AudioCodes RXV81 Manuale utente

AudioCodes RXV81 Collaboration Bar

Quick Guide

1. Introduction

Thank you for purchasing AudioCodes AudioCodes RXV81 Collaboration Bar!

The RXV81 offers an integrated camera with an adjustable lens angle for optimal viewing, six beamforming

microphone arrays that provide a pickup range of 14.7 feet (4.5 meters), and a robust 10W speaker.

2. Package Contents

Make sure you've received the following items in the shipped box:

✓RXV81 Collaboration Bar

✓Power Adapter

✓USB Type-C cable

✓Wall mount and screws

✓HDMI Cable

✓Controller. Depending on your purchase, your RXV81 includes one of the following controllers:

oRC-RXV Remote Control and batteries (when purchasing TEAMS-RXV81)

oRX-PAD Meeting Room Controller (when purchasing TEAMS-RXV81-B10)

3. Positioning

You can wall mount the RXV81 or

placed it on top of the display (not

supplied but can be ordered

separately). Designed for small-to-

mid-size rooms, it's recommended

to position the RXV81 below the

display and approximately 4 inches

(10 cm) above the table.

You can adjust the camera's wide-angle horizontal field of view, which spans 110 degrees,

allowing for precise fine-tuning of its vertical position as well.

P a g e | 2

4. Mounting RXV81

The following procedures describes how to mount RXV81 on a wall or on top of the display.

Wall-mounting RXV81:

For optimal placement, it's recommended to mount the RXV81 on the wall.

1. Attach wall-mounting bracket

to the bottom of RXV81, using

the D-Ring Hinged screw

(supplied).

2. Mount the hook bracket (with

hooks facing upward)

centered under the display,

ensuring that it's at least

4 inches (10 cm) above table

height, with the three screws

and anchors (supplied). An

additional screw and anchor

have been included for your

convenience.

3. Securely mount the RXV81 by

hanging the wall-mounting

bracket onto the hook

bracket. Make sure that it's

firmly attached.

P a g e | 3

Mounting RXV81 on display:

The RXV81 can be mounted on top of the display using a camera clip bracket (purchased separately).

1. Attach the camera clip

bracket to the bottom of

RXV81, using the D-Ring

Hinged screw (supplied).

2. Open the camera clip bracket

and place it on top of the

display. Make sure that it's

firmly attached.

To avoid any accidents, if you need to move the display, always remove RXV81 first to prevent

it from falling off the display. In addition, refrain from pushing RXV81 from the back to the

front as it may dislodge. Please make sure proper precautions are taken to maintain safety.

P a g e | 4

5. Cabling

The RXV81 connector ports are located on its rear panel, as shown below:

L-R

Description

Use the supplied HDMI Out cable to connect this port to a display (standalone mode).

Applies to RXV81 as a standalone device (default). Video and sharing are presented on the

display. Meetings are controlled via the RC-RXV and/or RX-PAD.

Power on / Reset button.

To restart RXV81, press and hold for at least 2 seconds.

Not applicable

USB type-A port to connect to touch-capable room display.

Ethernet LAN GbE port to connect RJ-45 terminals.

USB type-C to connect to a Bring-Your-Own-Device (BYOD) computer running a Unified

Communication (UC) client for ad hoc or full peripheral mode.

12V-3A

DC power input port for the 12V power supply adapter.

6. Connecting RXV81 as a USB Peripheral

You can connect RXV81 to a peripheral to Bring-Your-Own-Device (BYOD) computer running a UC client for

ad hoc or full peripheral mode. In peripheral mode, the BYOD displays the meeting video and content.

Meetings are controlled via the BYOD (join, accept, manage participants). Audio/video (camera ePTZ, mic

mute) can be controlled from the UC client, RC-RXV, and/or RX-PAD (camera on / off, mute, volume).

For RX-PAD Meeting Room Controller:

Make sure that the RX-PAD and RXV81 are connected to the same network.

For Wi-Fi connectivity, make sure that RX-PAD is powered by the supplied AC/DC power adaptor.

P a g e | 5

7. RC-RXV Smart Bluetooth Remote Control

The functionality of the RC-RXV remote control is described below:

Press to switch on, or long press for at least 2 seconds to restart the

RXV81.

Press to return to the Teams app.

Press to switch the camera on or off, or long press to open Camera

Settings.

Press or to move the camera or the selection.

Press OK to confirm a selection. After zooming in or out, press OK to restore

the default view.

Press to return to the home page.

Press + to initially connect the RC-RXV to RXV81.

Press to return to the previous menu or to quit.

Press to open Device Settings.

Press + or –to increase or decrease the volume, respectively.

Press to turn the microphone on or off (mute).

Press to answer a call.

Press to end a call.

Press to put a call on hold.

8. Management

RXV81 (as a standalone or a USB audio/video peripheral device) is fully managed by AudioCodes Device

Manager.

Management includes (but is not limited to):

✓Monitoring

✓Firmware upgrades

✓Alarm management (e.g., if remote control is missing or reaches a low battery level)

✓Upgrade RXV81 on Android

P a g e | 6

9. Pairing RC-RXV Remote Control with RXV81

The following procedure describes how to pair the RC-RXV remote control with your RXV81.

To pair RX-PAD with RXV81, please see RX-PAD Meeting Room Controller Pairing Guide.

To pair RC-RXV remote control with RXV81:

1. Insert batteries (supplied) into RC-RXV; the following message appears on the display:

Remote is not connected.

while holding the remote near the RXV81, press and

hold the specified buttons below.

2. Press and hold + buttons on the RC-RXV until its successfully paired with RXV81, as indicated by

the following message on the display:

Remote connection between RC-RXV and RXV81

established successfully.

P a g e | 7

10. Viewing Status on RXV81

RXV81 provides LEDs on its front panel, which indicate various operating status information.

LED 1

Camera Status

Camera is on.

Off

Camera is off.

LED 2

General Status

White on

RXV81 is powered on and signed into Teams.

White flashing

RXV81 is booting up.

Red on

RXV81 has been muted (highest priority).

Red flashing

✓RXV81 has lost network connectivity.

✓RXV81 is being upgraded.

✓RXV81 has lost connectivity with the RC-RXV.

White flashing

RXV81 is powered on and connected to the network but isn't signed into Teams.

LED 3

Call Status

Blue on

In a call (active call or meeting).

Blue flashing

Incoming call (i.e., ringing).

11. Technical Specifications

For RXV81 technicalspecifications,refertotheRXV81 Datasheet.

   

LED 1

LED 2

LED 3

International Headquarters

1 Hayarden Street,

Airport City

Lod 7019900, Israel

Tel: +972-3-976-4000

Fax: +972-3-976-4040

AudioCodes Inc.

80 Kingsbridge Rd

Piscataway, NJ 08854, USA

Tel: +1-732-469-0880

Fax: +1-732-469-2298

Website: https://www.audiocodes.com/

Mediant, MediaPack, What’s Inside Matters, OSN, SmartTAP, User Management Pack, VMAS, VoIPerfect,

VoIPerfectHD, Your Gateway To VoIP, 3GX, VocaNom, AudioCodes One Voice, AudioCodes Meeting

Insights and AudioCodes Room Experience are trademarks or registered trademarks of AudioCodes

Limited. All other products or trademarks are property of their respective owners. Product specifications

are subject to change without notice.

FCC Warning

Prior to operating RX-PAD and AudioCodes devices for Teams Rooms on Android, refer to

the regulatory information documents.

Notice Information

Information contained in this document is believed to be accurate and reliable at the time of printing.

However, due to ongoing product improvements and revisions, AudioCodes cannot guarantee accuracy

of printed material after the Date Published nor can it accept responsibility for errors or omissions.

Updates to this document can be downloaded from https://www.audiocodes.com/library/technical-

documents.

This document is subject to change without notice.

Date Published: August-20-2023

Altri manuali per RXV81

Indice

Altri manuali AudioCodes Telecamera IP

AudioCodes

AudioCodes RXVCam50 Manuale utente

Manuali Telecamera IP popolari di altre marche

FLIR

FLIR Exx series Manuale utente

Avigilon

Avigilon H4A-BO1-IR Manuale utente

Digital Watchdog

Digital Watchdog DWCA-C128-64 Manuale utente

ShareTech

ShareTech AV1 Manuale utente

Ezviz

Ezviz C6C Manuale utente

Melchioni

Melchioni UCAM 2015 Manuale utente

Geutebruck

Geutebruck G-Cam/ESD-4630 Manuale utente

Arecont Vision

Arecont Vision MegaBall AV3146DN-3310-D-LG Manuale utente

Mitel

Mitel 6800i Series Manuale di servizio

Vitek

Vitek VTC-IR403-212NP Manuale utente

THOMSON

THOMSON DSC - 323W Manuale utente

AVer

AVer FB2027 Manuale utente

ENFORCER

ENFORCER EV-T5105-N2SQ Manuale utente

Wansview

Wansview NC543 Manuale utente

Eneo

Eneo MCB-64A0003M0A Manuale utente

deView electronics

deView electronics CBDNI36F Manuale utente

Swann

Swann SwannEye Manuale utente

LevelOne

LevelOne IP CamSecure Manuale utente