Caple CE1122SS Manuale utente

Contact Caple on 0117 938 7420 or for spare parts www.caple.co.uk

ceiling extractor

instruction manual

CE1122SS / CE1122WH

CE1122SS/WH_Instruction manual.indd 1 22/03/2018 10:53

Instruction manual CE1122

Please keep this instruction manual for future reference

CONTENTS

WARNINGS 3

ENVIRONMENTAL PROTECTION 7

INSTALLATION 8

FREESTANDING INSTALLATION 9

BUILT-IN INSTALLATION 11

REMOTE CONTROL 17

TIMING 20

MAINTENANCE 21

CE1122SS/WH_Instruction manual.indd 2 22/03/2018 10:53

Instruction manual CE1122

Please keep this instruction manual for future reference

WARNINGS

-This appliance is not intended to be used by young

children or inﬁrm persons without supervision. Young

children should be supervised to ensure they do not play

with the appliance.

-The air extracted cannot be conveyed through or into a

duct used to let out fumes from appliances fed by energy

other than electric power (eg. central heating, radiators,

water heaters, etc.). To evacuate the air outlet, please

comply with the pertaining rules given by competent

authorities.

-Provide the room with adequate ventilation when a

cooker hood and appliances fed by energy other than

electric power (gas, oil, or coal stoves, etc.) are used

simultaneously.

-The cooker hood, when evacuating the extracted air,

could generate a negative pressure in the room which

must not exceed the limit of 0.04mbar, in order to avoid

the suction of exhausts deriving from the heating source.

Therefore the room should be provided with air intakes

to allow a constant ﬂow of fresh air.

-If the rating label in the cooker hood shows the symbol

, the appliance is built in class II° and it does not

need any earth connection.If the rating label in the

cooker hood does not show the symbol , the appliance

is built in class I° and it needs the earth connection

CE1122SS/WH_Instruction manual.indd 3 22/03/2018 10:53

Instruction manual CE1122

Please keep this instruction manual for future reference

-When performing the electrical connections on the

appliance, please make sure that the current tap is

provided with earth connection and that voltage values

correspond to those indicated on the rating label placed

inside the appliance itself.

-Before carrying out any cleaning or maintaining

operations, the appliance needs to be removed from the

electric grid.

-If the appliance is not provided with a non-separable

ﬂexible cable and plug, or with another device ensuring

unipolar disconnections from the grid, with an opening

distance between the contacts of at least 3 mm, then

such disconnecting devices must be supplied within the

ﬁxed installation.

-If the appliance is ﬁtted with a supply cord and a plug,

the appliance has to be put in a place where the plug

can be reached easily.

-The use of materials which can burst into ﬂames should

be avoided in close proximity of the appliance.

-When frying, please pay particular attention to ﬁre risk

due to oil grease. Being highly inﬂammable, fried oil is

especially dangerous.

-Do not use uncovered electric grills. In order to avoid

possible ﬁre risk, all instructions for grease ﬁlter cleaning

and grease deposits removal should be strictly followed.

CE1122SS/WH_Instruction manual.indd 4 22/03/2018 10:53

Instruction manual CE1122

Please keep this instruction manual for future reference

-This appliance complies with all relevant local and

national safety requirements. Inappropriate use can,

however, lead to personal injury and damage to property.

-The cooker hood is not intended for outdoor use.

-It must only be used as a domestic appliance to extract

vapours and remove odours from cooking. Any other

usage is not supported by the manufacturer and could

be dangerous.

-Where a recirculation cooker hood is ﬁtted above a gas

hob, please ensure that there is an adequate supply of

fresh air into the room in which it is installed. Please

seek the advice of a qualiﬁed gas ﬁtter (e.g. GasSafe in

the UK) if necessary.

-Children under 8 years of age must be kept away from

the cooker hood unless they are constantly supervised.

-Children 8 years and older may only use the cooker hood

unsupervised if they have been shown how to use it

safely and recognise and understand the consequences

of incorrect operation.

-The electrical safety of this appliance can only be

guaranteed when correctly earthed. It is essential

that this standard safety requirement is met. If in any

doubt please have the electrical installation tested by a

qualiﬁed electrician.

CE1122SS/WH_Instruction manual.indd 5 22/03/2018 10:53

Instruction manual CE1122

Please keep this instruction manual for future reference

-Do not connect the appliance to the mains electricity

supply by a multi-socket unit or an extension lead. These

are a ﬁre hazard and do not guarantee the required

safety of the appliance.

-The cooker hood can get very hot during cooking due to

heat rising from the hob.

-Do not touch the housing or the grease ﬁlters until the

cooker hood has cooled down.

CE1122SS/WH_Instruction manual.indd 6 22/03/2018 10:53

Instruction manual CE1122

Please keep this instruction manual for future reference

ENVIRONMENTAL PROTECTION

Waste electrical products should not be disposed of with household waste. Please

recycle where facilities exist. Check with your Local Authority or retailer for recycling

advice. This appliance is marked according to the European directive 2012/19/EU on

Waste Electrical and Electronic Equipment (WEEE).

By ensuring this product is disposed of correctly, you will help prevent potential

negative consequences for the environment and human health, which could

otherwise be caused by inappropriate waste handling of this product. The symbol

on the product indicates that this product may not be treated as household waste.

Instead it shall be handed over to the applicable collection point for the recycling of

electrical and electronic equipment. Disposal must be carried out in accordance with

local environmental regulations for waste disposal.

For more detailed information about treatment, recovery and recycling of this

product, please contact your local council, your household waste disposal service or

the retailer where you purchased the product

CE DECLARATIONS OF CONFORMITY

Radio Equipment Directive (RED) 2014/53/EU

This Declaration is issued under the sole responsibility of the manufacturer.

Hereby, Caple declares that the radio equipment included in the product is in

compliance with the RED directive 2014/53/EU.

The full text of the EU Declaration of Conformity is available on our website

www.caple.co.uk.

CE1122SS/WH_Instruction manual.indd 7 22/03/2018 10:53

Instruction manual CE1122

Please keep this instruction manual for future reference

INSTALLATION

NOTE: Two people are needed for the installation of this product.

It is possible to open the glass/steel panels, which cover the grease ﬁlters, by slightly

pulling the panel on a side, as shown on ﬁg.1 In order to allow the hood to perform

correctly, it is recommended to install the appliance at a distance of 2000 - 2100

mm from the ﬂoor. Before starting the appliance installation, please check that

all components are not damaged, in such a case contact your retailer and do not

carry out the installation. Furthermore, please read carefully all of the following

installation instructions.

- For the best performance we recommend an exhausting pipe with a maximum

length not exceeding 5 meters.

- Limit the number of elbows in the piping, since each elbow reduces the air

capacity of 1 linear meter. (Eg. if you use 2 x 90° elbows, the length of piping

should not exceed 3 meters).

- Avoid abrupt direction changes.

- Use a 150 mm constant diameter pipe for the whole length.

- Use ducting approved by the local standards inforce.

NOTE: For more information on venting, please see our ‘Extraction & Ventilation

guide’ available on our website www.caple.co.uk.

CE1122SS/WH_Instruction manual.indd 8 22/03/2018 10:53

Instruction manual CE1122

Please keep this instruction manual for future reference

FREESTANDING INSTALLATION

Recirculating version

The product is ready for this version.

Attention:

Let the power cord pass through the hood hole, as shown in ﬁg. 2.

Mark the holes to ﬁx the product to the false ceiling.

Having marked the holes, make them by using a drill bit (diameter 8mm), and place

in the holes the metric ﬁxing plugs provided.

Open the glass panels, following the instructions mentioned in the previous section

and remove the grease ﬁlters and carbon ﬁlters.

When ﬁxing the hood to the ceiling allow the electric cable to pass through into the

hood (not supplied). Fix the hood to the ceiling using the four screws provided.

Make the electrical connection in to the metal box (ﬁg.18). The power supply metal

box is postioned close to the electrical componets and you can see them after

removing the grease ﬁlters.

Please connect the cable as shown in ﬁg. 18. Once done reﬁt the carbon ﬁlters and

grease ﬁlters, the close the glass panels.

CE1122SS/WH_Instruction manual.indd 9 22/03/2018 10:53

Instruction manual CE1122

Please keep this instruction manual for future reference

Ducted version

Turn the motor to evacuate the air from the upper side of the hood. Open the glass

panels, and remove grease ﬁlters and carbon ﬁlters.

Remove the four screws shown in picture 4. Remove the lower stainless steel as

shown in picture 5. Then remove the screws holding the motor, as shown in picture

6. Open the hole in the middle of the upper side hood (ﬁg 7.) Fix the plug to the

hole where there was the motor before, using the four screws provided. (ﬁg 9)

Install the motor in the upper side by means of the four screws earlier removed

(picture 10). Prearrange an asir outlet exactly in the middle of the hood. Continue

with the installation as Recirculating version (Free standing).

The use of carbon ﬁlters is not necessary in this case.

Installtion of the air outlet with a joint diameter of 200mm.

Connect the internal motor or the external motor’s cable to the terminal board

found inside the plastic box of the wiring. Make sure to respect the colors of cables

when performing the electrical connection (ﬁg.2.1)

Make the opening for the air outlet diameter of 200mm on the upper side of the

product (the opening is already marked on the body of the unit).

Install the joint with a diameter of 200mm supplied with the external motor and ﬁx

it with the 8 screws supplied.

The 200mm diameter joint is moved slightly from the longitudinal axis of the

product by 25mm.

CE1122SS/WH_Instruction manual.indd 10 22/03/2018 10:53

Altri manuali per CE1122SS

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Caple Cappa di ventilazione

Manuali Cappa di ventilazione popolari di altre marche

emmeti

emmeti RECUPA MED A-140 Guida

Nibe

Nibe F135 Manuale utente

Kuppersberg

Kuppersberg INTRO 60 Istruzioni di installazione e manutenzione

Zephyr

Zephyr Spruce AK9834BS Guida all'installazione

Hisense

Hisense MH6INBG Manuale utente

Miele

Miele DA 1255 Manuale utente

Broan

Broan 46000 Manuale utente

GE Profile PV977 Istruzioni originali

FALMEC

FALMEC FFRIA24W5FS Manuale utente

Whirlpool

Whirlpool RH2600XL-1 SERIES Manuale utente

Küppersbusch

Küppersbusch DX ISLA Manuale utente

ETNA

ETNA AV360RVS Manuale utente

JUNO

JUNO JDF603E6 Manuale utente

Miele

Miele DA 6708 D Manuale utente

Tricity Bendix

Tricity Bendix LE 150 Manuale

AEG

AEG X68163BV1 Manuale utente

AEG

AEG 125 D Manuale utente

Smeg

Smeg KSEV97X Manuale utente