8
Spectrum 510
11. Connect the Power Supply
Connector (D) White - to the
“GND” 7 screw terminal block.
12. Connect the Power Supply
Connector (D) Black + to the “V
in +” 7 screw terminal block.
13. Using a screw driver, tighten
the “GND”, “DMX -”, “DMX +”,
sections of the 4 screw terminal,
and “GND”, and “V in +” of the
7 screw terminal.
14. Insert orange 4 screw terminal
block and 7 screw terminal
block into their respective pin
terminals.
15. Remove DMX Driver’s (A) DMX
IN screw terminal block from pin
terminal.
16. Connect the DMX IN Cable (E)
Ground to the DMX Driver’s (A)
DMX IN screw terminal block’s
“GND”.
17. Connect the DMX IN Cable (E)
Red to the DMX Driver’s (A) DMX
IN screw terminal block’s “D-”.
18. Connect the DMX IN Cable (E)
Black to the DMX Driver’s (A)
DMX IN screw terminal block’s
“D+”.
19. Using a screwdriver, tighten the
“GND”, “D-”, and “D+” sections
of the DMX IN screw terminal
block.
20. Insert DMX IN screw terminal
block into its pin terminal.
Installation - Touch Interface (Continued)Installation - Touch Interface (Continued)
21. Test light system prior to
mounting Touch Interface (B)
to wall. Verify connections are
secure and working properly.
22. Apply a 1/8” bead of silicone
around the back of the Touch
Interface (B).
23. Peel off tape and mount Touch
Interface (B) to hole cutout area.
24. Apply a 1/8” of silicone around
the edge of the mounted Touch
Interface (B) as required to form
a water tight seal.
25. Allow silicone to cure for 24
hours before exposing product
to any source of moisture.
