Cabletron Systems MMAC-Plus 9F310-02 Manuale utente

MMAC-Plus

™

9F310-02 & 9F315-02

FDDI Switch Module

User’s Guide

Notice

Cabletron Systems reserves the right to make changes in speciﬁcations and other information

contained in this document without prior notice. The reader should in all cases consult Cabletron

Systems to determine whether any such changes have been made.

The hardware, ﬁrmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT,

SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED

TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION

CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR

SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

Cabletron Systems, Inc.

35 Industrial Way

Rochester, NH 03867-5005

Printed in the United States of America

Order Number: 9031400-01 June 1995

SPECTRUM

Remote LANVIEW

and

LANVIEW

are registered trademarks and

MMAC-Plus

trademark of Cabletron Systems, Inc.

Ethernet

is a trademark of Xerox Corporation.

Notice

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

NOTE:

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial environment.

This equipment uses, generates, and can radiate radio frequency energy and if not installed in

accordance with the operator’s manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause interference in which case the user

will be required to correct the interference at his own expense.

WARNING:

Changes or modiﬁcations made to this device which are not expressly approved by the

party responsible for compliance could void the user’s authority to operate the equipment.

DOC Notice

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital

apparatus set out in the Radio Interference Regulations of the Canadian Department of

Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables

aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique

édicté par le ministère des Communications du Canada.

Notice

Safety Information

CLASS 1 LASERTRANSCEIVERS

The 9F315-02 is a Class 1 Laser Product

The 9F315-02 uses Class 1 Laser transceivers. Read the following safety

information before installing or operating these adapters.

The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation

limits. This control loop eliminates the need for maintenance checks or adjustments. The

output is factory set, and does not allow any user adjustment. Class 1 Laser transceivers

comply with the following safety standards:

• 21 CFR 1040.10 and 1040.11 U.S. Department of Health and

Human Services (FDA).

• IEC Publication 825 (International Electrotechnical Commission).

• CENELEC EN 60825 (European Committee for Electrotechnical

Standardization).

When operating within their performance limitations, laser transceiver output meets the

Class 1 accessible emission limit of all three standards. Class 1 levels of laser radiation are not

considered hazardous.

CLASS 1

LASER PRODUCT

Notice

Safety Information

CLASS 1 LASERTRANSCEIVERS

Laser Radiation and Connectors

When the connector is in place, all laser radiation remains within the ﬁber. The maximum

amount of radiant power exiting the ﬁber (under normal conditions) is -12.6 dBm or 55 x 10

-6

watts.

Removing the optical connector from the transceiver allows laser radiation to emit directly

from the optical port. The maximum radiance from the optical port (under worst case

conditions) is 0.8 W cm

-2

or 8 x 10

W m

sr-1.

Do not use optical instruments to view the laser output. The use of optical instruments to

view laser output increases eye hazard. When viewing the output optical port, power must

be removed from the network adapter.

vii

Contents

Chapter 1 Introduction

Features........................................................................................................................... 1-1

Related Manuals............................................................................................................ 1-4

Getting Help .................................................................................................................. 1-4

Chapter 2 Installing the MMAC-Plus modules

The Reset Switch ........................................................................................................... 2-3

User Accessible Components ...................................................................................... 2-4

Chapter 3 Operation

System Management Buses.................................................................................. 3-2

SMB-1 Bus........................................................................................................ 3-2

SMB-10 Bus...................................................................................................... 3-2

System Diagnostic Controller .............................................................................. 3-2

DC/DC Converter ................................................................................................. 3-3

INB Interface........................................................................................................... 3-3

Fast Packet Switch ................................................................................................. 3-3

i960 Core.................................................................................................................. 3-3

Chapter 4 LANVIEW LEDs

Chapter 5 Speciﬁcations

Technical Speciﬁcations......................................................................................... 5-1

CPU:.................................................................................................................. 5-1

Memory:........................................................................................................... 5-1

Standards: ........................................................................................................ 5-1

Network Interfaces:........................................................................................ 5-1

Safety ....................................................................................................................... 5-2

Service...................................................................................................................... 5-2

Physical.................................................................................................................... 5-2

Dimensions:..................................................................................................... 5-2

Weight:.............................................................................................................. 5-2

Environment:................................................................................................... 5-2

Link Distance.......................................................................................................... 5-3

Contents

viii

1-1

Chapter 1

Introduction

The 9F310-02 and 9F315-02 are three port switch modules with two front panel

FDDI interfaces and one INB-1 backplane interface. The external FDDI networks

are connected to the modules using standard FDDI A/B ports on the front panel.

The 9F310-02 uses multi mode ﬁber, and the 9F315-02 uses single mode ﬁber optic

cables for this connection. The 9F310-02 and 9F315-02 modules employs the Fast

Packet Switch (FPS), a high performance switch design, and the Intel i960 micro-

processor. The modules can redirect one or both of its front panel FDDI Interfaces

to the FNB backplane, creating an INB-1 to FNB bridge/switch product that

allows a migration from FNB modules to INB-1 modules.

Features

Processor

The 9F310-02 and 9F315-02 are equipped with an advanced Intel i960

microprocessor. This microprocessor provides a platform for all management

functions within a scalable RISC-based architecture.

Packet Switch Engine

The 9F310-02 and 9F315-02 module incorporates the Fast Packet Switch (FPS), a

collection of custom ASlCs designed speciﬁcally for high speed switching. The

FPS bus is 64 bits wide with a bandwidth of 320 Mbps. Since all frame translation,

address lookups, and forwarding decisions are performed in hardware, the

9F310-02 and 9F315-02 can obtain a throughput performance of greater than

150K pps.

Management

The 9F310-02 and 9F315-02 modules have two full implementations of SMT

(Version 7.3), one per interface, and SNMP for local and remote management.

Local management is provided through the RS-232 Com ports on the MMAC-Plus

Environmental Module using a standard VT-220 terminal or emulator. Remote

management is possible through Cabletron’s SPECTRUM or any SNMP

compliant management tool as well as telneting to the module. Management

features including module insert/bypass control, MAC placement, front

panel/FNB conﬁguration, and SMT statistics. Bridging statistics on both FDDI

Introduction

1-2

interfaces provide frames ﬁltered, frames forwarded, and all Spanning Tree

Protocol parameters. The 9F310-02 and 9F315-02 modules support the IETF FDDI

MIB (RFC-1512), IETF MIB ll (RFC-1213), IETF BRIDGE MIB (RFC-1493), and a

host of Cabletron enterprise MIBs. In addition, the front panel provides LEDs for

FDDI link status per port as well as transmit and receive activity.

Connectivity

The 9F310-02 and 9F315-02 modules have one interface to the INB-1, two front

panel FDDI interfaces, or two FNB interfaces to the MMAC-Plus FNB backplane.

The front panel A/B port connections are via standard ﬁber FDDI MIC

connectors. The INB-1 interface is ﬁxed, however, and the two FDDI interfaces

can attach to one or both of the front panel connectors, one or both of the FNB

interfaces (FDDI-1 or FDDI-2), or one of each.

Management Information Base (MIB) Support

Both 9F310-02 and 9F315-02 provide MIB support including:

• IETF FDDI MIB

• IETF MIB II

• IETF Bridge MIB

• a host of Cabletron Enterprise MIBs.

LANVIEW LEDs

The 9F310-02 and 9F315-02 use LANVIEW – the Cabletron Systems built-in visual

diagnostic and status monitoring system. With LANVIEW LEDs, you can quickly

identify the device, port, and physical layer status at a glance.

For a complete list of supported MIBs, refer to the release notes provided in

the 9F310-02 and 9F315-02 package.

NOTE

Altri manuali per MMAC-Plus 9F310-02

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Cabletron Systems Interruttore

Cabletron Systems

Cabletron Systems SEHI SEHI100TX- Manuale utente

Cabletron Systems

Cabletron Systems SEHI100TX-22 Manuale utente

Cabletron Systems

Cabletron Systems MMAC-Plus 9EX02-12 Manuale utente

Cabletron Systems

Cabletron Systems MMAC-Plus 9F206-02 Documento tecnico

Cabletron Systems

Cabletron Systems SmartSTACK 100 ELS100-24TX Istruzioni per l'installazione e il funzionamento

Cabletron Systems

Cabletron Systems SmartSwitch 6E122 Manuale del proprietario

Cabletron Systems

Cabletron Systems SmartStack STS-8SU Manuale utente

Cabletron Systems

Cabletron Systems SmartSwitch 6500 Manuale utente

Cabletron Systems

Cabletron Systems bridges Manuale utente

Cabletron Systems

Cabletron Systems Cabletron CyberSWITCH CSX5500 Manuale di istruzioni

Cabletron Systems

Cabletron Systems SmartSTACK ELS100-S24TX2M Manuale utente

Cabletron Systems

Cabletron Systems SmartSwitch 6500 Istruzioni per il montaggio

Cabletron Systems

Cabletron Systems SmartCell ZX-250 Manuale utente

Cabletron Systems

Cabletron Systems 9E106-06 Manuale utente

Cabletron Systems

Cabletron Systems SmartSTACK ELS100-24TXG Manuale di istruzioni

Cabletron Systems

Cabletron Systems SmartSwitch 9000 Documento tecnico

Cabletron Systems

Cabletron Systems SMALL OFFICE CyberSwitch 150 Manuale utente

Cabletron Systems

Cabletron Systems 924TX Istruzioni operative e di manutenzione

Cabletron Systems

Cabletron Systems Ethernet Hubs Manuale utente

Cabletron Systems

Cabletron Systems MMAC-Plus 9E312-12 Documento tecnico

Cabletron Systems

Cabletron Systems SmartSwitch 9A100 Manuale utente

Cabletron Systems

Cabletron Systems CyberSWITCH CSX1200 Manuale utente

Cabletron Systems

Cabletron Systems MRXI 10BASE-T Manuale utente

Cabletron Systems

Cabletron Systems SmartSTACK 100 Manuale utente

Manuali Interruttore popolari di altre marche

URC

URC Total Control MFS-8 Manuale utente

Azbil

Azbil HPQ-D11 Manuale utente

Sony

Sony DFS-900M Manuale utente

SICK

SICK i17S Manuale utente

F&F

F&F SZR-277 Manuale utente

Shure

Shure UAMS/BK Manuale utente

Dräger

Dräger X-zone Switch Off Manuale utente

Asco

Asco Joucomatic 349 Series Manuale utente

BT Mini Hub Manuale utente

D-Link

D-Link DES-1226G Manuale utente

Johnson Controls

Johnson Controls FS80-C Manuale utente

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuale utente

MicroNet

MicroNet SP1200A Manuale utente

Ruijie

Ruijie RG-PF2920 Series Manuale di installazione e funzionamento

Altinex

Altinex DA1914SX Manuale utente

MiLAN

MiLAN MIL-SM2401M Manuale utente

RJM

RJM MASTERMIND PBC/6X Manuale utente

Atlas

Atlas MMK-KVM8 Manuale utente