Installation Manual
PosiStrobe CP
_______________________________________________________________________________________________________________________
Page 10 of 12
connected the ground side of the power supply. Connecting the blue wires
from each light together (and not to the ground or positive terminals on the
battery) should show that the lights are flashing together and indicates the
synchronization feature is working properly. When installed on the aircraft,
using the aircraft’s power (14 or 28 volts), the lights will be at their
maximum intensity.
After testing, the light can be installed on the aircraft.
IMPORTANT
NOTES:
1. Under no circumstances should any power supply other than a 9-32V dc, or a
12/24 volt battery be used to test the lights. Do not use: Battery chargers,
battery back-up power devices, or other bench avionics testing methods to
test the aviation lights. The lights are functional between 9 and 32 volts. Use
of a battery charger or other power unit to test the lights will void the warranty
and may damage the lights.
2. All power supplies for existing strobe lights, flasher beacons, etc. are required
to be removed from the aircraft prior to the installation of the Aveo light.
If you have any questions about the installation of the lights, please refer to our
web site: www.aveoengineering.com, and check FAQ and other links on our aviation
lights web page.
10. CARE AND CLEANING OF YOUR AVEO ENGINEERING
AVIATION LIGHTS
When you receive your Aveo Engineering Aviation Lights, they will have
been factory polished and ready to install on the aircraft. Upon installation, just
give the lights a good coat or two of a quality automotive polish. This should
protect the lights from dirt and other environmental factors. Once or twice a
month, just refresh the polish and hand buff to bring back the lights to factory like
new condition.
If the lights need a deeper cleaning, they can be polished with a good
automotive cleaner wax and/or a liquid polishing compound. The liquid
polishing compounds can normally be found at automotive parts stores or an
automotive paint store. After using a polishing compound, just give the
lights another coat of an automotive polish and you will again protect the
lights against dirt, etc. An electric buffing machine, with a lamb’s wool cover,
can also be used for deeper cleaning and polishing. Under no circumstances
should any petroleum based product be used to clean the lights.
For continued UV protection Aveo Engineering offers NonocloakTM UV Protectant
Spray and Cleaner, available at any Aveo Engineering Authorized installation
Center.
