Atop A-B15 Manuale utente
www.atop-team.com
A-B15 Assembled Manual
(Kevlar polyester wire lace)
V.1
1
2. Thread the wire lace into the
in the order of hole 1→ hole 2→ hole 3
reel holes
1. Thread the wire lace into the
of the base
holes
Hole 3
Groove
Hole 2
Hole 1
Hole 3
Hole 2
Hole 1
3. Tighten the wire lace to be fixed it
~1.Press the end of lace and tighten the wire lace which between hole 3 and hole 2.
~2.Take the end of wire lace across the middle part of wire lace, then conceal from the first wire lace
(See figure B).Pull wire lace outward from hole 1, and keep1mm distance away from the hole 1,
and cut the rest of wire lace. (See figure C)
~3.Pull tightly outward from hole 1 and make sure the wire lace is out of the central of circle
(See figure D),please check it is in accurate location.(See figure E)
~4.Repeat the above steps to fasten the other side of wire lace.(See figure F)
(See figure A)
Make sure the wire lace is
out of the central of circle.
Press the wire lace at
this point by your finger.
The central of circle
groove
(figure A) (figure B) (figure C)
(figure E) (figure F)(figure D)
2
~1.Under the knob has a hexagonal
hole which has to aim at the
hexagonal cylinder of base,and
inset the knob into the base.
3
3
1
2
Hexagonal
copper
cylinder
7. Fix the knob
~1.Setting the torque wrench on 2.5 kg,
and fasten the screw.Please must make
sure the screw is fastened in vertically.
~1.Tighten the wire lace in clockwise.
~2.Release the wire lace in anticlockwise.
~3.Pull out the wire lace inside the base.
~Repeat the above steps three times,as you
tighten and release the wire lace which runs
smoothly,thenit is assembled well.
8. Testing
4. Put the reel into
the base 6. Inset the knob
5. Inset the ratch
~1.Put the ratch's breach to
aim at the bulge of the
base.
~1.Pull the lace toward
and put the reel into the base.
outside
breach of ratch
bulge of base
Indice
Altri manuali Atop Attrezzature da laboratorio
Manuali Attrezzature da laboratorio popolari di altre marche
Agilent Technologies
Agilent Technologies 5800 ICP-OES Manuale utente
Endress+Hauser
Endress+Hauser Cleanfit CPA875 Manuale utente
NI
NI PXI-5422 Manuale
Collomix
Collomix Aqix Manuale utente
SPEX SamplePrep
SPEX SamplePrep 6875 Freezer/Mill Series Manuale utente
Ocean Insight
Ocean Insight FLAME-NIR+ Manuale utente
