BEC BEC 6500AEL Manuale utente

BEC 6500AEL

4G/LTE Enterprise

Multi-Service Router

Quick Start Guide

BEC 6500AEL 4G/LTE Enterprise Multi-Service Router

Package Contents

✓BEC 6500AEL 4G/LTE Wi-Fi Broadband Router x 1

✓This Quick Start Guide x 1

✓Wi-Fi Antenna x 2

✓RJ-45 Ethernet Cable x 1

✓DC Power Adapter 15V DC 1.6A x 1

✓4G/LTE Antenna x 2 ( 6500AEL R18/R21 is using four (4) 4G/LTE antennas)

NOTE:ALL IMAGES SHOWN ARE FOR ILLUSTRATION PURPOSE ONLY.

PACKAGE CONTENTS MAY DIFFER FROM ACTUAL PRODUCTS.

Warning

⚫Do not use the router in high humidity or at high temperature.

⚫Do not use the same power source for the router as other equipment.

⚫Do not open or repair the case yourself. If the router is too hot, turn off

the power immediately and have it repaired at a qualified service center.

⚫Avoid using this product and all accessories outdoors.

Attention

⚫Place the router on a stable surface.

⚫Only use the power adapter that comes with the package. Using a

different voltage rating power adapter may damage the router.

PLEASE READ THE QUICK START GUIDE AND FOLLOW THE

STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU

INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE.

IF YOU NEED MORE INFORMATION ON THIS SOFTWARE

CONFIGURATION, PLEASE REFER TO THE ONLINE USER

MANUAL.

Quick Start Guide

Front Panel - LEDs / LTE Connectors

PORT

MEANING

LTE Antenna

Connectors

Screw the supplied mobile LTE antennas onto the antenna connectors on both

sides.

(6500AEL R18 / R21 uses 4LTE antennas and 2Wi-Fi antennas)

LED

STATUS

DESCRIPTION

Power

Green

System is up and ready

Red

Boot failure

Ethernet Port

LAN 1 - 4

Green

Transmission speed is at Gigabit speed (1000Mbps)

Orange

Transmission speed is at 10/100Mbps

Blinking

Data being transmitted/received

USB

Green

Connecting to hard drive for storage or file sharing, etc.

Wi-Fi 2.4G / 5G

Green

Wireless connection to 2.4G or 5G network is established

Blinking

Data being transmitted / received

WPS

Green

Wireless device(s) being connected successfully via WPS mode

Blinking

WPS is enabled and trying to establish a WPS connection

LTE

(Received

Signal

Strength

Indicator)

Green

RSSI greater than -69 dBm. Excellent signal condition

Green

Flashing

Quickly

RSSI from -81 to -69 dBm. Good signal condition

Orange

Flashing

Quickly

RSSI from -99 to -81 dBm. Fair signal condition

Orange

Flashing

Slowly

RSSI less than -99 dBm. Poor signal condition

Orange

No signal and the 4G_LTE module is in service

Off

No LTE module or LTE module fails

Internet

Green

WAN IP is received, and traffic is passing thru the device

Red

Cannot get a WAN/public IP address

Off

The device is either in bridged mode or WAN connection not ready.

BEC 6500AEL 4G/LTE Enterprise Multi-Service Router

Rear Panel –Ports / Connectors

PORT

MEANING

Wi-Fi

Antenna

Connectors

Screw the supplied Wi-Fi antennas onto the antenna connectors on both sides

LTE Antenna

Connectors

(6500AEL R18 / R21 uses 4LTE antennas and 2Wi-Fi antennas)

Screw the supplied mobile LTE antennas onto the antenna connectors on both sides

SIM Card Slot

Insert the mini SIM card (2FF) with the gold contact facing down

Push the mini SIM card (2FF) inwards to eject it

WPS &

Wireless

On/Off

By controlling the pressing time, users can achieve two different effects:

(1) WPS*: Press &hold the button for less than 6 seconds to trigger WPS function.

(2) Wireless ON/OFF button: Press & hold the button for more than 6 seconds to

enable or disable the wireless.

* Refer to the WPS section in the User Manual for more details.

Reset

After the device is powered on, press it 6 seconds or above: to restore to factory

default settings (this is used when you cannot login to the router, e.g. forgot your

password)

Gigabit

LAN Ethernet

(1 - 4)

Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the four LAN ports when

connecting to a PC or an office/home network of 10Mbps /100Mbps /1000Mbps

* Ethernet WAN/4

Connect to Fiber/ Cable/ xDSL Modem with a RJ-45 cable, for broadband

connectivity

Note: LAN 4 automatically becomes an ethernet WAN port when the ETH WAN internet

interface is being selected in the GUI

USB

Mainly for storage and file sharing

DC Power

Jack

Connect the supplied Power Adapter to this jack

Power

ON/OFF

Power ON/OFF switch

Quick Start Guide

Hardware Connection

Back Panel Ports & Connectors

Wi-Fi & LTE Antenna Connectors (Standard Version)

BEC 6500AEL 4G/LTE Enterprise Multi-Service Router

Wi-Fi & LTE Antenna Connectors (6500AEL R18 / R21 Only)

Hardware Installation

1. Power Connection

Plug in the supplied power adapter to the wall jack, the other side to device then power ON

the 6500AEL by pressing the Power On/Off button.

Quick Start Guide

2. LAN Connection

Connect the supplied RJ-45 Ethernet cable to one of the Ethernet ports, and the other side

to the PC’s Ethernet interface.

3. WAN Link Interface and Connection

BEC 6500AEL supports failover and failback on multiple WAN interfaces, 4G/LTE and

Ethernet WAN <Please refer to User Manual for detailed Internet setup>

3.1 4G_LTE Connection

Slide the SIM card into the card slot of the device with the gold contact facing down. Make

sure that the SIM card has been slid into the bottom of the slot with a click. When removing

the SIM card, press the SIM card again it will be ejected from the card slot.

WARNING: Please power off the device before inserting or removing the SIM

card.

BEC 6500AEL 4G/LTE Enterprise Multi-Service Router

3.2 Ethernet WAN Connection

Connect RJ-45 Ethernet cable to the EWAN port, and connect the other side to another

alternative broadband device, such as Cable Modem, VDSL, Fiber Modem or PON optic

lines.

4. USB for Network File Sharing

BEC 6500AEL has built-in FTP and Samba Servers, simply plug in an external USB HD

then follow the instruction setup in the User Guide.

Quick Start Guide

Connecting to the Router

The default IP of modem is 192.168.1.254 with subnet 255.255.255.0. Make sure the attached

PC to this router is in the same subnet and has an IP address in the range between 192.168.1.1

~ 192.168.1.253.

Open a web browser and type http://192.168.1.254 in the URL address bar.

The login prompt will appear. Input the default username (admin) and password (admin) for

Account type, Administrator. *This username / password may vary by different Internet Service Providers.

Quick Setup Your Router

Use the Quick Start for fast connection setup.

Step 1: Change administration password

Setup a new password for “admin” account for device management. The default password is

“admin”. Click Continue to go on to the next step.

*The password may vary by different Internet Service Providers.

Step 2: Time Zone configuration

Enable and select your Time Zone then click Continue to go on to the next step.

URL Address bar: type

http://192.168.1.254

Time Zone: select your time zone

Next Step: click Next

Wired Broadband Connection - Before start configuring the 6500AEL, make sure you

have the Ethernet WAN connected with your Internet box or fiber line.

New Password: assign a new,

unique password

Confirm Password: re-enter the

new password again

Next Step: click Next

Indice

Manuali Router di rete popolari di altre marche

Allnet

Allnet ALL0333AU Manuale utente

HomeSeer

HomeSeer HT-SEL Manuale utente

Sercomm

Sercomm Genesis OC3505D Manuale utente

Billion

Billion BIPAC 5102 Series Manuale utente

TP-Link

TP-Link TD-8817 Manuale utente

Motorola

Motorola MR1900 Manuale utente

Digi

Digi IX14 Manuale utente

Cisco

Cisco NCS 540 Manuale

XAVi

XAVi X8821e Manuale utente

MikroTik

MikroTik hAP ac3 Series Manuale utente

Korenix

Korenix JetNet 5428G Series Manuale utente

NETGEAR

NETGEAR FS526T - Switch Manuale utente

Korenix

Korenix JetNet 5710G Series Manuale utente

Automated Logic

Automated Logic ZN551 Manuale del proprietario

Cisco

Cisco ASR 1000 Series Manuale dell'operatore

EnGenius

EnGenius ESR-9710 Manuale utente

Cisco

Cisco 805 Series Istruzioni operative e di sicurezza

LevelOne

LevelOne FBR-1416 Manuale utente