en/TA-11-ALM-6040/10040FL pag.: 6
USER /
INSTALATION
MANUAL
4-POST HD ISSUED 26-05-04
ALM-6040FL
ALM-10040FL
AUTEC Hefbruggen bv
Industrieterrein IJsselveld, Vlasakker 11, 3417 XT MONTFOORT, The Netherlands
T
el: +31 348 477000 Fax: +31 348 475104 Internet: www.autec.nl - E-mail: [email protected]2SAFETY PRECAUTIONS
2.1 Safety Notice
GFOR YOUR SAFETY, READ THIS MANUAL AND THE SAFETY PRECAUTIONS THOROUGHLY
BEFORE OPERATING THE LIFT.
GTHE LIFT IS INTENDED FOR USE BY PROPERLY TRAINED PERSONNEL ONLY. THE
SAFETY MESSAGES PRESENTED IN THIS MANUAL ARE INTENDED AS REMINDERS TO
TRAINED OPERATORS TO EXERCISE CARE WHEN USING THE UNIT.
2.2 General
The lift is supplied in a safe condition. In order to keep it in a safe condition and to ensure safe
operation of the Equipment, the operating and maintenance instructions contained in this manual
must be followed and the safety warnings & cautions must be observed.
2.3 General Warnings
General Warnings, giving instructions for the prevention of injury to people, are given in the following list.
Further specific warnings are printed where applicable before the appropriate subject.
GBEFORE USING THE LIFT, MAKE SURE THAT THE MAINS POWER SUPPLY CABLE IS
CONNECTED TO A MAINS POWER SUPPLY OUTLET OF THE CORRECT VOLTAGE WITH A
PROTECTIVE EARTH CONTACT. (REFER SERIAL NUMBER PLATE ON THE UNIT FOR MAINS
POWER REQUIRMENTS). VOLTAGES HIGHER THAN SPECIFIED CAN DAMAGE THE UNIT
AND MAKE IT UNSAFE.
G
THE USE OF MAINS POWER SUPPLY EXTENSION CABLES IS NOT RECOMMENDED.
IF ONE HAS TO BE USED, IT SHOULD HAVE CONDUCTORS WITH A DIAMETER OF
AT LEAST 1.5 mm. AND A PROTECTIVE EARTH CONTACT.
GONLY USE FUSES WITH THE FUSE RATING INDICATED NEAR THE FUSE HOLDER.
THE USE OF INCORRECTLY RATED FUSES CAN DAMAGE THE UNIT OR THE POWER CABLE
AND MAKE THESE ITEMS UNSAFE.
GDO NOT OPERATE THE UNIT BEFORE CONTACTING THE SERVICE CENTRE OF THE
MANUFACTURER/SUPPLIER, WHEN THE UNIT:
=SHOWS VISIBLE DAMAGE.
=FAILS TO OPERATE.
=HAS BEEN SUBJECTED TO PROLONGED STORAGE UNDER UNFAVOURABLE CONDITIONS
=HAS BEEN SUBJECTED TO SEVERE TRANSPORTATION STRESSES.
IT IS POSSIBLE THAT THESE CONDITIONS CAN MAKE THE UNIT UNSAFE.
GONLY USE THE LIFT IF YOU ARE QUALIFIED TO WORK WITH IT.
GKEEP PERSONS AND ANIMALS AWAY FROM THE LIFT WHILST IN OPERATION.
GENSURE THAT THE VEHICLE CANNOT MOVE DURING LIFTING. ALWAYS SET THE GEAR
SELECTOR IN NEUTRAL, SET THE PARKING BRAKE AND PLACE WHEEL CHOCKS IN FRONT
AND AT THE REAR OF THE DRIVE WHEELS BEFORE LIFTING A VEHICLE.
