BayTech DS-RPC Manuale utente
2019
Copyright2019
BayTechnicalAssociates,Inc
2/1/2019
DataSwitch‐RemotePowerControl
Reset(DS‐RPC)
Page2
DSRPCFactoryReset:
To reset the DS-RPC unit’s outlets to factory default, use the following instructions:
Hardware Revision lower than H2.0* and DS2-RPC
1. Remove the top lid of the DS-RPC chassis.
2. Locate jumper J15 (Blue Arrow) in the center of the receptacle board. (This is a two-pin jumper.)
3. Place “a” jumper on the two pins and power the unit up for 10 seconds.
4. Turn the power off and remove the jumper.
5. Turn the power back on.
* Label located on inside of chassis, on the back side of the front panel
If the unit still asks for a password perform reset again but increase the jumper time to 20 seconds.
Page3
DS4(A)-RPC and Hardware Revision H2.0 or higher*
To reset the DS-RPC unit’s outlets to factory default, use the following instructions:
1. Remove the top lid of the DS-RPC chassis.
2. Locate jumper JP1 (Blue Arrow) in the center of the receptacle board. (This is a two-pin jumper.)
3. Turn the power off
4. Place a jumper on the two pins and power the unit up for 10 seconds.
5. Remove the jumper while the unit is powered on.
* Label located on inside of chassis, on the back side of the front panel
If the unit still asks for a password perform reset again but increase the jumper time to 20 seconds.
Altri manuali per DS-RPC
1
Indice
Altri manuali BayTech Interruttore
BayTech
BayTech ATS Series Manuale utente
BayTech
BayTech DS72 Manuale utente
BayTech
BayTech BayTech DS71-MD4 Manuale utente
BayTech
BayTech V79 PDI-1 Manuale utente
BayTech
BayTech BayTech DS71-MD4 Manuale utente
BayTech
BayTech MRPr Manuale utente
BayTech
BayTech ATS27 Manuale utente
BayTech
BayTech DS74 Manuale utente
BayTech
BayTech MSP Series Manuale utente
BayTech
BayTech DS3 Manuale utente
