
6
Intended Usage
The Brewista® Cold Pro Nitro 2 Dual™ Dispenser is a ready-to-use dispenser to tap still and
nitrogenated and cooled beverages in particular cold-brew coee from any pressurized
or non-pressurized container. Such systems are mainly used for professional customers
in cafes, hotels, restaurants, and bars. The nitrogen eect is created through ltered
compressed air which contains 78% nitrogen and chilling it to 36°F (2°C). The device is
only approved for this application and is not suitable for cooling hot liquids, unltered
liquids, chemicals, or similar substances. The Brewista® Cold Pro Nitro 2 Dual™ Dispenser
must only be operated by a trained person. The appliance is not to be used by persons
(including children) with reduced physical, mental, or sensory abilities or with scarce
experience and/or expertise, unless they are supervised by a person responsible for their
safety, or they are instructed by this person on how to properly use the Cold Pro Nitro 2
Dual™ machine.
Operation Instructions
Assemble your Cold Pro Nitro 2 Dual™
1) Place the device in a level, clean, and dry location. Ensure there is enough
space around the machine for proper ventilation — about one inch (2.54 cm)
from the side vents and 4 inches (10 cm) from the top.
2) Let the machine sit upright for 5 hours before rst use so the compressor
works properly.
3) Assemble the tap handles (1) by screwing each on at the top of the dispenser’s
spout component [(2) and (3)].
4) Ensure the power button (7) at the bottom of the machine is switched o. If
the red light inside of the switch is o, then the air compressor is o.
5) Plug in the power cord (9) to a grounded outlet (refer to Additional
Safeguards, page 3).
6) Connect the intake lines (13) to the Cold Pro Nitro 2 Dual™ by pushing the
male elbow coupler (14) into the female couplers [(5) and (6)] at the bottom of
the machine located at the far end of the machine on the bottom.
◦Lift the machine slightly if needed.
◦The female coupler nearest to the side (5) of the machine feeds to the
spout that will dispense chilled still cold brew.
◦The female coupler nearest to the center (6) of the machine feeds to the
spout that will dispense chilled nitro cold brew.
◦To release the coupler attachment, push the metal spring component to
loosen.
7) The pre-lter comes attached upon delivery of the Cold Pro Nitro 2 Dual™
machine. Ensure all tubing is installed rmly at all connections to prevent air
bubbles from entering the tube. Tubing may have loosened during shipment.
◦Note: If a lter adapter is not part of both intake lines, coee grounds
or other particles could block the jet nozzles in the device or impair the
functionality of the membrane pump and make the device unusable.
Connect your Cold Brew Container
• Note: Brewista recommends checking functionality of your system by using
water. This will also help ush out any cleaning solution residue from the
system as well.