Maintenance
• When unpacking, assembling and
cleaning the product, handle the
individual parts with extra care, especially
the glass parts which are very fragile.
• The assembly and wiring of the luminaire
must be carried out by an authorized
person.
• The floor luminaire is intended for indoor
use.
• Do not cover the light source or touch the
light source when the light is on.
• Do not make any repairs or changes to
the components. Contact a specialist
service center.
• Do not use any spare parts which have
not been supplied or approved by the
manufacturer (except for light sources).
• Do not expose the luminaire to an
unsuitable environment where it might
get damaged (water, heat, frost).
• Warning: the luminaire may in some
parts have sharp edges which may
cause injury. Take extra care when
moving in close proximity to them.
• Any cleaning and maintenance should
be carried out with the luminaire
switched off and preferably disconnected
(please mind this warning throughout the
installation.)
• When changing a bulb, always disconnect
the luminaire from the power supply.
• It is recommended to install pendant
luminaires in more than one person.
• After installing the luminaire, check that it
is correctly and securely fixed to its base.
• Do not expose the luminaire to
unreasonable loads, protect the luminaire
from mechanical damage.
• The light source heats up during
operation. Before starting any operation,
wait until the light source cools down
spontaneously _do not expose to rapid
cooling_.
• Halogen light sources must not come
into contact with oily materials, so do not
touch them with bare hands. Install them
using clean textile gloves or a clean cloth.
To clean a halogen bulb, it is best to use
alcohol-based products.
• When replacing the bulb, use the
same or recommended light source
(information about the type is on the
label or in the installation instructions).
• Do not hang any other components
on the luminaire in conflict with the
manufacturer’s installation instructions.
• Pay attention to checking all parts before
their installation. Damaged components
and glass parts _fragmentation, cracks_
can cause bodily injury to persons in their
vicinity.
• Contact the manufacturer if a serious
problem occurs during cleaning or
maintenance of the luminaire.
• Any other manipulation with the
luminaire should be carried out by
qualified personnel or directly by the
manufacturer.
