Page 4
___________________________________________________________________________
Adjusting the down position
If adjustment is not possible, go to Option B, then to Step 3
STOP +▼ until
STOP +▼ until 2x
Go to the already Press at the same time Go to the new Press at the same time
set bottom position, STOP and DOWN until bottom position. STOP and DOWN button, until
the motor moves and beeps 1x. the motor 2x moves and 3x beeps.
_______________________________________________________________________________
Option B Pulse / jog control
1x
, beeps 1x
▲+▼ until 1x
1x STOP
Pulse / jog on
Pulse / jog off
Press and hold UP and DOWN button, Press 1x STOP button.
until the product moves up and down.
2x
, beeps 3x
_______________________________________________________________________________
Option C Deleting the third limit position
1x P2 1x
1x STOP 1x
1x STOP 1x
OK
Press 1x P2. Press 1x STOP button. Press 1x STOP button. The third limit positions
The product moves 1x up The product moves 1x up The product moves 1x up are now deleted from
and down and beeps 1x. and down and beeps 1x. and down and beeps 1x the memory.
for confirmation.
_______________________________________________________________________________
Option D Learn new transmitter/channel while maintaining end limits
Only possible when end limits are set.
= Already existing transmitter = New transmitter
Method 1
P2 a until
P2 a until
STOP b until 2x
OK
Press P2 of a. The product Press P2 of a. The product Press STOP of b. The product The transmitter b
moves 1x up and down moves 1x up and down moves 2x up and down has been added.
and beeps 1x. and beeps 1x. and beeps 3x.
Repeating the above will remove the new transmitter/channel.
