Carmanah Go Power! GP-TS Manuale utente
Go Power! Owner’s Manual
GP-TS Transfer Switch
1
Carmanah Technologies Corp. © 2011
Last revised: August 2011
1.0 Warnings
Avoid All Electrical Hazards. Disconnect batteries and electrical system from 120/240 VAC, or any
other power source of electrical power, before attempting to install your Go Power! GP-TS Kit.
Observe proper polarity throughout the GP-TS Kit installation.
Work Safely. Do not wear jewelry when working with electrical or mechanical equipment. Use protective
eyewear, gloves and apron when working with batteries or power tools. Use extreme caution when on
ladders or a roof.
Follow the Safety Precautions of the battery manufacturer. Do not produce sparks when working in
locations where flammable gases or vapours exist. Shield skin and eyes from battery acid. If skin, eyes or
clothing comes in contact with acid rinse thoroughly with water.
*Avoid electrical shock. Make sure all sources (inverter, shore power, generator) are disconnected.
2.0 Installation Overview
The TS-30 is a two-pole 30 Amp AC Switch that automatically connects shore power (when available) to
your vehicle load center (breaker panel). If you unplug from shore power, it then connects your inverter
output to power your circuits. The GP-TS includes a cable with built-in plug to connect the inverter output,
and a receptacle that powers your converter only when shore power is available.
Congratulations on becoming the owner of a GP–TS Kit. Please read and understand all instructions
before installing your new product for the easiest and safest installation. Before installing the kit, review
the installation design with this DC Kit Installation Manual. Contact your Authorized GP Dealer if in doubt
as to this kit's suitability or compatibility with your system. Retain this guide for future reference.
2.1
Disclaimer of Liability & Warranty
The conditions or methods of installation, operation, use and maintenance of this kit are beyond the
control of Go Power! and Go Power! does not assume responsibility and expressly disclaims liability for
loss, damage, or expense arising from, or in any way connected with such installation, operation, use, or
maintenance. Go Power! Inc does not cover labour or shipping for items returned.
Owner’s Manual | Go Power! – Transfer Switch Kit
2
Carmanah Technologies Corp. © 2011
Last revised: August 2011
3.0 Installation
1. Ensure the shore power plug is not connected to shore power and batteries are disconnected.
2. Connect the RV shore power cord to Go Power! Transfer Switch input: wires are labeled “Shore Hot”
and “Shore Neutral”. Connect ground wire to provided ground bonding block.
3. Connect transfer switch output to AC power panel. (Use terminals labeled “AC Panel”).
4. Plug supplied inverter power cord into inverter. (With inverter power switch “off” or disconnect inverter
from the battery.)
5. Plug Go Power! Battery Charger into transfer switch female outlet and connect to batteries. (When
using a stock converter charger, remove the AC connections from the breaker panel and add a male
plug to connect with the transfer switch female outlet.)
6. Disable converter when using a stand-alone charger.
3.1
Installation Diagram
AC Panel
Converter
Go Power! Battery Charger
or
Stock converter charger Go Power! Inverter
Go Power!
Transfer Switch
Disconnect Shore
Power
To Batteries
Owner’s Manual | Go Power! – Transfer Switch Kit
3
Carmanah Technologies Corp. © 2011
Last revised: August 2011
Document number: MOBI_MAN_GP-TS_2011_vC
50750
© 2011, Carmanah Technologies Corp.
Phone: 1.877.312.4547
www.solidsignal.com
Indice
Altri manuali Carmanah Interruttore
