@bigpond

username@bigpond.com

username@bigpond.net.au

username@direct.telstra.net

Optus 8/35 PPPoE LLC username@optusnet.net.au

AAPT 8/35 PPPoE LLC [email protected]et.au

iiNet 8/35 PPPoE LLC

Enter username and your

password.

iPrimus 8/35 PPPoE LLC

Enter username and your

password.

PPPoE LLC

TPG 8/35

IPoA LLC

Enter IP address, Subnet Mask,

Gateway and DNS as instructed

by TPG.

PPPoE LLC

Enter username and your

password.

OzEmail 8/35

PPPoA VC/MUX

PPPoE LLC

Enter your username and your

password.

PPPoA VC/MUX

Internode 8/35

IPoA LLC

Enter IP address, Subnet Mask,

Gateway and DNS as instructed

by Internode.

Dodo 8/35 PPPoE LLC [email protected]u

iHug 8/35 PPPoE LLC

Enter username and your

password.

PPPoE LLC usernam[email protected] Pacific

Internet

8/35

PPPoA VC/MUX [email protected]cific.net.au

Xtra - New

Zealand

0/100 PPPoA VC/MUX

Rev1.0

And here, we use Optus for the example.

i. Fill in the VPI and VCI, click “Next”.

ii. Choose PPPoE for Connection Type and LLC for Encapsulation Mode, click

“Next”

Rev1.0

iii. Fill in the username and password which ISP provided, click “Next”.

b) Refer to manual for following setup details.

Troubleshooting Tips:

Here are some tips for correcting simple problems you may have.

If your PC cannot connect Internet through the router, please check with this sequence:

1) Check if the phone line is securely connected.

2) Check if VCI/VPI value is correct. If ADSL connection is established, the ADSL light

should lit as green

3) Check if WAN configuration and each parameter are correct.

Altri manuali per WL-600g

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Asus Router di rete

Manuali Router di rete popolari di altre marche

Allnet

Allnet ALL0333AU Manuale utente

HomeSeer

HomeSeer HT-SEL Manuale utente

Sercomm

Sercomm Genesis OC3505D Manuale utente

Billion

Billion BIPAC 5102 Series Manuale utente

TP-Link

TP-Link TD-8817 Manuale utente

Motorola

Motorola MR1900 Manuale utente

Digi

Digi IX14 Manuale utente

Cisco

Cisco NCS 540 Manuale

XAVi

XAVi X8821e Manuale utente

BEC

BEC 6200WZL Manuale utente

MikroTik

MikroTik hAP ac3 Series Manuale utente

Korenix

Korenix JetNet 5428G Series Manuale utente

NETGEAR

NETGEAR FS526T - Switch Manuale utente

Korenix

Korenix JetNet 5710G Series Manuale utente

Automated Logic

Automated Logic ZN551 Manuale del proprietario

Cisco

Cisco ASR 1000 Series Manuale dell'operatore

EnGenius

EnGenius ESR-9710 Manuale utente

Cisco

Cisco 805 Series Istruzioni operative e di sicurezza