AVteq DynamiQ RPS-500 Guida rapida
DynamiQ RPS-500
EASYSETUPGUIDE
C
G
Items
Included
A
Items needed for install
- Phillips screw driver
- Wrench 3/4”
Top Horizontal
Support
Middle Horizontal
Support
(x2)
Leg
(x2)
B
F
Bottom Horizontal
Support Shelf (x1)
Mount Cover (x1)
(x1)(x1) (x2)
D E
H I
Philips
Head Bolt
1/4”x 1”-1/4”
Install Tip: As you are installing the bolts
and nuts, leave them all loose. Install all of
them before tightening.
AVTEQ.net
800-285-8315
Phillips
Head Bolt
5/16”x 1 or
5/16”x 3/4” (x28)
5/16”
ext 0.75”
(x28) (x4)
KJ L M
Casters
With Brake (x2)
Without Brake (x2)
DynamiQ 400
Mount (x1)
Washer
1/4” (x2)
Nut 1/4”
(x2)
A
A
J
J
Attach Casters (J) to the end of
each Leg (A). Make sure the
Casters with Brakes are
installed in the front of the cart.
1
Rack Screws
10-32
N
AVTEQ.net
800-285-8315
2
4
3
A
B
B
C
C
D
D
G
H
G
H
H
H
G
G
A
D
D
Attach each of the Horizontal Supports
(B) (C) (D) to the first Leg (A) using
the Bolts (G) and Washers (H) as
shown. Make sure the flat side of each
support is facing the front of the cart.
Attach the other Leg (A) to the Hori-
zontal Supports (B) (C) (D) using the
Bolts (G) and Washers (H) as shown.
Secure Mount Cover (L)
between the Top and Middle
Horizontal Supports using the
Phillips Head Bolts (G) and
Washers (H) as shown.
G
L
E
I
I
H
Install the Shelf (E) to
the vertical rack rails
using the Rack Screws (I).
K
AVTEQ.net
800-285-8315
5
6
7
Attach the DynamiQ
400 Mount (K) to the
frame by aligning the
holes on each side of
the mount with the
hooks on the top
Horizontal Support.
Hook on Top Horizontal Support
Hole in DynamiQ
400 mount
Hang mount to
frame
FRONT CART
Please refer to the instructions in the BB VESA mount for
VESA mount assemble and please refer to the instructions
in the DynamiQ/BalanceBox 400 series mount for adjusting
the DynamiQ mount. See UM-1 Adaptor and CSB Mount
Instructions if using cart with Cisco boards
REAR CART
Secure with Bolt (F),
Washer (M) and Nut (N).
M
N
F
Indice
Altri manuali AVteq Rack e supporto
