Beam Laser Manuale utente
INSTALLATION GUIDE
TABLE
Thank you for purchasing your new BEAM. Here's what's included:
The BEAM system Power cord Remote controller
for controlling the BEAM projector
The BEAM keyboard
for operating the system menus
WHAT’S IN THE BOX
1 32 4
Before starting the installation and setup, please make sure that:
BEFORE INSTALLING
Full batteries are equipped in both the
keyboard and remote controller.
The keyboard's toggle on the is on and
its green background is visible.
1 32
The yellow saftey ribbon is pulled out
of the batteries compartment.
In order to hang your BEAM from the ceiling, please prepare:
BEFORE INSTALLING
4 TURNBUCKLES
HOOK/EYE
4 CONCRETE EYE BOLT
ANCHORS
4 CHAINS
See chart on slide 6 to
determin required length
4 CARABINER CLIPS
Note
Please prepare a measuring tool, a marker, a drill, a pair of pliers and a leveler for the installation process itself.
An internet connection is required to complete the device setup.
TECHNICAL SPECIFICATIONS
The BEAM device dimentions and
measurments in milimeters:
TOP
BACK
LEFT
RECTANGULAR TABLE SETUP
PROJECTION SURFACE MINIMUM ZOOM MAXIMUM ZOOM
Distance from surface to device Width Height Width Height
140 79 50 128 80
150 85 53 137 86
160 90 56 147 92
170 96 60 156 97
180 102 64 165 103
190 107 67 174 109
200 113 70 183 115
210 118 74 193 120
220 124 78 202 126
225 127 80 206 129
Use this table to determine if the
installation location can accomodate the
desired projection size.
All measurments are in centimeters.
Note
Mounting the device more than 425
centimiters above the projection
surface may produce false interactions
and sensor inaccuracies.
ROUND TABLE SETUP
PROJECTION SURFACE MINIMUM ZOOM MAXIMUM ZOOM
Distance from surface to device Projection Diameter Projection Diameter
140 50 80
150 53 86
160 56 92
170 60 97
180 64 103
190 67 109
200 70 115
210 74 120
220 78 126
225 80 129
Use this table to determine if the
installation location can accomodate the
desired projection size.
All measurments are in centimeters.
Note
Mounting the device more than 425
centimiters above the projection
surface may produce false interactions
and sensor inaccuracies.
INSTALLING BEAM
Unpack the device and place it face
down on a soft surface such as a carpet.
Each end of the turnbuckles should
be screwed to it's middle to allow for
maximum adjustment range.
1 3
Attach each of the carabiner clips to the four ear loops on the top panel.
Next, connect the turnbuckles to the carabiner clips.
2
X X
INSTALLING BEAM
Locate the center of the projection area - the device will be installed directly
above it. Measure a square on the ceiling above the center of the projection area.
The square must be at least 60 centimeters (24 inches) in length and width. Mark
the square's corners.
In order to leave sucient space for the projection area, keep a distance of at least
100 centimeters between the marked square (where you intend to install the
device) and any nearby walls.
4
PROJECTION AREA DISTANCE FROM WALLS
Drill holes at of the square's marked corners. Make sure the drilled holes depth and
diamater match the measurments of your eye bolt anchors. Insert an eye bolt
anchor to each one of the drilled holes.
Fasten the bolts in place.
5
INSTALLING BEAM
Indice
Altri manuali Beam Proiettore
