AvaLAN AW58EMVAP Manuale utente
USER’S MANUAL
Industrial-grade, long-range wireless Ethernet systems
AW58EMVAP
AW584EMVSU
Wireless Forecourt Access Point and
Wireless Wireless In-Dispenser Unit
with Network Switch
AW58EMVAP | AW584EMVSU User’s Manual
PAGE 2
Technical Support (650) 384-0000 www.avalan.com
© by AvaLAN Wireless Systems Inc. All rights reserved.
Revision 05.10.2018
127 Jetplex Circle
Suite A
Madison, AL 35758
Phone: (650) 384-0000
Fax: (650) 249-3591
READ THIS MANUAL BEFORE YOU BEGIN
Dispensers have both electricity and a hazardous, ammable and potentially explosive liquid. Failure
to follow the below precautions and the Warning and Caution instructions in this manual may result
in serious injury. Follow all rules, codes and laws that apply to your area and installation.
SAFETY PRECAUTIONS - INSTALLATION AND MAINTENANCE
Always make sure ALL power to the dispenser is turned OFF before you open the dispenser cabinet
for maintenance. Physically lock, restrict access to, or tag the circuit breakers you turn off when
servicing the dispenser. Be sure to trip (close) the emergency valve(s) under the dispenser BEFORE
beginning maintenance.
Make sure that you know how to turn OFF power to the dispenser and submersible pumps in an
emergency. Have all leaks or defects repaired immediately.
HOW TO CONTACT AVALAN WIRELESS
Problems with the installation of this kit should be referred to AvaLAN Technical Support:
(650)384-0000.
INDICATORS AND NOTATIONS
Danger indicates a hazard or unsafe practice which, if not avoided, will result in severe injury
or possibly death.
Warning indicates a hazard or unsafe practice which, if not avoided, may result in severe
injury or possibly death.
Caution indicates a hazard or unsafe practice which, if not avoided, may result in minor injury.
NOTE: Important information to consider, otherwise, improper installation and/or damage to
components may occur.
AW58EMVAP | AW584EMVSU User’s Manual
PAGE 3
Technical Support (650) 384-0000 www.avalan.com
PRODUCT.................................................................................. 4
INTRODUCTION ........................................................................... 4
HOW TO USE THIS DOCUMENT ......................................................... 4
UNPACKING AND INSPECTION........................................................... 5
RETURNING DAMAGED COMPONENTS ................................................. 6
SAFETY INFORMATION ................................................................... 7
INSTALLATION LOCATION................................................................ 8
CONFORMITY AND STANDARDS ......................................................... 9
REQUIRED TOOLS......................................................................... 9
REQUIRED PARTS ......................................................................... 9
INSTALLATION OVERVIEW ..............................................................10
INSTALLATION PROCEDURE ............................................................11
Shutdown the Site ..............................................................11
AW584EMVSU Installation......................................................11
Wall Mounting ...................................................................11
Connecting to the Ethernet Ports ............................................11
Site Startup......................................................................11
Table of Contents
AW58EMVAP | AW584EMVSU User’s Manual
PAGE 4
Technical Support (650) 384-0000 www.avalan.com
Product Information
Product AvaLAN AW58EMVAP
Application 5 GHz Wireless Forecourt Access Point
Current Build Version 01
Hardware Platform AvaLAN Proprietary Hardware
How To Use This Document
By following the installation instructions and performing the steps in the sequence presented, you
will be assured of a successful install.
NOTE: This kit may require installation of several wiring and hardware assemblies. Any
installation or modication must comply with the requirements of the National Electrical Code
(NFPA 70), the Automotive and Marine Service Station Code (NFPA 30A) and any other applicable
codes.
NOTE: You must wear a static wrist strap, securely attached to an earth ground when handling
any circuit board, electronic component or assembly, or when reaching into the site controller or
dispenser computer enclosure. Do not use power tools.
Product AvaLAN AW584EMVSU
Application 5 GHz Wireless In-Dispenser Communications System
Current Build Version 01
Hardware Platform AvaLAN Proprietary Hardware
AW58EMVAP | AW584EMVSU User’s Manual
PAGE 5
Technical Support (650) 384-0000 www.avalan.com
Unpacking and Inspection
Complete the following steps:
1. Before opening any cartons, count the number of cartons and verify the carton count against the
supplied packing list.
2. Inspect the cartons for damage made during transit.
3. File claim information with the carrier on the bill of lading.
4. Retain cartons suspected of damage for future claim purposes.
NOTE: You must wear an anti-static wrist strap, PN 916962 or equivalent, when removing electronic
components from static packages. Attach the wrist strap securely to an earth grounding point to
prevent possible damage from static electricity.
5. Remove all equipment from the shipping cartons and carefully inspect for visible damage.
NOTE: Any damage should be brought to the attention of the carrier and claims made immediately.
Return all equipment to the respective cartons for protection until actual installation is made. Save
all cartons until it is certain that return shipments are not required.
Returning Damaged Components
Parts or components returned to the factory under warranty or for repair are subject to damage
if not packaged properly. Complete the following steps to return parts or components to the
production facility.
1. Place electronic components in an anti-static bag and in the original shipping cartons for return
shipment to the production facility.
NOTE: If original shipping cartons are not available use a sturdy cardboard container and suitable
packing materials such as anti-static polyethylene foam or bubble pack, to ensure the component is
rmly packed.
2. Include a Return Parts Tag with the defective component describing the particular problem with
the part.
3. Make sure adequate insurance is provided when returning parts to the factory.
WARNING
If the parts or components arrive at our factory in a damaged condition and it is determined
that the damage is a direct result of inadequate or improper packaging, the damage will
not be covered under the original warranty and the customer or distributor will be held
responsible for the cost of repairs necessary to correct or replace the damaged parts.
AW58EMVAP | AW584EMVSU User’s Manual
PAGE 6
Technical Support (650) 384-0000 www.avalan.com
Safety Information
Read NFPA 30A and NFPA 70 (U.S. Installations)
Before installing the equipment, the installer must read, understand and follow this manual, NFPA
30A, NFPA 70, and applicable federal, state and local codes and regulations. Failure to do so may
adversely affect the safe use and operation of the equipment.
CSA C22.1 (Canadian Installations)
For installation in Canada the installer must read and understand this manual, CSA C22.1
(Canadian Electrical Code) and applicable federal, provincial and local codes and regulations.
Emergency Power Cutoff
NFPA30A requires that an emergency power cutoff be installed. An emergency power cutoff is a
single control that removes AC power from all site fueling equipment and submersible pumps.
Make sure the control is accessible, labeled clearly, and installed away from dispensers. Make sure
all station employees know where the Emergency Power Cutoff is located and how to operate it.
Electrical Circuits
Some of the procedures in this manual involve removal and connection of components during
installation or service. Remove power from the distribution box before executing these procedures.
AW58EMVAP | AW584EMVSU User’s Manual
PAGE 7
Technical Support (650) 384-0000 www.avalan.com
Installation Location for Subscriber Units
Equipment may be installed in a variety of locations; all the cabinets and required wire-ways must
be located in an intrinsically safe enclosed space.
Ensure that all cabinets are located in an area that offers easy access for service, and free air space
for cooling 3” away from other equipment.
Environmental Requirements
Care should be taken to ensure that the temperature of the cabinets does not exceed the
operational ranges of -40°C to 70°C (-40°F to 158°F).
Power Requirements
The DC power source to the AW584EMVSU device must have an input voltage of 24VDC.
Installation Location for Access Point
XXXXX
Environmental Requirements
Care should be taken to ensure that the temperature does not exceed the operational
ranges of -40°C to 70°C (-40°F to 158°F).
Power Requirements
The DC power source to the AW58EMVAP device must have an input voltage of 24VDC.
AW58EMVAP | AW584EMVSU User’s Manual
PAGE 8
Technical Support (650) 384-0000 www.avalan.com
Conformity with Standards
Ensure that all National, State, and local standards and codes are observed in site preparations,
wiring, and installation.
Power Wiring
Warning: USE THE SUPPLIED POWER CABLE ONLY.
Using other cables will void your warranty.
Emergency Stop Circuit
It is recommended that the electrical wiring for the AvaLAN AW584EMVSU be run through the
Emergency Stop circuit at the site so that all electrical power is cut whenever the Emergency Stop
button is pressed. The Emergency Stop Circuit wiring should be congured according to local electrical
regulations.
Codes
Conrm that all equipment is installed in accordance with the US National Electrical Code (NFPA 70),
the automotive and Marine Service Station Code (NFPA 30A), and any other applicable state and local
codes. For installations outside the US follow all applicable local and international codes.
Requirements
REQUIRED TOOLS
The only tool we require is an Anti-Static Wrist Strap. No other tools are required.
REQUIRED PARTS
Quantity Part Number Description
1AW58EMVAP 5 GHz Wireless Forecourt Access Point
1AW584EMVSU 5 GHz Wireless In-Dispenser Communications System
2AW58EMVMK Mounting Kit
AW58EMVAP | AW584EMVSU User’s Manual
PAGE 9
Technical Support (650) 384-0000 www.avalan.com
Installation Overview
INSTALLATION NOTES:
1) Installation and use shall be in accordance with the Flammable and Combustible Liquids Code,
NFPA 30
2) This device will connect to the Wayne Fuel Dispenser’s 24VDC power panel
3) The cables provided with the product shall be reliably routed separate (>50mm) from other wiring/
cabling within the dispenser, unless all wiring insulation is rated for the highest circuit voltage.
4) The Earthing conductor shall be minimum 18AWG and copper only.
5) Only use the supplied cable to power device.
6) The power supply should be Class 2 or equivalent.
FIGURE 11.1 AvaLAN AW584EMVSU INSTALLATION
AW58EMVAP | AW584EMVSU User’s Manual
PAGE 10
Technical Support (650) 384-0000 www.avalan.com
Mounting Kit Plate
Quick Disconnect Bracket
AW584EMVSU Radio
USB Key Power Cable
Mounting Adhesive
Screws
What’s in the Box
AW584EMVSU
AW58EMVAP
Quick Disconnect Bracket
Mounting Adhesive
Screws
Power Supply
POE Injector
Mounting Kit Plate AW58EMVAP Radio
Antennas
Altri manuali per AW58EMVAP
3
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali AvaLAN Punto di accesso wireless
AvaLAN
AvaLAN AW58800HTP-PAIR Manuale utente
AvaLAN
AvaLAN AW58100HTA Manuale utente
AvaLAN
AvaLAN AW58EMVAP Manuale utente
AvaLAN
AvaLAN AW58100HTA Manuale utente
AvaLAN
AvaLAN AW58300HTA Manuale utente
AvaLAN
AvaLAN AW58803HTS Manuale utente
AvaLAN
AvaLAN AW49200HTA Manuale utente
AvaLAN
AvaLAN AW58800HTA Manuale utente
AvaLAN
AvaLAN AW58EMVAP Manuale utente
AvaLAN
AvaLAN AW58100HTA Manuale utente
