Genie Z-60/34 Manuale utente
Operator’s Manual
Z-60 34
Seventh Edition
First Printing
Part No. 133083
Serial Number Range
after 00000
with
Maintenance
Information
CE
Operator's Manual
Z-60/34 Part No.133083
Seventh Edition • First Printing
Important
Read, understand and obey these safety rules and
operating instructions before operating this machine.
Only trained and authorized personnel shall be
permitted to operate this machine. This manual should
be considered a permanent part of your machine and
should remain with the machine at all times. If you have
any questions, call Genie Industries.
Contents
Page
Introduction ................................................................ 1
Symbol and Hazard Pictorial Definitions..................... 3
GeneralSafety ........................................................... 5
Personal Safety ......................................................... 8
Work Area Safety....................................................... 9
Legend ...................................................................... 17
Controls .................................................................... 18
Inspections ............................................................... 25
OperatingInstructions ............................................... 36
Transport and Lifting Instructions .............................. 46
Maintenance ............................................................. 49
Specifications ........................................................... 53
Contact us:
Internet:www.genielift.com
E-mail:[email protected]
Copyright © 1993 by Genie Industries
First Edition: First Printing, February 1993
Second Edition: Third Printing, September 1996
Third Edition: Sixth Printing, November 2001
Fourth Edition: First Printing, July 2002
Fifth Edition: Second Printing, August 2004
Sixth Edition: Second Printing, June 2006
Seventh Edition: First Printing, December 2007
"Genie" and "Z" are registered trademarks of
Genie Industries in the U.S.A. and many other
countries.
Printed on recycled paper
Printed in U.S.A.
Operator's ManualSeventh Edition · First Printing
Part No.133083 Z-60/34 1
Introduction
Danger
Failure to obey the instructions and
safety rules in this manual will result
in death or serious injury.
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
Know and understand the safety rules
before going on to the next section.
2 Always perform a pre-operation inspection.
3 Always perform function tests prior to use.
4 Inspect the workplace.
5 Only use the machine as it was intended.
You read, understand and obey the
manufacturer's instructions and safety rules—
safety and operator's manuals and machine
decals.
You read, understand and obey employer's
safety rules and worksite regulations.
You read, understand and obey all applicable
governmental regulations.
You are properly trained to safely operate the
machine.
Owners, Users and Operators:
Genie appreciates your choice of our machine for
your application. Our number one priority is user
safety, which is best achieved by our joint efforts.
We feel that you make a major contribution to
safety if you, as the equipment users and
operators:
1 Comply with employer, job site and
governmental rules.
2 Read, understand and follow the instructions
in this and other manuals supplied with this
machine.
3 Use good safe work practices in a
commonsense way.
4 Only have trained/certified operators,
directed by informed and knowledgeable
supervision, running the machine.
If there is anything in this manual that is not clear
or which you believe should be added, please
contact us.
Internet: www.genielift.com
E-mail: [email protected]
Operator's Manual Seventh Edition · First Printing
2 Z-60/34 Part No.133083
Intended Use
This machine is intended to be used only to lift
personnel, along with their tools and materials to
an aerial work site.
Introduction
Safety Sign Maintenance
Replace any missing or damaged safety signs.
Keep operator safety in mind at all times. Use mild
soap and water to clean safety signs. Do not use
solvent-based cleaners because they may damage
the safety sign material.
Hazard Classification
Genie uses symbols, color coding and signal
words to identify the following:
Safety alert symbol—used to alert
you to potential personal injury
hazards. Obey all safety
messages that follow this symbol
to avoid possible injury or death.
Indicates a hazardous situation
which, if not avoided, will result in
death or serious injury.
Indicates a hazardous situation
which, if not avoided, could result
in death or serious injury.
Indicates a hazardous situation
which, if not avoided, could result
in minor or moderate injury.
Indicates a hazardous situation
which, if not avoided, could result
in property damage.
Red
Orange
Yellow
Blue
Operator's ManualSeventh Edition · First Printing
Part No.133083 Z-60/34 3
Symbol and Hazard Pictorials Definitions
CrushHazard Explosion Hazard Fire Hazard ExplosionHazard Electrocution
Hazard
FallHazard Crush Hazard Tip-overHazard Tip-over Hazard Tip-overHazard
Tip-overHazard Tip-over Hazard Electrocution
Hazard
Maintainrequired
clearance.
Readthe
operator’s
manual.
Keep off this
surface.
Keep away from
moving parts.
Keep away from
path of moving
platform.
No smoking.
No flame.
Stopengine.
Do not use ether
or other high
energystarting
aids on machines
equippedwith
glow plugs.
Read service
manual
Ratedplatform
capacity
Platform uphill:
1 Lower primary
2 Lower secondary
3 Retract primary
Platformdownhill:
1 Retract primary
2 Lower secondary
3 Lower primary
3
3
Recovery procedure if tilt alarm sounds
whileelevated.
Onlytrained
maintenance
personnelshould
access
compartments
Operator's Manual Seventh Edition · First Printing
4 Z-60/34 Part No.133083
Symbol and Hazard Pictorials Definitions
Lanyard
attachment point
Wheelload Voltage rating for
power to platform
Pressure rating for
air line to platform
Avoid contact. Tie-down
instructions
Tie-down
instructions
Fireextinguisher
Weight of welder
reduces capacity
Windspeed
Turntable lock can
shear.
Keep away from
moving parts.
Collisionhazard Keep away from
moving parts.
Tirepressure
Operator's ManualSeventh Edition · First Printing
Part No.133083 Z-60/34 5
General Safety
Safety signs and locations
Operator's Manual Seventh Edition · First Printing
6 Z-60/34 Part No.133083
General Safety
Safety signs and locations
Operator's ManualSeventh Edition · First Printing
Part No.133083 Z-60/34 7
General Safety
Safety signs and locations
Operator's Manual Seventh Edition · First Printing
8 Z-60/34 Part No.133083
Personal Safety
Fall Protection
Personal fall protection equipment (PFPE) is
required when operating this machine.
Occupants must wear a safety belt or harness in
accordance with governmental regulations. Attach
the lanyard to the anchor provided in the platform.
Operators must comply with employer, job site and
governmental rules regarding the use of personal
protective equipment.
All PFPE must comply with applicable
governmental regulations, and must be inspected
and used in accordance with the PFPE
manufacturer’s instructions.
Altri manuali per Z-60/34
2
Indice
Altri manuali Genie Sistema di sollevamento
Genie
Genie TMZ-50/30 Manuale utente
Genie
Genie S-40 TRAX Manuale utente
Genie
Genie S-100 Manuale di installazione e funzionamento
Genie
Genie Lift Guard GR-15 Manuale utente
Genie
Genie S-65 Manuale di installazione e funzionamento
Genie
Genie AWP Super Series 114002 Manuale utente
Genie
Genie GS-2669 RT Manuale utente
Genie
Genie GTH-4013 SX Manuale utente
Genie
Genie DPL Super Series Manuale utente
Genie
Genie GTH-1544 Manuale di installazione e funzionamento
Genie
Genie Z-34/22 Manuale utente
Genie
Genie Z-45/25 Manuale utente
Genie
Genie Z-25/8 Manuale utente
Genie
Genie GTH-636 Manuale di installazione e funzionamento
Genie
Genie CE Series Manuale utente
Genie
Genie GC-1530 Manuale utente
Genie
Genie Runabout GR-8 Manuale utente
Genie
Genie gS-1530/32 Manuale utente
Genie
Genie GS-2668 RT Manuale utente
Genie
Genie Z-45/25 Manuale utente
Manuali Sistema di sollevamento popolari di altre marche
Screen Technics
Screen Technics INTERFIT Vertical Up Lift Manuale utente
Mortuary Lift
Mortuary Lift ULTIMATE 1000 Manuale utente
Custom Equipment
Custom Equipment Hy-Brid 3 Series Manuale di programmazione
Custom Equipment
Custom Equipment Hy-Brid Lifts 2 Series Manuale di programmazione
Hy-Brid Lifts
Hy-Brid Lifts HB-P3.6 Manuale di programmazione
BERG
BERG BeNomic EasyLeaf Manuale utente
