3
ASSEMBLY (refer to figure 4 on page 4)
1.Threadtheconnectingblock(#12)tomiddle rod (#6),
then secure to base (#3) with M10 nut and washer
(#21 & 22).
2. Secure top cover (#4) and two holding arms (#14) to
base (#3) with M6x25 bolts, washers & nuts (#15,
16 & 17).
3.Attach wheel axle (#5) to base (#3) with M12x40 bolts
& nuts (#23 & 24).
4.Attach wheels (#18) and washers(#19) to wheel axle
(#5), then secure with cotter pins (#20).
5. Secure the axle links (#5A) of wheel axle (#5) to
connecting block (#12) with M12 bolts and washers
(#13 & 19).
6.Attach hookbracket(#9)totop cover (#4) and secure
with lock pin (#11).
7.Attach angle adjustable wheel (#7) to middlerod(#6)
with set screw (#8).
8.Attachhandle(#1)totopcover(#4)withlockpin(#2).
9. Insert handle grip (#10) to handle (#1).
OPERATION
1.Preparethebrakedrumorbrakedrum/hub assembly
for removal according to the instructions in vehicle
servicemanual.
2. Place drum handler in a horizontal position.
3.Turn theangleadjustable wheeluntilthe drumhandler
is in its lowest postion.
4. Position the handler under the drum until the holding
arms meet the outer surface of the drum.
5. Turn the angle adjustable wheel clockwise until the
handlermeetsthe lower surface of the drum.
6. Lower the handle to slightly lift the drum. Pull the
handler and drum back, away from the brake
assembly.
7. Forremoving/installingdrumonly:
Flipthe hook bracketintothehub openingofthedrum
as shown in figure 2.
For removing/installingdrumandhubasanassembly:
Position the hook bracket reverse as shown in figure
3 to allow a wheel nut to secure hook to drum/hub
assembly.
8. It may be necessary to adjust the hook. Remove the
hooklockpin,andmovethehookbrackettoanyone
offour hole locations.
9. Pull the drum completely away from the brake
assembly.Slowlyandcarefullyliftthehandleto place
thedrumface down onthefloor,being cautiousofthe
transferof loadweight.
Note:ReversetheprocesstoInstall thebrakedrumback
to the brake assembly. Be sure to align the drum with
thestudsand followtheinstructionsinthevehicle service
manual.
MAINTENANCE
Periodically inspect the drum handler. Ensure all parts
movefreely.Ifrust appears,sandaffected areaandcover
with suitable utility paint. When not in use, store drum
handler in upright position and in a clean, dry area.
REPLACEMENT PARTS (see page 4)
Available Parts: Pleaserefertotheparts drawing when
ordering parts. Not all components of the brake drum
handler are replacement items, but are illustrated as a
convenient reference of location and position in the
assembly sequence. When ordering parts, give model
number,serial numberandparts description.Callor write
forcurrent pricing:
ATDToolsInc.160EnterpriseDrive,Wentzville,MO63385
U.S.A. Tel:(636)327-9050 Fax:(636)327-9044
HookPosition
(fordrum only)
Figure2 - Illustration for removing/installing drum
BrakeDrum
HoldingArms
HookPosition
(fordrum/hubassy.)
Drum/HubAssy.
Figure3-Illustrationforremoving/installing drum/hub
assembly
HoldingArms
