6
1. This lift is designed for maintenance and servicing of vehicles. Do not use the lift for purposes
other than those for which it is intended.
2. Stop using the lift if even a single safety device fails to operate properly.
3. Wet tires and supporters require attention, as they can cause slippage.
4. Pay attention to prevent a hand or finger from becoming trapped when using and storing the
sliding supporter.
5. Adjust the height of supporters to evenly distribute the load among the four supporters when
using the swing arm.
6. Lifts on the left and right are linked for synchronization and are not able to take extremely
unbalanced loads.
7. The difference in load applied to supporters on the left and right must be within 300 kg when
using the lift. Failing to do so may potentially cause damage to the lift.
8. Set the supporters securely at lifting points and do not raise a vehicle when there are no clear
lifting points on the vehicle. Refer to the maintenance manual of the vehicle for information on
correct lifting points.
<Lifting & lowering>
1. Pay attention to the condition of the vehicle while operating the lift to raise or lower and never
operate the lift while looking elsewhere.
2. In the event there are other lifts at the same site, avoid erroneous operation with operating
buttons for other lifts.
3. Do not lift any vehicle that exceeds the maximum capacity of the lift.
4. Do not lift a vehicle with people or cargo still on board.
5. Make sure there is no oil or soil on supporter when raising a vehicle.
6. Stop lifting after Supporter have made firm contact with vehicle and check locations of Supporter
for correct lifting points before reraising the vehicle.
7. Pay attention to tilting of the vehicle on the lift when raising or lowering and make sure that the
vehicle is kept horizontal at all times.
Stop operating the lift immediately if the vehicle tilts.
8. In the event the lift does not lower even when the lowering button is pressed, raise it once and
then lower it.
9. When lowering the lift with the sliding supporters in use, stow them after tires of the vehicle
comes into contact with the floor, then lower the lift to the lowest position. Failure to do so may
potentially cause damage to the supporters or the floor surface.
10. Do not operate the lift while tools or parts are left inside the pit or on movable parts of the lift unit.
Doing so may result in malfunction of the lift or vehicle falling.
11. Do not approach the lift or touch the lift while raising or lowering a vehicle.
12. Raise or lower the lift only after verifying the vehicle and lift surroundings to ensure that there are
no people or objects.
13. Drive the vehicle in and out only after the supporters have been lowered completely. Drive the
vehicle in and out only after the swing arms have been opened completely. Failure to do so can
cause damage of the vehicle or the lift.
